Resumo do conteúdo contido na página número 1
M Mo od de ell 6 67 71 1X XV V
➤ O Ow wn ne er r’’s s G Gu uiid de e
V Viip pe er r
Resumo do conteúdo contido na página número 2
lliim miitte ed d lliiffe ettiim me e c co on ns su um me er r w wa ar rr ra an ntty y Directed Electronics, Inc. ("Directed") promises to the original purchaser to repair or replace with a comparable reconditioned model any Directed unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the foll
Resumo do conteúdo contido na página número 3
CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DIRECTED SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER'S PURCHASE PRICE OF THE UNIT. DIRECTED SHALL NOT BE RESPONSIBLE FOR ANY DAMAGES WHATSOEV- ER, INCLUDING BUT NOT LIMITED
Resumo do conteúdo contido na página número 4
tta ab blle e o off c co on ntte en ntts s lli im mi it te ed d lli if fe et ti im me e c co on ns su um me er r w wa ar rr ra an nt ty y.. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. i i 2 2- -w wa ay y r re em mo ot te e c co on nt tr ro oll d di ia ag gr ra am m .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .
Resumo do conteúdo contido na página número 5
2 2- -w wa ay y r re em mo otte e c co on nttr ro oll d diia ag gr ra am m 2 3 4 1 5 6 8 7 s stta an nd da ar rd d r re em mo otte e c co on nffiig gu ur ra attiio on ns s 1. Arm/Disarm Indicator (Orange) 2. Receive/Transmit Indicator (Green) 3. Auxiliary Indicator (Yellow) 4. Siren Indicator (Red) 5. Arm Button 6. Disarm Button 7. Panic Button 8. Auxiliary Channel Button © 2004 directed electronics, inc. 2
Resumo do conteúdo contido na página número 6
w wh ha att iis s iin nc cllu ud de ed d ➤ One control module ➤ An XHF2 transceiver/antenna ➤ One 4-button 2-way remote ® ® ➤ Stinger Doubleguard dual-stage shock sensor ® ® ➤ Revenger Soft Chirp six-tone programmable siren ➤ In-vehicle status LED indicator light ® ➤ Push-button Valet switch ➤ Your warranty registration ® ➤ Failsafe Starter Kill ready circuitry (may require additional labor) iim mp po or rtta an ntt iin nffo or rm ma attiio on n Congratulations on the purchase of your stat
Resumo do conteúdo contido na página número 7
system maintenance ➜ This system needs no specific maintenance beyond 2-way remote control battery replacement. The 2-way remote is powered by a 1.5V AAA battery. Low Battery Notification If the battery is low (and this feature is programmed On) the 2- way remote will emit 2 long beeps 5-seconds after a transmission is completed. The 2 long beeps will repeat every 25seconds up to 3 times (or until a 2-way remote button is pressed). Battery Replacement Gently pull the end of the battery door away
Resumo do conteúdo contido na página número 8
fcc/id notice ➜ This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device.
Resumo do conteúdo contido na página número 9
2 2- -w wa ay y r re em mo otte e c co on nttr ro oll ffu un nc cttiio on ns s The 2-way remote control buttons are used to send commands to the system. The descriptions below reflect the standard config- uration for this system. The buttons can be custom configured for the user’s specific needs by the installer. standard button configurations ➜ Button The System Arm and Multi-Level Security Arming functions are controlled by pressing this button for one second. Button The System Disarm and H
Resumo do conteúdo contido na página número 10
and Buttons An optional auxiliary convenience or expansion function that you have added to your system can be activated by pressing these buttons simultaneously. The auxiliary output controls __________________________. r re em mo otte e o op pe er ra attiio on n The remote start system operates at 434 MHz and incorporates Directed’s proprietary XHF2 out-board technology transceiver. The high frequency combined with Binary Data communication achieves superior range with two-way communication. s
Resumo do conteúdo contido na página número 11
Alarm Page If the alarm system is triggered while armed, an Alarm Page will be sent to the remote control. When the remote receives an Alarm Page, the LED icons will display the alarm system status information and the remote control will generate beeps. An Alarm Page alert is a series of 10 or 4 rapid beeps and the Red LED will illuminate. This will repeat every 100 seconds to alert the user that the alarm system was triggered and will continue until the alarm page is cleared. If the shock senso
Resumo do conteúdo contido na página número 12
