Resumo do conteúdo contido na página número 1
INSTALLATION AND OPERATION MANUAL
EPA Certified
Wood-Burning
Fireplace Insert
Save These Instructions
For Future Reference
P/N 775,213M, Rev. B, 02/2010
Wood Fireplace Insert
Model Canyon™ C310
A French manual is available upon request. Order P/N 775,213CF.
Ce manuel d’installation est disponible en francais, simplement en faire la demande. Numéro de la
pièce 775,213CF.
These appliances must be properly installed and operated in order to prevent the
possibility of a house fire. Please read t
Resumo do conteúdo contido na página número 2
Positive Flue Connection .............................................................. 10 CONGRATULATIONS! Insert Pre-Installation Preparation ............................................... 11 When you purchased your new wood-burning fireplace insert, Chimney Liner Installation ........................................................... 11 you joined the ranks of thousands of individuals whose answer Installing the Insert ......................................................................
Resumo do conteúdo contido na página número 3
13. Inspect your chimney at least once a month during the burn- IMPORTANT SAFETY AND WARNIING ing season to check for soot and creosote accumulations. Any accumulations over 1/4” thick should be removed by a INFORMATION professional chimney sweep. Do not attempt to burn out heavy creosote accumulations with a hot fire. If large accumulations READ THIS MANUAL IN ITS ENTIRETY AND UNDER- are occurring, review your burning procedures. STAND THESE RULES TO FOLLOW FOR SAFETY. 14. If a creosote fi
Resumo do conteúdo contido na página número 4
read greater than .0’ W.C. (inches water column) and less than .08” TESTING INFORMATION W.C. As per NFPA-211 standard (see paragraph below), the installer must take into account all variables within the installation and install the appliance in such a manner that satisfies the draft requirements of the This manual describes the installation and operation of the Canyon™ C310 appliance. See Chimney Guidelines below to assist you in selecting the non-catalytic wood heaters. These heaters
Resumo do conteúdo contido na página número 5
Dry, seasoned wood is that which has been cut, split and allowed to dry NEGATIVE PRESSURE WARNING under a covered area where air is free to flow and circulate under and around the wood (not under a tarp or plastic). Make sure wood is not This appliance is not designed to be operated in a negative pressure. stacked directly on the ground, it may absorb moisture from the ground. In very airtight homes with large kitchen exhaust fans, furnace cold air It should be allowed to dry in these cond
Resumo do conteúdo contido na página número 6
BRICK INSTALLATION Firebox Brick Layout Canyon ™ C310 26 27 30 29 28 B B B B CAUTION: Wear gloves during brick installation in case of sharp M 32 33 A* A* edges behind the stove. 31 3 4 5 34 1 2 10 Note: Installation of the baffle boards and baffle blankets are easier when A 6 F A F F F F F F you can still access the flue outlet, (before connecting the flue vent). Be * * 7 11 sure the baffle blankets are placed flat on the baffle boards so as not F F to block exhaust flow t
Resumo do conteúdo contido na página número 7
Maximum Mantel Depth = 9” (9mm) REqUIRED CLEARANCES COMBUSTIBLE MANTEL WARNING: BE ABSOLUTELY SURE THE DISTANCE BETWEEN THE Top Facing / Trim HEATER AND THE SURFACE OF ANY COMBUSTIBLE CONSTRUC- TION IS NOT LESS THAN SHOWN ON THIS PAGE. A B Model *A *B *C *D E(1) 0” 1” 8” C10 USA-30” USA -20” 200mm CAN-787mm CAN-584mm 508mm 381mm D C10 with ” 1” 0” 8” 8” 559mm 305mm 508mm 200mm 200mm mantel Insert C and/or side shields Hearth Protection E (Canada) E (USA) Model F (1) G H J() M
Resumo do conteúdo contido na página número 8
Using the r formula: HEARTH PROTECTION Minimum r-value (per Inch) Specified min. thickness of = of listed material x thickness The hearth and/or floor protection must be a thermally rated non-com- alternate r-value (per inch) of listed bustible hearth/floor protector meeting or exceeding a thermal rating of material of alternate material material k=.84 or equivalent with a listed thickness of 3/4" (19mm) minimum in USA and Canada. The covering must extend 24” (610mm)
Resumo do conteúdo contido na página número 9
1. READ ENTIRE INSTALLATION INSTRUCTIONS. CHIMNEY REqUIREMENTS 2. Check all REqUIRED CLEARANCES as specified in the previous section (Page 7 ) of this installation instruction booklet. The Canyon™ C310 inserts are approved for use in masonry fireplaces built to UBC Chapter 37 or equivalent with a minimum 30-1/2” (775) 3. Wear gloves during installation in case of sharp edges on the stove width opening at the front of the fireplace. and it’s parts. The Canyon™ C310 inserts may be installed us
Resumo do conteúdo contido na página número 10
