Manual do usuário TP-Link TL-ANT5830B

Resumo do conteúdo contido na página número 1

Quick Installation Guide
5GHz 30dBi Outdoor Grid Parabolic Antenna
TL-ANT5830B

7106503929
Rev. 1.0.0

Resumo do conteúdo contido na página número 2

I. Introduction TL-ANT5830B, the TP-Link 5GHz 30dBi Outdoor Grid Parabolic Antenna, is applicable for outdoor point-to-point or point-to-multi-point directional signal transmission. It is usually mounted on such high-level outdoor locations as towers, roofs, etc. The easy way to mount TL-ANT5830B is to bind it to a mast, as illustrated above. * TL-ANT5830B is only compatible with 5GHz Access Points. Please do not connect it with 2.4GHz AP. 1

Resumo do conteúdo contido na página número 3

II. Specifications Electrical Specifications Model TL-ANT5830B Frequency Rang-MHz 5150-5850 Gain-dBi 30 VSWR ≤1.8 Horizontal Beamwidth-° 6 Vertical Beamwidth-° 4 Polarization Vertical or Horizontal F/B Ratio-dB ＞30 Impedance- Ω 50 Maximum Input Power-W 100 Connector N Female Mechanical Specifications Antenna Dimension-mm 600×900 Weight-Kg 3, 5 Mounting Mast Diameter-mm Ø30 ～Ø50 Radome Material Aluminium Die Cast Rated Wind Velocity-Km/h 241 2

Resumo do conteúdo contido na página número 4

III. Radiation Patterns Vertical Pattern Horizontal Pattern 3

Resumo do conteúdo contido na página número 5

IV. Installation Please find the necessary accessories in the attachment, and take the following steps to install your antenna TL-ANT5830B. 1. Mount the antenna on the “L” type brackets according to the mounting diagram. Make sure the antenna polarization is parallel to the direction you need. When the antenna polarization is vertical to the 4

Resumo do conteúdo contido na página número 6

ground, the antenna is vertically polarized. When the antenna polarization is horizontal to the ground, the antenna is horizontally polarized. 2. Mount the antenna on the pipe mast according to the mounting diagram. 3. Test the antenna with equipment to make sure the antenna receive the best signal by turning the azimuth and pitching angle, then lock all the screws and seal the connector between antenna and cable. 5

Resumo do conteúdo contido na página número 7

4. Connect TL-ANT5830B to 5GHz AP (Access Point) interface with cables. It’s recommended to use radio frequency cables with high quality and low loss. Besides, the shorter the cable is, the better it will be to avoid unnecessary loss. Warning:  Mount the antenna at a safe location, far away from power lines, lamps, and other cables.  Do not mount the antenna in the rain or thunder storm.  Do not mount the antenna alone. 6

Resumo do conteúdo contido na página número 8

Technical Support  For more troubleshooting help, go to: http://www.tp-link.com/en/support/faq  To download the latest Firmware, Driver, Utility and User Guide, go to: http://www.tp-link.com/en/support/download  For all other technical support, please contact us by using the following details: Global Australia & New Zealand Tel: +86 755 26504400 Tel: AU 1300 87 5465 E-mail: support@tp-link.com NZ 0800 87 5465 Service time: 24hrs, 7 days a week E-mail: support@tp-link.com.au S