Resumo do conteúdo contido na página número 1
HOME OWNER / INSTALLER
FOR YOUR SAFETY
THIS MANUAL MUST BE READ IN ITS
ENTIRETY BEFORE OPERATING HEATER
IB35ETRN
IB35ETRLC
Gas Radiant Space Heater
Owners Operation and Installation Manual
WARNING: If the information in these instructions are not
followed exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
•
Resumo do conteúdo contido na página número 2
LIMITED WARRANTY RINNAI FIREPLACE HEATER WHAT IS COVERED? This Warranty covers any defects in materials or workmanship, subject to the terms stated below. This Warranty extends to the original purchaser and subsequent transferees, but only while the product remains at the site of the original installation. This Warranty only extends through the first installation of the product and terminates if the product is moved or reinstalled at a new location. HOW LONG DOES COVERAGE LAST? Item Period of
Resumo do conteúdo contido na página número 3
WARNING IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE CAN CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER, SERVICE AGENCY OR THE GAS SUPPLIER. This manual applies to the following models only: IB35ETRBN/US IB35ETRSN/US IB35ETRBL/US IB35ETRSL/US Inbuilt Fire ETR Electronic Timer Remote Table of Contents Limited warranty ..............................................................................
Resumo do conteúdo contido na página número 4
SPECIFICATIONS Model: IB35ETRBN/US, IB35ETRSN/US (NG) United States IB35ETRBL/US, IB35ETRSL/US (Propane) United States Description: Freestanding radiant/convector, glass-fronted, ceramic log space heater with forced convection and natural draft flue system Gas Control: Electronic control valve Burners: Ember bed flame and heat burner Warm Air Discharge: Top front louvres Flue: Natural draft. Approved 4” B vent system Ignition: Electronic spark Power Supply: 120V. 60Hz Rating Plate Location: Bot
Resumo do conteúdo contido na página número 5
IMPORTANT POINTS / USAGE AND INSTALLATION MUSTS Unpack the heater and check for damage (DO NOT INSTALL DAMAGED HEATER). If the heater is damaged, contact your supplier for advice. Before installing the heater, check the label for the correct gas type (see rating plate, bottom right hand side of pillar). Refer to local gas authority for confirmation of the gas type if you are in doubt. Included in the carton Customer operation information. IMPORTANT Before using this product, please read this
Resumo do conteúdo contido na página número 6
36” CEILING 12” 12” LEFT RIGHT 36” FRONT qualified service technician to inspect 23 The draft hood on the appliance should the room heater and to replace any part be installed in the same atmospheric of the control system and any gas control pressure zone as the combustion air inlet which has been under water. to the appliance and shall be located so that the relief opening is accessible for 16 Adequate clearances for accessibility for checking vent operation. purposes of servicing and proper op
Resumo do conteúdo contido na página número 7
BEDDING MATERIAL, ET CETERA. IT 35 Do not substitute glass, glowing embers IS IMPERATIVE THAT CONTROL or logs. Use only glass, glowing embers and logs supplied by manufacturer. COMPARTMENTS, BURNERS AND CIRCULATING AIR PASSAGEWAYS 36 Caution: Do not operate unit with broken OF THE APPLIANCE ARE KEPT glass. CLEAN. 37 WARNING: DO NOT OPERATE 34 The glass window shall be replaced as APPLIANCE WITH THE FRONT one piece as supplied by the REMOVED, CRACKED OR BROKEN. manufacturer. See log and glass R
Resumo do conteúdo contido na página número 8
FOR YOUR SAFETY READ BEFORE OPERATING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A This appliance is equipped with an a neighbour’s phone. Follow the gas ignition device which automatically suppliers instructions. ignites the pilot. Do not try to light the • If you cannot reach your gas supplier call pilot by hand the fire dept. B. BEFORE OPERATING smell all around C.Use only your hand to pu
Resumo do conteúdo contido na página número 9
CONTROL PANEL LAYOUT For your convenience the controls on your new Flame Fire are situated under the cover on the top right-hand side of the fire and are accessed by simply lifting the lid. All necessary adjustments to the operation of your fire can be made with these controls. OPERATION • TURNING ON fan is running. Press the ON/OFF button to operate the • ROOM TEMPERATURE unit. The ON indicator will glow green. The ADJUSTMENT spark generator will be heard before the The room temperature and
Resumo do conteúdo contido na página número 10
deactivate the LOCK press and hold the you have selected AM or PM as required, button for 3 seconds until the indicator a small indicator on the left hand side of goes off. the Digital Display indicates the AM/PM setting. During normal operation the LOCK may be activated and all controls, other than the Use the buttons again to set the minutes. OFF switch, will be locked. Deactivating Scroll up or down using the buttons until the LOCK releases the controls. the correct time is reached. If the L
Resumo do conteúdo contido na página número 11