POSITIVE FLUE CONNECTION A full chimney liner is recommended A positive flue connection is providing a seal between the vent pipe or Fireplace liner and the existing fireplace chimney for the purpose of preventing Chimney room air passage to the chimney cavity of the fireplace. There are differ- ent approved methods to achieve this. See Direct Connect Positive Flue Connection on this page. Must extend starter section past the damper When creating a positive flue connection, a positive flu
Resumo do conteúdo contido na página número 11
If additional support is necessary, factory punched holes in the front INSERT PRE-INSTALLATION PREPARATION corners of the bottom air chamber will accept leveling legs. Carefully measure the distance from the hearth protection to the bottom of the Install the two 3” (76 mm) long bolts (with the head up) through the stove. Use 3/8” diameter bolts that are 1/2” (13 mm) longer that the nuts attached to the insert on the lower rear corner of each side. This will distance just measured. Thread a
Resumo do conteúdo contido na página número 12
OPERATING HINTS STARTING AND MAINTAINING A FIRE Be sure to clean the Nickel or Gold Plated door with a household 1. Burn only dry, well-seasoned wood for maximum heat output. In some states it is illegal to burn wet wood or anything other than clean, dry type glass cleaner and a very soft cloth to remove any fingerprints wood products. and residues prior to the first fire. . Your fireplace insert is designed to operate with the door closed! 1. NEVER USE FLAMMABLE LIqUIDS TO START OR REKIN
Resumo do conteúdo contido na página número 13
BLOWER OPERATION Blower Operation The blower can be operated manually or automatically (blower will turn on when the insert is hot and turn off when the insert is cool). The rocker switch on the control panel allows you to select between manual operation or automatic operation as follows (see Figure 10 ): MANUAL OPERATION: Turn rocker switch to the manual position (up) and adjust rheostat knob to the desired speed. The blower will have to Blower Speed Control Manual / Auto be manually tur
Resumo do conteúdo contido na página número 14
OPERATING TECHNIqUES AND HINTS ACHIEVING CLEAN, LONG BURNS Recent developments in wood-burning technology have made wood-burn- To achieve long burn times, after having thoroughly preheated the ing a cleaner and more convenient way to heat your home. Overall efficiency stove, let the stovetop cool down to 7 to 00 degrees (on Elites, in a wood-burning appliance is a combination of combustion efficiency locate thermometer on the face of the insert just above the door). Now load the firebox an
Resumo do conteúdo contido na página número 15
MAINTENANCE CLEAN GLASS SEE MAINTENANCE ON FOR GLASS CLEANING TIPS DOOR HINGES: If door hinges need lubricating, use an anti-seize compound (never use oil) available from your Lennox Hearth Products dealer. The operator plays an important part in keeping the glass clean and free of build-ups. The first and most important part the operator plays is mak- DOOR LATCH: If your door latch fails to latch tightly and the gasket is ing sure to burn only well-seasoned firewood. Wet wood = Dirty gla
Resumo do conteúdo contido na página número 16
TROUBLESHOOTING Problem Solution POOR DRAFT: Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys nor- mally have poor drafts. Remember, the stoves’ draft depend solely on the natural draft of the chimney (See Drafting section on Page 4). If your stove is not drafting properly, your chimney is the problem. All stoves are thoroughly tested to ensure proper draft with the correct size chimney flue. EXCESSIVE DRAFT: With better chimneys being more c
Resumo do conteúdo contido na página número 17
DO’S AND DON’T DO NOT: Install or operate this stove before reading this manual. DO NOT: Close the draft beyond the point at which the flames are completely extinguished. DO NOT: Open the stove door without fully opening the draft first. DO NOT: Burn driftwood or wood that has been in salt water. This includes some mill ends and scrap lumber that has been floated in salt water on the way to the mill. (This will void your warranty). DO NOT: Handle the Nickel or Gold faceplate unnecessarily.
Resumo do conteúdo contido na página número 18
C10 INSER T PARTS REPLACEMENT PARTS - MODEL C 10 7119 Large Flange Screw/ Black - Seven Needed Contact an Authorized Lennox Hearth Products dealer to obtain H9 Large Flange Screw/ Gold - Seven Needed any of these parts. Never use substitute materials. Use of H9 Large Flange Screw/ Nickel - Seven Needed non-approved parts can result in poor performance and safety H8079 Nameplate Kit w/ Hardware - Silver hazards. H8080 Nameplate Kit w/ Hardware - Gold H0 Draft Rod Knob
Resumo do conteúdo contido na página número 19
REPLACEMENT PARTS - MODEL C 10 33 34 48 47 36 36 46 37 35 37 39 39 40 45 39 39 40 38 38 40 38 38 38 38 38 41 38 38 38 40 38 38 38 42 38 38 44 38 42 43 41 38 38 43 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 19
Resumo do conteúdo contido na página número 20
REPLACEMENT PARTS - MODEL C 10 Door Parts 1 2 3 11 8 4 4 5 9 6 7 10 Blower Parts 29 15 17 16 19 32 18 0 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
