Manual do usuário Plantronics 50-0230B-004

Resumo do conteúdo contido na página número 1

KEMCO



FOR
50 - 0230B - 002
50 - 0230B - 003
50 - 0230B - 004
SUBURBAN






















These instructions





1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter
3. T - 15 TORX bit driver 4. Razor knife or similar
5. T - river 6.

Resumo do conteúdo contido na página número 2

Description 4 1 SCREW, # 6 X 1/2" PPH 4 2 SCREW, # 6 X 3/8" PPH 4 3 SCREW, # 8 X 2 1/2" PFH 3 4 SCREW, #8 X 1 1/ 2 5 1 6 1 7 LIGHT 2 8 LIGHT TRIM 2 9 PLYWOOD, 3/8" X 6" X 14" 1 10 , 6 - 6 11 4 12

Resumo do conteúdo contido na página número 3

head. See Figure 1. four tabs on back of control assembly. See Figure 2. Discard cloth covered trim ring. 3. removing center cover and (2) two screws. 4. 5. 3 FIGURE 3 l

Resumo do conteúdo contido na página número 4

Caution: Bef Cut only where indicated. contacts rear edge of recessed area. See Fig. 5. # 8 x 3/4" TEK screws. See Figure 6. 4 FIGURE 6 8. Secure bracket to sheet metal frame using (4) four FIGURE 5 roof. Slide bracket rearward until flange the metal inner area. Align the front mounting tabs with the openings in 7. I

Resumo do conteúdo contido na página número 5

10. Remove and retain the (2) two door scuff 11. nts to the 12. 5 FIGURE 9 nd lay aside. See Figure 9. headliner a side of vehicle. Unsnap upper door trim from head bolt and bracket. Carefully pull panel away from bracket for the seat belt. Remove and retain TORX Unsnap the cover from upper and lower

Resumo do conteúdo contido na página número 6

6” wide x 8 3/4” long. Make sure that the 6” Caution: Before only where indicated. opening and rotate 90 degrees. See Figure 10. 16. 17. re using (1) one 18. 11. NOTE: Additional assistance in mounting the overhead console in vehicle is advised 6 to prevent damage to console or components. III. INSTALLATION OF

Resumo do conteúdo contido na página número 7

opening to B - B - instructions included with the antenna. 12 Caution: Do not overtighten screws. Use secured to the vehicle. Failure to do 2 - 32 X 3/4" on console 13 two # 8 x 1 1/4" screws. Make sure console is centered - 2. 14

Resumo do conteúdo contido na página número 8

c around control head. Insert control 2 1/2" screws at the rear light. Make 29. Ins 1 5 IMPORTANT - TORQUE SEAT BELT BRACKET TO MFG. . 32 . 16 8 FIGURE Install door scuff plates in original position. iginal position. “B” pillar in or 31. Reinstall handle and door trim to top of SPECIFICATION fasteners. secure seat belt bracket us