Manual do usuário Dimplex FXL18N

Resumo do conteúdo contido na página número 1

FXL(N) FAN STORAGE HEATER RANGE
MODELS: FXL18N - 2.6kW / 18kWh STORAGE & 1.5kW BOOST
FXL24N - 3.4kW / 24kWh STORAGE & 1.5kW BOOST
INSTALLATION AND OPERATING
INSTRUCTIONS
IMPORTANT
PLEASE READ THIS LEAFLET CAREFULLY AND
RETAIN FOR FURTHER USE. NOTE ALSO THE
INFORMATION GIVEN ON THE HEATER
The Installation must be carried out by trained personnel.
A means for disconnection must be incorporated in the fixed wiring by a double pole switch with a
contact separation of a minimum of 3mm and in acc

Resumo do conteúdo contido na página número 2

INSTALLATION INSTRUCTIONS FAN/BOOST CIRCUIT 2. Remove the inner front panel by unscrewing the screws along its top and sides. As the front insulation is attached care must be taken when lifting this panel from the heater and placing it to one side. Remove the three inner guards by removing the screws along their bottom edges and sliding the guards up and off the base tray. Please note the location of each guard. STORAGE CIRCUIT WARNING - This appliance must be earthed Only heat resisting cable

Resumo do conteúdo contido na página número 3

4. FAN SPEED SELECTION - At this point 10. Carefully fit the bottom row of the the installer must choose between Normal/ back layer of bricks placing the two end High Fan or permanent High Fan option. bricks into position first. Ensure that the recess in the bricks is toward the rear of Option 1 - The heater is factory set at Normal the heater with the narrow end to the Fan. The fan will therefore:- bottom. Repeat this with the top row of (a) Run at NORMAL when the boost option the back layer o

Resumo do conteúdo contido na página número 4

OPERATING INSTRUCTIONS Option 1 (two stage fan recommended for Principles of Operation Control Functions domestic installations) If boost option is not selected Normal Fan will operate. Heat Retention Setting the Controls If boost option is selected, the fan will This storage heater takes in energy when electricity The controls are located at the top right hand automatically operate at Normal speed when tariffs are low, and retains it in the insulated core. corner of the heater, both under the