Manual do usuário JBL PROCOUSTICS MS-2

Resumo do conteúdo contido na página número 1

®
JBl Procoustics Ms-2
car audio optimizer
o wner ’s Manual
BoX contents
In
Pwr Sub
DEFEAT
6-ft (1.8m) Audio Cable
TREBLE
–3 0 +3
IMPACT
0 +3 +6
BASS
IntroductIon
0 +3 +6
IMAGE
Off On
®
Thank you for your purchase of the JBL ProCoustics MS-2 car audio optimizer.
3-ft (0.9m) Audio Cable
SETUP
We have designed the MS-2 to dramatically improve the sound of portable
OK High Low
audio devices in your vehicle, and to be quick and easy to connect, set up
and use.
This owner’s manual contains all th

Resumo do conteúdo contido na página número 2

Vehicle Audio System connectIons – OR – MS-2 Cigarette Lighter/ To Aux 12V Power Outlet Input To Headphone Output Power Supply Connector To 12V Power Outlet Audio Input Connector Audio Output Connector Portable 6V Music Player Stereo Power Supply 3-ft (0.9m) 3.5mm-to-RCA (supplied) Audio Cable AudioACable (not supplied) 3-ft (0.9m) (supplied) Audio Cable (supplied) 2

Resumo do conteúdo contido na página número 3

Impact control and indicators: Press the Impact control to add midbass controls and IndIcators punch to the sound (such as the fullness of drums or the upper frequencies of a bass guitar). The impact setting may also affect the sound of male Input Indicator vocals. The indicators show the setting. Power Indicator Sub Indicator Bass control and indicators: Press the Bass control to boost the bass (such as low-frequency sounds from bass guitar and bass drum). Two levels Defeat Button of bass

Resumo do conteúdo contido na página número 4

DISTRACTION WARNING: Do NOT perform the setup procedure while driving. We recommend that you perform these functions only after pulling off the road into a position that you are absolutely sure presents no risk. Always obey all traffic laws while driving. 6" – 8" (150mm – 200mm) setup Procedure: 1. Connect the MS-2 as shown in the Connections section on page 2. 2. Enable your vehicle audio system’s “Aux” (or MP3) input. 3. Set your portable audio player’s volume level to 3/4 full or higher a

Resumo do conteúdo contido na página número 5

using the Ms-2 with a Powered subwoofer: standby and on Modes The MS-2 will automatically enter Standby mode whenever no control 1. Press and hold the Bass button for five seconds. Sub LED lights buttons have been pressed and an audio signal has not been present for The Sub indicator light will turn on. approximately five minutes. All indicators will be off and the Power indicator will pulse red. The MS-2 will automatically turn on whenever an audio signal 2. Set your subwoofer’s crossove

Resumo do conteúdo contido na página número 6

This device complies with Part 15 of the FCC rules and RSS-210 of Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) this device must accept any interference received, including interference that may cause undesired operation. FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These