Resumo do conteúdo contido na página número 1
KDC-U553BT
CD-RECEIVER
INSTRUCTION MANUAL
© 2011 JVC KENWOOD Corporation B64-4920-00/02 (MW)
B64-4920-00_02_M_English.indd 1 11/12/21 9:43
Resumo do conteúdo contido na página número 2
CONTENTS Safety 3 Getting Started of Bluetooth 14 Maintenance Registering your Bluetooth device with this unit (Pairing) The marking of products using lasers Registering from Bluetooth devices (Pairing) Preparation 4 Operation of Hands-Free Phoning 16 How to attach/detach the faceplate Making a Call How to reset your unit Make a Voice Dialing Call How to prepare the remote controller (RC-405) Receiving a Call During a Call Getting Started 5 Switching between Two Connected Cell- Canceling the d
Resumo do conteúdo contido na página número 3
Safety ¤WARNING The marking of products using Stop the car before operating the unit. lasers Important to know... CLASS 1 ■■ To prevent a short circuit, never put or leave LASER PRODUCT any metallic objects (such as coins or metal tools) inside the unit. ■■ The label is attached to the chassis/case and Caution: Adjust the volume so that you can says that the component uses laser beams hear the sound outside the car. Driving with that have been classified as Class 1. the volume adjusted
Resumo do conteúdo contido na página número 4
Preparation How to attach/detach the faceplate How to prepare the remote controller (RC-405) When you use the remote controller for the 1 first time, pull out the insulation sheet. 1 Insulation sheet 2 2 ■■ Do not expose the faceplate to direct sunlight, excessive heat, or humidity. Also avoid places with too much dust or the If the effectiveness of the remote possibility of water splashing. controller decreases, replace the battery. ■■ Keep the faceplate in its casing while detached. 4 2
Resumo do conteúdo contido na página número 5
Getting Started Canceling the display Adjusting the clock demonstration 1 Press the volume knob to enter The display demonstration is always turned [FUNCTION] mode. on unless you cancel it. 2 Turn the volume knob to select [SETTINGS], then press to enter. When you turn on the power (or after you 3 Turn the volume knob to select [CLOCK], reset the unit), the display shows: then press to enter. [CANCEL DEMO] \ [PRESS] \ [VOLUME 4 Turn the volume knob to select [CLOCK KNOB] ADJUST], then press
Resumo do conteúdo contido na página número 6
Basic Operations Loading slot Remote sensor ■■ Do not expose to bright sunlight. Ejects the disc PAR VOICE iPod Volume knob Display window Detaches the faceplate The following indicator lights up when... ST: A s tereo broadcast is received. IN: A disc is in the unit. ATT: The sound attenuates. EQ: [ PRESET EQ] is set to an EQ mode other than [NATURAL]. (page 22) B.BOOST: [BASS BOOST] is set to [LV1], USB terminal [LV2] or [LV3]. (page 22) : I ndicates that the Music Search mode is Auxiliar
Resumo do conteúdo contido na página número 7
When you press or hold the following button(s)... Remote Main unit General operation controller ■■ Turns on. — ■■ Turns off if pressed and held. Selects the available sources (TUNER, BT AUDIO, USB or iPod, CD, SRC AUX, STANDBY), if the power is turned on. SRC • I f t h e s o u r c e i s r e a d y , p l a y b a c k a l s o s t a r t s . • “ iP o d ” o r “ C D ” i s s e l e c t a b l e o n l y w h e n a n iP o d i s c o n n e c t e d o r a d i s c i s l o a d e d . Volume knob VOLud Adjusts
Resumo do conteúdo contido na página número 8
Listening to the Radio PAR VOICE iPod ■■ Press and hold to memorize the current station. ■■ Press briefly to recall memorized station. Changing the frequency steps 1 Press SRC to select “TUNER”. You can change the frequency step of FM/ 2 Press repeatedly to select a band (FM1/ AM. FM2/ FM3/ AM). FM : 50 kHz to 200 kHz 3 Press 4 / ¢ to search for a station. ■■ AM : 9 kHz to 10 kHz The tuning mode can be changed. Refer to 1 Press and hold SRC to turn off the (page 8). power. Di
Resumo do conteúdo contido na página número 9
Listening to the other external components Preparation : Make sure [ON] is selected for [BUILT-IN AUX]. (page 5) PAR VOICE iPod 1 Press SRC to select “AUX”. Auxiliary input jack 2 Turn on the external component and start playing. 3 Turn the volume knob to adjust the volume. 3.5 mm stereo mini plug Portable audio device (commercially available) (commercially available) English 9 B64-4920-00_02_M_English.indd 9 11/12/21 9:43
Resumo do conteúdo contido na página número 10
Listening to a Disc/ USB device/ iPod Ejects the disc. (“NO DISC” appears and “IN” Loading slot indicator goes off.) PAR VOICE iPod ■■ Press to select track/file. USB terminal ■■ Press and hold to fast- Press to pause. Press again forwards/fast-backwards. to resume playback. Press to select folder of Audio File/iPod. Start playing a disc 1 Press SRC to turn on the power. Apple iPod 2 Insert a disc into the loading slot. (commercially available) Playback starts automatically. Start playing a U
Resumo do conteúdo contido na página número 11
