Manual do usuário White Rodgers 1F59-11

Resumo do conteúdo contido na página número 1

1F59-11
Low Voltage Heat Pump Thermostat
WHITE-RODGERS
INSTALLATION & OPERATION
INSTRUCTIONS
Operator: Save these instructions for future use!
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
DESCRIPTION
This thermostat is designed to control a heat pump
system where automatic changeover is not required. The
thermostat is equipped with EMER HEAT and AUX
indicator lights. The EMER HEAT indicator

Resumo do conteúdo contido na página número 2

G O Y B INSTALLATION SELECT THERMOSTAT LOCATION 1 ⁄ ” hole for 2 thermostat wire Proper location insures that the thermostat will provide a comfortable home temperature. Observe the following Stout cord with 6” general rules when selecting a location: chain attached Approximately 1. Locate thermostat about 5 ft. above the floor. Baseboard 5 feet from floor strip moulding 2. Install thermostat on a partitioning wall, not on an 1 ⁄ ” guide hole 4 outside wall. for sighting 3. Never expose thermost

Resumo do conteúdo contido na página número 3

84 84 84 83 83 83 82 82 82 81 81 81 80 80 80 79 79 79 78 78 78 W7 77 77 77 76 76 76 75 75 75 74 74 74 73 73 73 72 72 72 71 71 71 70 70 70 EMER AUX G O Y B 50 60 70 80 90 G O Y B G O Y B 69 69 69 WIRE THERMOSTAT TO SYSTEM Insert stripped wires into terminal blocks, then tighten terminal screws. For best electrical connection, use solid 18 gauge wire. If Aux. Light you must use stranded wire, tin the wires with solder to Emer. Heat insure a good electrical connection. Light 1 1. Strip wires back ⁄

Resumo do conteúdo contido na página número 4

OPERATION SWITCH POSITIONS SYSTEM FUNCTION Rev Rev Aux FAN SYSTEM Fan Valve Valve Heat Compr. Emer Aux. COMPONENT OPERATION Auto On Cool Off Heat Emer Relay (O) (B) Relay Contact Light Light No heat - no cool - no fan - no lights Heating Mode: stage 1 calling. Fan relay, compressor contactor, and reversing valve (B) energized by thermostat. Heating Mode: both stages calling. Fan relay, compressor contactor, reversing valve (B), and auxiliary heat relay are energized. Emergency Heat Mode: aux he