Manual do usuário Earlex STEAM CLEANING KIT SC165

Resumo do conteúdo contido na página número 1

STEAM CLEANING KIT
OPERATING INSTRUCTIONS
MODELS: SC75
SC76
SC125
SC150
SC165
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USE
Thank you for purchasing an Earlex Steam Cleaning Kit. In order to obtain the
best results please read the instructions before commencing any work.
Please also make a special note of the safety rules.
EARLEX LTD. WILL ACCEPT NO RESPONSIBILITY FOR THE USE OF THIS
PRODUCT IF USED FOR ANY OTHER PURPOSES THAN THOSE DETAILED
HEREIN.
RETAIN FOR FUTURE REFERENCE.

Resumo do conteúdo contido na página número 2

SAFETY RULES Keep equipment away from children and pets. Switch off and wait for 2 minutes before removing Ensure boiler is placed on a flat level surface, and filler cap to refill boiler. Do not overfill. should the boiler become tilted in use - level again immediately. Allow to cool completely before emptying boiler. Failure to do so can result in severe Do not stand on boiler or hose. overheating, complete element failure and void Do not drag or try to move boiler by pulling with

Resumo do conteúdo contido na página número 3

STEAM CLEANING KIT CONTENTS Please note: Not all of the accessories shown in this instruction booklet are included in every steam cleaning kit. To check the contents of your steam cleaning kit, please refer to the colour packaging (where supplied), cat- alogue or store where the unit was purchased. If you are unsure about the contents of your steam cleaning kit, please contact our helpline on 01483 454666. Component List Steam Boiler (not shown) i SC75 D87 SC76 W82 h SC125 B44 SC150 F64 j SC165

Resumo do conteúdo contido na página número 4

CASTORS (MODEL SC150 AND SC165 OPTIONAL) The castors are packed separately. Turn the boiler upside down and insert the 3 castors. These should be pushed in hard until they stop. Once installed these remain in place permanently. FILLING SC75 (see Fig.1) Remove elbow filler cap and fill unit to Max. level indicator with clean - preferably hot water. Ensure that the ‘O’ ring is seated correctly on the elbow filler cap and place elbow filler cap lugs into filler hole with the tongue pointing to th

Resumo do conteúdo contido na página número 5

FLOOR CLEANER IMPORTANT Some carpets have stain resistant treatments, which have varying active Iives before breakdown. Accordingly it is best to try a small area of carpet that is normally unseen, then allow 24 hours to check whether the steam has any unusual effects on the carpet material, e.g. white streaks. If this happens DO NOT CONTINUE USE - Check with your carpet supplier for further advice. Used correctly the floor cleaner will refresh your carpet by removing surface grime, pet hairs et

Resumo do conteúdo contido na página número 6

JET NOZZLE Connect the universal handle to the jet nozzle head. Select the scraper head or brush to fit the nozzle end if required and push on to the nozzle. PIug the boiler unit in and wait for steam to appear at the accessory head. Beware of hot water discharge prior to steam emission. This accessory can be used for cleaning all round the house, stoves, cupboards, work surfaces, toilets, sinks, lawnmowers etc. It both cleans and disinfects at the same time. It can also be used to defrost your

Resumo do conteúdo contido na página número 7

LARGE STEAM PLATE - WALLPAPER STRIPPING (OPTIONAL ACCESSORY - NOT INCLUDED IN ALL KITS) CAUTION! Check the state of your plaster before starting work. Steam can loosen weak, porous or poorly bonded plaster - which also loosens readily if cracked, holed or if the steam plate is held in place too long after the paper is soaked. Weak plaster can normally be detected by tapping a few areas of wall. A hollow sound indicates that you should pro- ceed only with extreme care - stopping immediately if yo

Resumo do conteúdo contido na página número 8

TROUBLE SHOOTING IF A PROBLEM OCCURS ALWAYS SWITCH THE UNIT OFF IMMEDIATELY. PROBLEM CAUSE ACTION Unit fails to boil. Safety cut-out has Refill boiler making sure to cover the element; operated. allow unit to cool for 20 mins then re-try. Fuse has blown in lead. Replace with a 13 amp fuse only. Power cord extension Extension cables must be rated at at least 10 being used. amps and fully unwound. A lower rating will trip out. Element burnt out due The element cannot be replaced, you can buy a to