Manual do usuário Bunn TITAN SINGLE 2

Resumo do conteúdo contido na página número 1

USE & CARE INSTRUCTIONS for ULTRA-2 COLD DRINK DISPENSER WITH PAF DISPENSER
NOTICE - This guide is for quick reference only and is not intended to replace the information in the Operation Manual!
DISASSEMBLY & CLEANING
Empty all product from the ULTRA hoppers before proceeding!
1. Open the Cabinet Door 2. Pull the Mixing Cham- 3. Twist the Whipper 4. Pull the Frother off the 5. Twist Whipper Cham-
and allow the support ber out of the Whipper Chamber clockwise and Motor Shaft. Notice the ber Rece

Resumo do conteúdo contido na página número 2

16. Do not scratch this 17. Remove the Drip Tray surface when cleaning. and Cover. Deep scratches could cause leakage around the seal. 18. Place all parts in a clean sink with mild hot water (120°F) and sanitizer solution. Allow parts to soak for at least 5 minutes. Carefully wash all components with a clean wash cloth in the hot water and sanitizer solution. Use a clean, soft bristle brush as needed for the smaller components and tight areas. Do not immerse hopper lids. Use a commercial sanitiz

Resumo do conteúdo contido na página número 3

26. Slide PAF assembly 27. Reassemble and in- 28. Position the Faucet 29. Slide the Faucet Valve 30. Press down on the forward. stall all PAF parts. Close Seal and Return Spring in assembly into place on Valve to compress the Door. the Faucet Valve. the Hopper. Spring. Position the Fau- cet Handle over the Fau- cet Valve one side at a time and snap into place on the Hopper. 31. Install the Drip Tray and Cover. THOROUGH CLEANING OF THE PAF HOPPER (Once a week) 1. Open the Cabinet Door 2. Remove t