again when the power comes back on, but proceed to TIMER 2 - which is programmed in the same way - or three the time will be slow by the duration of the times to return to the clock display. This power failure. To set the clock to the must be done within 1 minute of setting the correct time after the power has come time to lock it into the memory. back on, simply follow the instructions on page 9. The digital display will show the current time. A small indicator on the digital display • OVERRID
Resumo do conteúdo contido na página número 12
• TO REPLACE REMOTE CONTROL ON BUTTON BATTERY Operates the unit manually. The battery is held in a clip that slides out the bottom of the remote control. The clip is removed by inserting a coin or similar OFF BUTTON into the recess in the back of the remote Stops unit control and sliding downwards. manually. The battery must be of type CR 2032 and will only operate if installed the right way up, as shown below. TEMPERATURE ADJUSTMENT Remove the battery if the remote control is Increases or not
Resumo do conteúdo contido na página número 13
36” CEILING 12” 12” LEFT RIGHT 36” FRONT LOCATION When positioning the heater, the main points governing the location are: 1. Flue connection and proper venting • Mantles 2. Warm air distribution. A mantle is allowable providing that it is outside the minimum clearances and the 3. Adequate air supply. distance it protrudes is no more than half the distance it is above the heater. 4. The heater must not be installed where curtains or other combustible materials See diagram below could come into c
Resumo do conteúdo contido na página número 14
• Fireplace dimensions There are two types of installation that may be used with this heater. • Non-combustible (masonry, brick etc) fire place. • Zero clearance kit installation, for installation in combustible materials. In each case there are minimum and maximum dimension that the fire place or opening must fall within, as shown in these diagrams. Solid Fuel Burning Fireplace This may require a sheet of non- 6” minimum combustible material to be laid under the chimney flue heater or a layer o
Resumo do conteúdo contido na página número 15
VENTING Use only an approved B vent system. An approved chimney liner must be ** used. It is recommended that the flue be installed vertically only. If installation X prevents this then there must be at X/3 maximum least 4 feet of vertical flue before any bends. The flue must not fall below horizontal at any stage. There must not be more than 2 bends in any 10 ft system. Any horizontal section of flue Minimum ** 4 ft must be less than 1/3 the length of maximum minimum vertical flue which fol
Resumo do conteúdo contido na página número 16
ELECTRICAL CONNECTION There is a junction box provided at the front of the heater for the electrical connection. WARNING: This appliance must be properly grounded for your protection against shock hazard. Connecting the power supply: Refer to the diagram opposite, 1 Open the side doors. 2 Loosen the screws holding the front panel in place. 3 Remove the front panel by sliding to one side to release it and then sliding back again to release the other end. Take care not to place strain on the wire
Resumo do conteúdo contido na página número 17
LOG INSTALLATION The logset is packed inside the unit and the packaging must be removed prior to installing the logset in its correct position. • Open both side panels. • Remove fasteners on both sides of the top glass retainer. • Lift retainer away from unit. • Loosen screws on bottom glass retainer. • Carefully lift glass out of bottom channel. • Carefully remove log packaging. The logset has two holes underneath for location onto the pins inside the unit. Place the logset into the unit ensuri
Resumo do conteúdo contido na página número 18
TESTING AND COMMISSIONING • TESTING PROCEDURE It is the responsibility of the installer to check that under normal operating Turn gas supply on and plug the unit into conditions of the appliance, all flue the power supply. (Caution 115V) gases are exhausted to the outside atmosphere and that there is no spillage of combustion gases into the • TO CHECK BURNER PRESSURE room. • Refer to rating plate. COMMISSIONING • Remove the wiring cover panel. • INSTALLATION / COMMISSIONING CHECKLIST • Remov
Resumo do conteúdo contido na página número 19
MAINTENANCE INSTRUCTIONS IMPORTANT MAINTENANCE INSTRUCTIONS A heater should not be used if you suspect ANNUAL INSPECTION there may be a problem, and a service The unit should be inspected at least once agent must be called to investigate the a year by a qualified service technician cause of the problem. including inspection of the flue system. The main burners are designed to produce The appliance area must be kept clear and some yellow flame but should not produce free from combustible material
Resumo do conteúdo contido na página número 20
• ELECTRIC MOTOR MAINTENANCE Motors are permanently lubricated and need no lubrication. Keep fan and motor free of dust and dirt, clean annually. The heater should be serviced annually only by an authorised person. • GLASS REPLACEMENT AND CLEANING. (May be performed by the owner) It is best to handle the glass with clean gloves to avoid smearing the glass with finger prints which might show after replacement. Refer diagram opposite Open the side panels.(1) Access can now be obtained to the t