Manual do usuário Escali M-Series

Resumo do conteúdo contido na página número 1

DIGITAL COUNTING SCALE

M - Series

OPERATING MANUAL




INTRODUCTION

Congratulations on your purchase of our Multifunctional Scale.

In order to ensure the scale continues to deliver peak performance, please
read these operation instructions carefully and thoroughly prior to initial usage.




IMPORTANT

1. Read all instructions before operating the scale.
2. Follow the basic safety precautions for all office equipment when using this
scale.
3. The manufacturer d

Resumo do conteúdo contido na página número 2

BATTERY INSTALLATION 1. Turn the entire scale upside down and reset it securely on a firm, flat surface. 2. Open the battery door by loosing the battery door screw. 3. Install four UM2 size C batteries in the battery compartment, ensuring that the positive/negative side is in the direction as shown in the cabinet. 4. Close the battery door and fasten it with the screw. BATTERY STATUS • When the battery is low, “Lo” will be displayed. Open the battery compartment and replace the old bat

Resumo do conteúdo contido na página número 3

OPERATION LEVEL THE SCALE When the scale is put to use at a new place, adjust the level of the scale by turning the 4 level adjusting feet until the bubble is located in the middle position of the bubble leveler. ACTIVATING THE SCALE 1. Turn on the “power on/off switch” 2. Turn the scale on by pressing “ON/OFF” key 2. The LCD screen will show all characters for a few seconds and then “0.000 ►” will be shown on the display. 3. The scale turns off automatically after being idle for two

Resumo do conteúdo contido na página número 4

USING THE COUNTING MODE:: A. Set sample size: 1. Turn on the scale 2. Press “PCS” key, SET will be shown on the display. 3. Press “MODE” key, 100 will be displayed. 4. Press “MODE” key again to select the sample size in the sequence of 10 → 20 → 40 → 60 → 80 → 100. 5. Press “PCS” key to confirm the sample size. “pcs” icon will be shown on the left hand corner of the display. 6. Press “PCS” again to return to weighing mode. Remark: the sample weight is memorized in the scale. You