Manual do usuário Viking VIL1200

Resumo do conteúdo contido na página número 1

VIKING MODEL VIL1200
INLINE FAN
ONLY FOR USE WITH: VWH, VIH, VBCV, VICV, DTWL AND
DTWN 24"W TO 66"W WALL AND ISLAND HOODS
READ AND SAVE THESE INSTRUCTIONS
CAUTION
WARNING
1. For general ventilating use only. Do not use to exhaust
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-
hazardous or explosive material and vapors.
JURY TO PERSONS, OBSERVE THE FOLLOWING:
2. T o avoid motor bearing damage and noisy and/or
1. Use this unit only in the manner intended by the manufac-
unbalanced impel

Resumo do conteúdo contido na página número 2

PLANNING THE INSTALLATION 1. Locate the inline fan so that the length of the duct run and � number of elbows needed is kept to a minimum. 2. The inline fan is designed for use with 10” diameter duct. 3. Use rigid metal ductwork. 4. Always install ventilation products with an approved wall or roof cap. 5. For a truly quiet kitchen ventilation system add a Viking �� � � Inline Duct Silencer part number VSIL10 (sold separately) to the installation. The simple addition of a inline duct si-

Resumo do conteúdo contido na página número 3

CONNECT WIRING TO VIL1200 INLINE FAN CONNECT WIRING TO THE ROUGH-IN PLATE 1. The opposite end of this wiring will be connected to the 1. Run 115VAC electrical power cable from the service panel rough-in plate in the next step. and from the inline fan to the rough-in plate part number 2. Remove wiring box cover from the inline fan. PV300008. 3. Attach an appropriate UL approved cable connector to 2. R emove appropriate knockouts from the range hood rough the wiring hole in the wiring box. i

Resumo do conteúdo contido na página número 4

CONNECTING DUCT WORK TO VIL1200 INLINE FAN USE AND CARE Two duct clamps part number 001377-000 are included Disconnect electrical power supply and lock out service panel with this unit and are intended to simplify fan installation before cleaning or servicing this unit. and isolate fan vibration from the rigid metal duct. CLEANING Note: The duct clamps are convenient in installations Periodic inspection and cleaning is recommended. The fre- 8mm neoprene pad where regular removal of the quenc