Resumo do conteúdo contido na página número 1
Electric
Fireplace
Model
HE32EF
Installation Instructions & Homeowner's Manual
WARNING! IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY,
AN ELECTRICAL SHOCK OR FIRE MAY RESULT CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF LIFE.
FOR YOUR SAFETY
DO NOT STORE OR USE GASOLINE OR OTHER
FLAMMABLE VAPOURS OR LIQUIDS IN THE VICINITY
OF THIS OR ANY OTHER APPLIANCE.
C US
™
The Vermont Castings
Majestic Products Company
410 Admiral Blvd. • Mississauga, Ontario • Canada L5T 2N6
www
Resumo do conteúdo contido na página número 2
TABLE OF CONTENTS Please read the Installation & Operating Instructions before using this appliance. Thank you and congratulations on your purchase of a Vermont Castings Majestic Products Company fireplace. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and/or injury and will void the warranty. Installation Instructions ...............................................
Resumo do conteúdo contido na página número 3
INSTALLATION INSTRUCTIONS GENERAL 1 . Read all instructions before using this appliance. 15. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, 2. This appliance is hot when in use. To avoid burns, do like a bed, where openings may become blocked. not let bare skin touch hot surfaces. If provided, use handles when moving this appliance. Keep combus- 16.This appliance has hot and arcing or sparking parts tible materials, such as furnitu
Resumo do conteúdo contido na página número 4
FIREPLACE DIMENSIONS B F D A E G H C MINIMUM FIREPLACE OPENING T Q U S R R - Fireplace opening width Q - Fireplace opening height HE32EF S - Firebox width at depth(T) T - Firebox depth at back height (U) 5/8" A1 26 676 mm U - Height at depth 3/8" B1 38 975 mm A2 29" 737 mm T 15/16" 1= SS or SSD Trim B2 41 1065 mm R I 2= SL or SLD Trim A3 33" 838 mm M 3= SXL Trim B3 44" 1118 mm 4= BSL Trim A4 28" 712 mm 5= BXL Trim 7/8" B4 40 1041 mm 1/2" A5 30 775 mm B5 46" 1171 mm 3/4" F C 28 730 mm I 3/4" D 18
Resumo do conteúdo contido na página número 5
MANTELS FRAMING & FINISHING When the fireplace is being installed into a woodburning Before deciding on the frame dimensions and finishing fireplace the minimum the mantel can be above the fire- materials it is important to consider the finished dimensions place is governed by local building codes applicable to of the chosen fireplace trim kit (see options section of this woodburning fireplaces. Consult local authorities having manual). jurisdiction for these clearances. The underside of the ma
Resumo do conteúdo contido na página número 6
INSTALLATION OF LOGS ELECTRICAL CONNECTION 1. Turn off power to the unit. A 15 AMP, 120 Volt, 60 Hz circuit with a properly grounded outlet is required. Preferably, the fireplace will be on a 2. Remove front glass (See "Glass Removal" section). dedicated circuit as other appliances on the same circuit 3. The log bottom is shipped in place. No adjustment is may cause the circuit breaker to trip or the fuse to blow necessary. when the heater is in operation. The unit comes standard with a 6 ft.
Resumo do conteúdo contido na página número 7
SERVICE INSTRUCTIONS Disconnect power before attempting any maintenance or cleaning to reduce the risk GLASS INFORMATION of fire, electrical shock or personal injury. 1. Under no circumstances should this product be operated with missing or broken glass. LOUVRE REMOVAL 2. Do not strike or slam the glass. 3. Do not use abrasive cleaners to clean the glass. To remove top louvre pull louvre up and then lift out. 4. This product uses tempered glass. Replacement of See Figure 5. the glass with gaske
Resumo do conteúdo contido na página número 8
CLEANING BRASS TRIM MAINTENANCE OF MOTORS The motors used on the fan and the drum assembly are Clean the brass trim using a soft cloth, slightly dampened prelubricated for extended bearing life and require no with lemon oil and buff with a clean soft cloth. Do NOT use further lubrication. However, periodic cleaning/vacuuming brass polish or household cleaners as these products will of the fan/heater is recommended. damage the brass trim. Lemon oil can be obtained at supermarkets or hardware s
Resumo do conteúdo contido na página número 9
OPERATING INSTRUCTIONS The control compartment is located behind the lower louvre 2. HEATER CONTROL panel. To access the controls, simply flip down the lower louvre panel. To locate the position of each control de- scribed below, refer to Fig. 7. The Heater Control acts to turn the heater on and off as well as setting the comfort level in the room. Turning the knob clockwise from the off position will place the heater into 1. MAIN ON/OFF SWITCH operation. The further the knob is rotated
Resumo do conteúdo contido na página número 10
REPLACEMENT PARTS - ELECTRIC FIREPLACE 18 8 15 7 4 / 5 9 6 13 14 20 2 21 23 216mm [8 1/2"] (DISTANCE BETWEEN TWO SOCKETS) 216mm [8 1/2"] (DISTANCE BETWEEN TWO SOCKETS} 305mm [12"] #1 COMPLETE LOG SET 19 22 3 17 HE32EF #2 COMPLETE LOG SET - 10 -
Resumo do conteúdo contido na página número 11