out of range notification ➜ If a command is issued from the remote, but the remote is beyond the range of the vehicle to receive the command, the remote responds with 2 sets of 3 quick beeps and the Green LED will flash 6-times. p pr ro og gr ra am mm miin ng g 2 2- -w wa ay y r re em mo otte e To enter programming mode Press and hold all four remote control buttons simultaneously until one long beep is heard. Programming mode is now entered. Beeps On/Off Press to select beeps On/Off. One beep
Resumo do conteúdo contido na página número 13
Page notification The remote control can be programmed to notify the user of a page (audibly beeping if the vehicle’s status changes, e.g. door unlocked, engine started, vehicle violation, etc.). Press to select page On/Off. One beep is page On, Two beeps is page Off. When programmed off the remote will not give any notification that a page was received from the vehicle. To exit programming mode The remote control will exit programming mode after 2-seconds of inactivity and will emit 2 long beep
Resumo do conteúdo contido na página número 14
second chirp after arming and note that the in-vehicle’s status LED is flashing in groups, see the Diagnostics Section of this guide. This extra chirp is called Bypass Notification. The remote responds to active arming with one beep and the Orange LED will flash 3-times to indicate successful arming of the system. If after 2-seconds the remote beeps once and the Orange and Red LEDs flash 3-times, the system has detected an active sensor that should be checked. If after 2-seconds the remote beeps
Resumo do conteúdo contido na página número 15
The remote responds to passive arming with one beep and the Orange LED will flash 3-times to indicate successful arming of the system. note: If any protected entry point (such as a door or a switch-protected trunk or hood) is open, the system will not passively arm (unless forced passive arming is pro- grammed on. See Programming Options section.) Addi- tionally, each time a sensor is triggered during the arming countdown, the 30-second countdown starts over. When armed your vehicle is protected
Resumo do conteúdo contido na página número 16
multi-level security arming ➜ Multi-Level Security Arming allows you to select which of the system's inputs or sensors will be active and which will be bypassed when the system is armed. (See Table of Zones section of this guide.) Pressing (only in Standard Configuration) again within five seconds of arming the system will activate the Multi-Level Security feature. Each time is pressed again, a different security level is selected. The different security levels are selected as follows: ➤ Press o
Resumo do conteúdo contido na página número 17
After each press of the to reach the next level of security, the remote will emit normal arm notification (1 beep and 3 flashes of the Orange LED). For easiest operation in reaching each level of security, press immediately a af ft te er r each notification. arming while driving ➜ Your security system can be armed while driving the vehicle! Simply press on the 2-way remote for two seconds while the vehicle is running. The siren will chirp once to indicate that the security system is armed, and t
Resumo do conteúdo contido na página número 18
The remote will indicate disarm notification with 2 beeps and 3 flashes of the Orange LED. If disarming after the system has been triggered, the remote control will send a diagnostic notifi- cation as a reminder. These diagnostic notifications are: 1. If a sensor triggered the system, the remote will beep 4-times and the Orange and Red LEDs flash 3 times. 2. If a switch (Zone 1, 3, 5, or 6) triggered the system, the remote will beep 4-times, the Orange LED will flash 6-times and Red LED will ill
Resumo do conteúdo contido na página número 19
notes: The first press of the remote button, while the remote is beeping, only clears the alarm page (no com- mand is sent to the vehicle). The transceiver transmits immediately upon system trig- ger and does not allow disarm during the first 6 seconds after trigger. The 2-way remote will respond with a number of beeps and LED flashes according to whether a pinswitch, sen- sor, activated the alarm (and also if NPC is active). disarming without a 2-way remote ➜ This feature allows you to disarm t
Resumo do conteúdo contido na página número 20
important! The unit can be programmed to respond to ® one to five pulses of the Valet button for the disarm function. Be sure to check with the installer for the desired programming. The remote will indicate disarm notification with 2 beeps and 3 flashes of the Orange LED. silent mode ➜ To temporarily turn off the arm or disarm chirps, use Silent Mode™. Simply press for less than one second before arming or disarming, and the confirmation chirp(s) will be elim- inated for that one operation only
