Resumo do conteúdo contido na página número 1
Operating and Installation
Instructions
Ventilation System
DA 408
DA 409
To prevent accidents en - US, CA
and machine damage,
read these instructions
before
installation or use. M.-Nr. 06 241 950
Resumo do conteúdo contido na página número 2
Contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the appliance Operation Turning on the fan .................................................10 Selecting the power level............................................10 Delayed Shut Down................................................12 Turning off the fan .................................................12 Turning the lighting on/off ...........................................13 Dimming the lighting ...........................
Resumo do conteúdo contido na página número 3
IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is designed to vent ~ This appliance is intended for cooking smoke and odors only. residential use only. Use the Be certain your appliance is ~ appliance only for its intended properly installed and grounded by a purpose. The manufacturer cannot qualified technician. be held responsible for damages To guarantee the electrical safety of this caused by imprope
Resumo do conteúdo contido na página número 4
IMPORTANT SAFETY INSTRUCTIONS This equipment is not designed for Use ~ maritime use or for use in mobile Do not allow children to play with or ~ installations such as recreational operate the appliance or its controls. vehicles or aircraft. However, under Supervise its use by the elderly or certain conditions it may be possible for infirm. installation in these applications. Please contact the nearest Miele dealer or the Do not flambé or grill with an open ~ Technical Service Department with fla
Resumo do conteúdo contido na página número 5
IMPORTANT SAFETY INSTRUCTIONS , WARNING - TO REDUCE , WARNING TO REDUCE THE RISK OF INJURY THE RISK OF A COOKTOP TO PERSONS IN THE EVENT OF A GREASE FIRE: COOKTOP GREASE FIRE, OBSERVE Never leave surface units ~ THE FOLLOWING: unattended at high settings. Boilovers SMOTHER FLAMES with a close ~ cause smoking and greasy spillovers fitting lid, cookie sheet, or metal tray may ignite. Heat oils slowly on low or then turn off the burner. medium settings. BE CAREFUL TO PREVENT BURNS. Always turn the
Resumo do conteúdo contido na página número 6
IMPORTANT SAFETY INSTRUCTIONS Installation Any fittings, sealant, or materials ~ used to install the ductwork must be , WARNING ~ made of approved non-flammable To reduce the risk of fire only use materials. metal ductwork. Never connect an exhaust hood to ~ Provided a larger distance is not ~ an active chimney, dryer vent, vent flue, given by the manufacturer of the or room ventilating ductwork. Seek cooktop, follow the minimum safety professional advice before connecting distances between a co
Resumo do conteúdo contido na página número 7
Functional description The hood offers two modes of operation: Air extraction Recirculation mode The air is drawn in and cleaned by the Air is drawn through the grease filters grease filters and directed outside. and an active charcoal filter. The filtered air is then recirculated back into The hood comes equipped with a the kitchen through a vent at the top of non-return flap. This flap automatically the hood’s chimney. closes when the hood is turned off so that no exchange of outside air and T
Resumo do conteúdo contido na página número 8
Guide to the appliance 8
Resumo do conteúdo contido na página número 9
Guide to the appliance a Chimney extension m Grease filter button The indicator next to the grease filter b Chimney button lights when the grease filters need to be cleaned. This button is also c Canopy used: – to reset the grease filter timer after d Control panel cleaning the grease filters (see "Cleaning and Care"). e Grease filter – to show how long the grease filters have been in use (see "Operation/ f Recirculation vent Filter timers"). – to change the number of hours g Overhead lighting c
Resumo do conteúdo contido na página número 10
Operation Turning on the fan Automatically switching back the Intensive power level The intensive level "4" can be programmed to automatically switch back to level "3" after 10 minutes. ^ Press the On/Off button. ^ Turn the fan and the lights off. Selecting the power level ^ Press and hold the "Delay Shut down" button for 10 secs. The first indicator ^ Use the "–/+" controls to select the of the fan power levels lights. desired power level. ^ Press the following buttons one after & = increases t
Resumo do conteúdo contido na página número 11
Operation If the power level indicators flash the Fan performance automatic switch back is not activated. The maximum air flow capacity is 625 cfm. Factors such as narrow duct diameter and bends will affect this value. Level 1 operates at 40% capacity ^ To activate the automatic switch back Level 2 operates at 60% capacity press the "+" button. Level 3 operates at 80% capacity Level 4 operates at 100% capacity The power level indicators light. There will also be a slight decrease in ^ To deactiv
