Manual do usuário Desa Wall Mantel and Base W26ME

Resumo do conteúdo contido na página número 1

W26ME Wall MantEl and BasE
ass EMBl Y ad n Is n taa ll t IOn Is n t RUCt IOs n
Shown with
Shown with
Light Reed
Dark Reed
Panels
Panels
Important: Read entire instruction sheet before If any wood pieces are missing or damaged, contact the
dealer where you purchased this mantel for replacement.
assembling or installing mantel kit.
If hardware is missing or damaged, contact DESA Heating
this mantel is only approved for use with any DesA
Products at 1-866-672-6040 for referral information.

Resumo do conteúdo contido na página número 2

leG Assembly 4. Place right side/leg assembly on base and align threaded holes with brackets. Start 1/2" screws through brackets 1. Lay right side panel (#2) face down on a soft surface into threaded holes in side/leg assembly. Back of side/ to avoid marking finish. Attach three brackets with 1/2" leg assembly should be flush with back of base. Assure screws to bottom of right front leg (#3), leaving screws alignment is correct and spaces are at a minimum. Leave slightly loose. Face brack

Resumo do conteúdo contido na página número 3

mANtel tOP Assembly ReeD INst AllA tION 1 1. Start two 1 / " screws with washers through each of the 4 1. Mantel kit contains two sets of reed panels. A dark set three header assembly blocks (#8) and into threaded (Espresso) and a light set (Fruitwood). Determine which inserts on mantel as shown in Figure 4. set you prefer. Store second set in safe, dry location on a flat surface to interchange in the future if you so desire. 2. Place mantel top (#7) on mantel assembly. Align back of 1 to

Resumo do conteúdo contido na página número 4

Fireplace with fixed louver: Before installing logs or GAs FIRePlAce INst AllA tION burner assembly (see owner’s manual) remove screws 1. Fireplace should be fully assembled. See Assembling securing floor to assembly. Lift floor for access to bot- Fireplace in fireplace owner’s manual. tom of fireplace. Use two screws provided in fireplace 2. Place mantel base close to installation location. See fire- hardware package and attach fireplace base to wooden place owner’s manual for installatio