Manual do usuário Clam Corp Fish Trap Guide 8060

Resumo do conteúdo contido na página número 1

Model No.
- 8060 -
p/n 108306
Specifications
Height: 60” (21” packed)

Width: 35 inches

Depth: 81” (35” packed)

Weight: 45 lbs.

- Clam Customer Service Information -
NOTICE!! Once used, this shelter cannot be returned to the store. If you have a
Warranty Claim, please contact Clam Corporation Customer Service by email
inquiry or direct by calling:
Customer Service Hrs: - 8am to 4pm, Mon. - Fri. Central Standard Time

Clam Corporation, Inc.

600 Clydesdale Trail
Medina, MN 5534

Resumo do conteúdo contido na página número 2

- Step One - 2

Resumo do conteúdo contido na página número 3

- Step Two - 3

Resumo do conteúdo contido na página número 4

- Step Three - Slide the Canopy Hoop Poles onto the Canopy Poles until the spring buttons engage the holes near the ends. Lean the Canopy Hoop Poles down and locate the Tent. 4

Resumo do conteúdo contido na página número 5

- Step Four - Drape the Tent over the supported hoops then go inside and spread out the Canopy Hoop Poles, attaching the Roof Velcro as you go. Feed the length of the Porch Hoop Pole through the Porch Hoop Sleeve sewn on the Tent. Slide the Porch Hoop Pole onto the Porch Poles, engaging the second hole position. Attach the Porch Velcro on each side of the Tent. The Tent is now ready to be “set” in the next step. 5

Resumo do conteúdo contido na página número 6

- Step Five - To “set” the tent, grasp the tent material at the rear of the shelter and pull it downward. Observe the porch area of the tent lifting accordingly as you pull. When the U-Channel Molding is correctly installed, the Porch Hoop Pole will lightly touch the floor. To achieve this condition, start by finding the center of the Molding. From behind the unit, pull the midpoint of the Tent downward and fold the Tent material under the lip of the Base. Then press the midpoint of the

Resumo do conteúdo contido na página número 7

- Tips for Use - Folding and transporting your Fish Trap is easy: Push the spring buttons and retract each hoop, starting with the rear hoop and working towards the front. Rotate all retracted hoops to the resting position. Tuck the tent into the base and between the hoops so that no material is left hanging on the ground for transport. Cover with the Travel Cover* (an optional but recommended accessory to help prolong the life of the unit). Tow the unit out to your favorite fishing s

Resumo do conteúdo contido na página número 8

8