Resumo do conteúdo contido na página número 12
Operation Delayed Shut Down Turning off the fan If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes. ^ Press the On/Off button to turn the fan off. The indicator will go out. Automatic Safety Shut Off ^ Press the Delayed Shut Down button The fan will turn off automatically while the fan is still running. 10 hours after the last button was Press once = 5 minute dela
Resumo do conteúdo contido na página número 13
Operation Turning the lighting on/off Dimming the lighting The overhead lighting can be turned on The brightness of the lighting can be and off independently from the fan. adjusted. ^ While the lighting is turned on, press the light button. The lighting will dim until the button is released. ^ Press the light button briefly to turn ^ If the button is pressed again, the on the lighting. lighting will brighten until the button is released. The light button indicator illuminates. If the button is p
Resumo do conteúdo contido na página número 14
Operation Filter timers Checking the filter timers To check the percentage of time Grease filters already used: A timer monitors the hours of fan operation. The indicator for the grease filter will light after 30 hours of operation. The grease filters must then be cleaned. ^ Press the On/Off button to turn the fan on. After the grease filters have been cleaned and put in place, the grease filter timer must be reset. ^ Press and hold the grease or charcoal filter button. ^ To do this, press the g
Resumo do conteúdo contido na página número 15
Operation Reprogramming the timers The grease filter timer is preset to 30 hours. This time can be lengthened or shortened to 20, 30, 40, or 50 hours. The lit indicator shows the programmed – A time of 20 hours should be time: programmed in kitchens with 1st indicator from the left = 20 hours frequent pan or deep frying. 2nd indicator from the left = 30 hours – A time of 20 hours should also be 3rd indicator from the left = 40 hours programmed if the kitchen is only 4th indicator from the left =
Resumo do conteúdo contido na página número 16
Operation Reprogramming the charcoal filter timer The active charcoal filter can only be used in recirculation mode and cannot The lit indicator shows the programmed be used to exhaust fumes. time: The charcoal filter timer is not preset. 1st indicator from the left = 20 hours Before using the hood in recirculation 2nd indicator from the left = 30 hours mode, the charcoal filter timer must be 3rd indicator from the left = 40 hours programmed. 4th indicator from the left = 50 hours ^ Use the "–/+
Resumo do conteúdo contido na página número 17
Cleaning and Care Stainless steel Before cleaning or servicing the hood, disconnect it from the power Stainless steel surfaces can be cleaned supply by either removing the fuse, using a non-abrasive stainless steel unplugging it from the outlet, or cleaner. manually "tripping" the circuit To help prevent resoiling, a conditioner breaker. for stainless steel can be applied. Cleaning the casing Controls Warning: Never use abrasive These controls may become dis- cleaners, scouring pads, steel wool
Resumo do conteúdo contido na página número 18
Cleaning and Care Grease filters ^ In a dishwasher: place the filter vertically in the lower basket, making The reusable metal grease filters sure that the spray arm is not remove solid particles from the vented blocked. kitchen air (grease, dust, etc). Use a hot temperature program, e.g. "Heavy Soil" or "Pots and pans". Use the recommended amount of dishwasher detergent. Overuse could destroy the filter. The grease filters should be cleaned Depending on the detergent, every3-4 weeks or when the
Resumo do conteúdo contido na página número 19
Cleaning and Care Active charcoal filter In recirculation mode an active charcoal filter must be used in addition to the grease filters. It is designed to absorb cooking odors. The active charcoal filter will be replaced in the canopy above the grease filters. Replacement active charcoal filters ^ Insert the charcoal filter with the flap can be ordered from Miele. facing the front. ^ Remove the grease filters to access Before using: the charcoal filter. See "Cleaning and ^ Program the charcoal f
Resumo do conteúdo contido na página número 20
Cleaning and Care Changing the light bulb Before changing the light bulbs, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. ^ Turn the bulb counterclockwise and When in use halogen bulbs become pull it out of its socket. extremely hot, use caution. Do not attempt to change the bulbs until ^ Replace the bulb with a new one in they have had sufficient time to cool. the reverse order. ^ Return the grease filters. Do no