5 Press 4 / ¢ to move to the entry Selecting Random Play position. Press number button 3 (ALL RDM) You can enter up to three characters. repeatedly to make a selection. 6 Press the volume knob to start searching. Audio CD : DISC RANDOM, RANDOM OFF After this step, see step 2 of (page 11) to select a FOLDER RANDOM, RANDOM OFF song. All Random Play ■■ To return to the Music Search mode, press Press and hold number button . ■■ 3 (ALL RDM). T
Resumo do conteúdo contido na página número 12
3 Turn the volume knob to select [SKIP Selecting App & iPod Control Mode SEARCH], then press to enter. Press number button 5 (iPod) repeatedly 4 Turn the volume knob to make a to make a selection. selection, then press to confirm. MODE ON : 0.5% (initial)/ 1%/ 5%/ 10% : Sets the ratio Control iPod from the iPod *. “APP&iPod of skip when searching for a song in Music MODE” appears on the display. Search mode. MODE OFF: Control iPod from the unit. (Holding 4 / ¢ skips songs at 10% * Y o u
Resumo do conteúdo contido na página número 13
About the USB device ■■ ■■ This unit can play audio files stored on a Connecting a cable whose total length USB mass storage class device. is longer than 5 m can result in abnormal ■■ Install the USB device in the place where playback. ■■ it will not prevent you from driving your This unit cannot recognize a USB device vehicle properly. whose rating is other than 5 V and exceeds ■■ You cannot connect a USB device via a USB 500 mA. ■■ hub or multi card reader. When connecting the USB device,
Resumo do conteúdo contido na página número 14
Getting Started of Bluetooth PAR VOICE iPod Press and hold to pairing mode. code. Refer to [PIN CODE EDIT] under Registering your Bluetooth device (page 21). with this unit (Pairing) 5 “(device name)” is displayed. Press the 1 Press and hold to enter pairing mode volume knob. “PAIRING” is displayed. 6 The receiver is connected to a Bluetooth ■■ Any of the following is displayed device, with “HF CONNECT” or “AUD depending on Bluetooth device CONNECT” displayed, and exits
Resumo do conteúdo contido na página número 15
6 Press the volume knob to set up the Registering from Bluetooth devices Bluetooth device. (Pairing) ■■ “ ✱H ✱A (device name)”: The selected 1 Press SRC to turn on the power. Bluetooth device is busy. 2 Start registering this unit by operating ■■ “-H-A (device name)”: The selected the Bluetooth device. Bluetooth device is on standby. By operating the Bluetooth device, register ■■ “(blank) (device name)“: The Bluetooth the hands-free unit or audio unit (pairing). device is deselected. Se
Resumo do conteúdo contido na página número 16
Operation of Hands-Free Phoning Preparation : You need to register your cell-phone before using it with this unit. (page 14) Built-in microphone PAR VOICE iPod ■■ ■■ Press to enter Bluetooth mode. Press and hold to memorize the current phone ■■ Press to answer an incoming call. number. ■■ Press briefly to recall memorized phone number. ■■ To move to the next row, press 4 / ¢. Making a Call ■■ To return to the Phone Book mode, press 1 Press to enter Bluetooth mode. . 2 Turn the volume knob to
Resumo do conteúdo contido na página número 17
– Deleting all entries : “DELETE ALL” is 3 Press and hold number button (1 – 6). displayed. Press the volume knob. Make a Voice Dialing Call Turn the volume knob to select “YES”, You can make a voice call using the voice then press to confirm. recognition function of your cell-phone. 3. Press the volume knob. “COMPLETE” is 1 Press and hold the volume knob to start displayed. voice recognize. 4. Press the volume knob to return to Phone “VOICE TAG” is displayed. Book operation. 2 Pronounce
Resumo do conteúdo contido na página número 18
To download from the cell-phone manually Switching between Two Connected Use this procedure when your cell-phone Cell-phones does not support the Phone Book Access 1 Press to enter Bluetooth mode. Property (PBAP). 2 Press and hold . 1 Press to enter Bluetooth mode. ■■ You cannot switch between the connected 2 Turn the volume knob to select cell-phones during downloading of the [SETTINGS], then press to enter. Phone Book. 3 Turn the volume knob to select ■■ Only the main cell-phone f
Resumo do conteúdo contido na página número 19
Listening to a Bluetooth Audio Preparation : You need to register your audio player before using it with this unit. (page 14) PAR VOICE iPod ■■ Press to pause. Press again Press to select file. ■■ to resume playback. Press and hold to fast- forwards/fast-backwards. Selecting Repeat Play 1 Press SRC to select “BT AUDIO”. Press number button 4 (REP) repeatedly 2 Press 4 / ¢ to selects a file. ■■ to make a selection. Bluetooth audio players that do not support FILE REPEAT, REPEAT OFF AVRCP (Aud
Resumo do conteúdo contido na página número 20
Bluetooth Setup 3 Start registering this unit by operating Selecting the Bluetooth Device the Bluetooth device. 1 Press to enter Bluetooth mode. By operating the Bluetooth device, register 2 Turn the volume knob to select the hands-free unit or audio unit (pairing). [SETTINGS], then press to enter. Select “KENWOOD BT CD/R-5T1” from the 3 Turn the volume knob to select list of found units. [PAIRING], then press to enter. 4 Input the PIN code (“0000”) in the 4 Turn the volume knob to sele
