Manual do usuário Desa Wall Mantel and Base with Trim W32KPA

Resumo do conteúdo contido na página número 1

W32KCSA and W32KPA
Wall Mantel and Base with Trim
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Important: Read entire instruction sheet before
Tools required:
1
assembling or installing mantel kit.
• #2 Phillips screw driver (3 ⁄ " minimum length)
2
• Slotted screw driver
These mantels are only approved for use with any
• Measuring tape
DESA Heating Products 32" electric fireplace sys -
• Pencil
tem or firebox. Do not use mantel with any other
• Drill Driver
product.
If any wood pieces are missi

Resumo do conteúdo contido na página número 2

AsseMblING MANTel Right Leg Assembly IMPORTANT: More than one person is required to lift assembled mantel. l ift mantel by leg assemblies. l ifting by header or mantel top could damage mantel. Header 1. Some models require side/corner assembly. For these models, lay leg side on floor . Position leg as shown in Figure 1. Align bottom and attach with screws provided. Repeat for other side. 2. Each leg assembly will use 3 brackets for stability. Your bracket hardware kit will contai

Resumo do conteúdo contido na página número 3

5. Place the bottom panel on top assembly as shown in Figure 9. You may want to turn the entire assembly over for better access to pocket holes. Center the bottom panel Bottom Panel of Mantel left to right and make sure back is flush with back of side Top Assembly panels. Attach bottom to top assembly and middle support 1 using (14) 1 / " screws (see Figure 9). 4 6. Attach supplemental brackets using 1/2" - 3/4" screws provided in bracket hardware pack. Use 2 brackets to att

Resumo do conteúdo contido na página número 4

AsseMblING MeTAl TRIM 1. Remove packaging from three pieces of metal trim. 2. Locate two adjusting plates with set screws, and two shims in the hardware packet. 3. Align shim under adjusting plate as shown in Figure 11. 4. Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 11). 5. Slide other end of adjusting plate/shim in slot on mitered Screw edge of side trim (see Figure 11). 6. W h i l e fi r m l y h o l d i n g e d g e s o f t r i m t o

Resumo do conteúdo contido na página número 5

6. Fireplace with louver door: Lower bottom louver door. Installing Fireplace without Flange Use two screws provided in hardware package and attach 1. Place mantel assembly on wood base and center left to fireplace to wooden base (see Figure 14). Close louver right having back of assembly flush with back of base. door 1 2. Attach mantel to base using 1 /4" screws through pocket Fireplace with fixed louver: Before installing logs or holes. Using brackets and 1/2" or 3/4" screws fro

Resumo do conteúdo contido na página número 6

2701 Industrial Drive P.O. Box 90004 Bowling Green, KY 42102-9004 Technical Service and Parts: 1-866-672-6040 119794-01 Rev. A 119794 01 07/06 NOT A UPC