Manual do usuário Everpure EV9336-51

Resumo do conteúdo contido na página número 1

Installation and Operation Guide
Parallel 202 &/or Surge Tank Retrofit Kit
EV9336-52
DESCRIPTION
The Parallel 202 Pre-Filter is designed to remove larger dirt particles (10 microns-nominal) from the incoming water to a high flow, high volume
fountain machine, a coffee maker and/or an ice machine in order to extend the life of the fine filters. The surge (accumulator) tank is a pre-
pressurized, diaphragm-type tank designed to provide filtered water to a high flow, high volume fountain machine during

Resumo do conteúdo contido na página número 2

Figure 1. Parallel 202 Pre-Filter and/or Extra Capacity Surge Tank or Standard Surge Tank Retrofit Kit PARALLEL-202 PRE-FILTER (EV9100-24) INSTALLATION 1. Shut off water and electrical power to all affected food service equipment. It is important that the installation of the pre-filter be clean and sanitary. All water-contact parts shall be immersed in chlorinated water (a capful of bleach per bucket of water) at the start of the installation procedure. 2. Disconnect electrical power and water

Resumo do conteúdo contido na página número 3

10. Inspect the high flow filter system for any water leakage, tightening all connections as required until no leakage is observed. Turn on water and electrical power to all affected food service equipment. The filter system is now in service. Always keep a supply of replacement cartridges on hand. SERVICE No routine (daily, weekly, monthly, etc.) servicing of the pre-filter is required under normal operating conditions. The only scheduled servicing of the pre-filter is to change-out the cartridg

Resumo do conteúdo contido na página número 4

12. Pour a capful of bleach into the tubing connected in step 11 onto the 3/4” NPT x 3/4” barb connector at the surge tank ball valve and then immediately connect the loose tubing end to the 1/2” NPT x 3/4” barb connector installed in step 7. Fully tighten the remaining tubing clamp to secure the tubing onto the connector barb. 13. Place the high flow filter system into service by opening the inlet water ball valve. Open the surge tank ball valve and allow the surge tank to fill for three min