REPLACEMENT PARTS LIST - ELECTRIC FIREPLACE DESCRIPTION HE32EF 1. Log Set Complete 10003628 1a. Log Top Left N/A 1b. Log Top Right N/A 1c. Log Bottom N/A 2. Fan/Heater Assembly w/Bracket 10001815 3. Motor 12VDC (Flame generator) 10001978 4. Switch Rocker 53606 5. On/Off Switch (Illuminated) 10001393 6. Thermostat - Heater Control 10001971 7. Potentiometer - Flame Speed Control 10001168 8. Circuit Board - Flame Speed Control 10001589 9. Knob - Flame Speed, Heater Controls 10001639 10. Light Filte
Resumo do conteúdo contido na página número 12
FAN HEATER INSTALLATION INSTALLATION WARNING: UNPLUG OR TURN THE POWER TO THE APPLIANCE OFF PRIOR TO BEGIN- NING THE INSTALLATION. IT IS NOT ACCEPTABLE TO USE THE “ON/OFF” SWITCH TO MEET THIS REQUIREMENT. 1. Turn the power to the appliance off, or unplug it from the power supply. 2. Let fireplace cool if it has been operating. 3. Remove access panel radiance by lifting up and pulling out or open lower louvre assembly. 4. Remove two door retention screws along lower sides edge of door frame. 5. S
Resumo do conteúdo contido na página número 13
TRIM OPTIONS FOR HE32EF 1) RHESS, RHESL, RHESSD, RHESLD & RHESXL TRIMS FRAME ASSEMBLY RHESS, RHESL, RHESSD, RHESLD and RHESXL 1. Lay Trim Top Facing and Trim Side Facings, face down Trim Top Deflector on to an even surface such as a table or floor. Be sure not to scratch the painted surfaces. 2. Install the nuts and bolts (Fig. 8). Trim Frame Top Section Side View 10/24 Fig. 10 SCREWS RHESSD and RHESLD (Fig. 11) FRAME TOP 1. Install trim channels (left and right sides). Use two screws to assemb
Resumo do conteúdo contido na página número 14
FRAME MOUNTING GENERAL INFORMATION The Decorative Front Frame should be installed last after all other work, has been completed and thoroughly checked and tested for operation and proper installation requirements. 1. Fit Decorative Frame to the fireplace and fasten (Fig. 12) SCREWS AS SHOWN FROM FRONT Fig. 12 Plastic on the trim must be removed before mounting onto the fireplace. Glass must be tightly pressed against the front of the frame in order to prevent screws from damaging glass edge
Resumo do conteúdo contido na página número 15
TRIM REPLACEMENT PARTS LIST ALL repair parts will be available from your local dealer. When ordering, always give the following information: Model and serial number, part description with finish and part number; (2) (3) (3) (3) (4) KEY DESCRIPTION RHESS RHESL RHESSD RHESLD RHESXL 1 Trim Frame Top, Flat Black 57929 57932 57929 57932 57935 2 Trim Frame Left, Flat Black 57927 57930 57927 57930 57933 3 Trim Frame Right, Flat Black 57928 57931 57928 57931 57934 (1) 4 Trim Top Deflector 17634 17634 17
Resumo do conteúdo contido na página número 16
2) RHEBSL & RHEBXL TRIMS RHEBXL TRIM ASSEMBLY To install the kit you do not have to remove any piece RHEBSL of brass, you just add the external pieces. 1. Install trim channels (left and right sides). Use two Remove the frame trim from the unit if it is already screws to assemble each piece. installed. 2. Slide on the trim top channel and fasten it from the back side. 1. Install trim channels (left and right sides)by removing 3. Install the trim top deflector and use two screws to the two screws
Resumo do conteúdo contido na página número 17
3) RHEFA and RHEFP TRIMS TRIM ASSEMBLY 3. Install bottom decorative plate by simply sliding it under the unit floor. No fastening is required for 1. Remove the front glass (see "Glass Frame Re- this installation (See Fig. 16). Be sure to remove moval" section). protective cover. 2. Install support window trim channel, top and bottom 4. Install the bottom louvre assembly by fastening brass trim by using the shortest black screw. (Fig. the hinges with four screws to the pre-punched 14 & 15). ho
Resumo do conteúdo contido na página número 18
4) HEBTKP, HESBTKP, HECBTK, HECBTKMB & HEBTA TRIMS HECBTK - Cast bay window and grills in classic black trim kit HECBKMB - Cast bay window and grills in midnight black porcelain enamel trim kit HESBTKP - Steel bay window with polished brass and cast grills in classic black trim kit HEBTKP - Steel bay window and bay louvres with polished brass trim kit Install the bay window after all other installation work has been completed, thoroughly checked, and tested for operation, leaks and proper insta
Resumo do conteúdo contido na página número 19
HEBTKP Trim Assembly 1) Install the hanging brackets, as per Fig. 20 2) Install bracket on each side of the cabinet as per Fig. 24. 3) Install the two ceramic pieces inside the bay window, as per Fig. 19. 4) Install the bay window by hanging it onto the lower tabs of the hanging brackets, as per Fig. 21. 5) Install top louvre by engaging the obround holes with the upper tabs of the hanging brackets, as per Fig. 22. 6) Install brass trim to the steel frame as per Fig. 23. Fig. 21 Hang the Wi
Resumo do conteúdo contido na página número 20
TRIM REPLACEMENT PARTS LIST ALL repair parts will be available from your local dealer. When ordering, always give the following information: Model and serial number, part description with finish and part number; HECBTK & HECBTKMB HESBTKP HEBTKP 1 3 3 11 8 10 9 9 10 6 9 10 6 8 8 4 5 5 5 7 2 7 12 13 KEY DESCRIPTION HECBTK HECBTKMB HESBTKP HEBTKP HEBTA (1) 1 Trim Window Top/Bottom - - 55188-PB 55188-PB 55188-AB 2 Plate Decorative Bottom - - - 52828-PB 52828-AB 3 Top Louvre (Grill) Assembly 1301199
