Manual do usuário Liebert MP-C5120

Resumo do conteúdo contido na página número 1

LIEBERT MP™ ADVANCED POWER STRIPS
QUICK-START GUIDE: OPENCOMMS EM OR MP ADVANCED ACCESS SERVER
WHAT’S INCLUDED
Make sure you have all the items that should be included with your Liebert MP Advanced Power Strip. If
any item is missing or damaged in shipping, file a damage claim immediately—see the user manual for
details.
• RJ-45 to RJ-45 configuration cable, 5 ft. (1.5m)
• RJ-45 to DB9 adapter for configuration cable
• 2 mounting brackets and 4 screws
• Quick-start guide
Serial Ports - Connect

Resumo do conteúdo contido na página número 2

4. Click OK to open the IPSet window (at right). 5. In the Target area: a. Enter the OpenComms EM IP address Enter a unique b. Enter your network’s Subnet Mask IP address c. Enter your router’s IP address in the Default Subnet box. mask d. Enter the MAC address found on the bottom Default of your OpenComms EM. gateway 6. Apply the changes. If the device identification is address successful, the message “Successfully set IP Enter the unit’s MAC address address” appears in the Status box. (

Resumo do conteúdo contido na página número 3

DS74 CX1 CX2 1 2 3 4 CX3 CX4 EIA-232 I/0 MODULE DS62 NETWORK INTERFACE ETHERNET EIA-232 CONFIGURATION WITH LIEBERT MP ADVANCED ACCESS SERVER Liebert MP Advanced Mounting Power Strip Bracket on (MP-C5120) either side EIA-232 EIA-232 Port 1 3 5 8 POWER 2 4 6 8 EIA-232 Port - Connect to Power Strip EIA-232 Port MP-DS74 Card With Configurable Ethernet Port Liebert MP Advanced Communication Ports Access Server (MP-S5138) 100-240VAC On/Off Switch ?????????? 0.21-0.12AMPS ROUTE LINE (not on all

Resumo do conteúdo contido na página número 4

SET THE IP ADDRESS 1. Select “1” to set the IP Address for Module 1. Enter an IP address (below). The address must be unique on your system (obtain this from your network administrator). 2. Press Enter to return to the Network Port Configuration menu. Enter IP address 3. Choose “2” to set the Subnet Mask for your system (obtain this from your network administrator). SET THE GATEWAY ADDRESS 1. Return to the Network Port Configuration menu and choose “3” to set the Gateway Address (the IP addres