Manual do usuário Sanus Systems Accurate A/V Stand AFV48B

Resumo do conteúdo contido na página número 1

Assembly Instructions for Model: AFV48
Thank you for choosing the Sanus AFV48. If you do not
DO NOT EXCEED
understand these directions, or have any doubts about 200 lbs
90.9 kg WEIGHT LIMITS!
the safety of the installation, please contact Sanus at
800.359.5520 or www.sanus.com. Check carefully to make
sure that there are no missing or defective parts. Our
200 lbs
customer service representatives can quickly assist you
90.9 kg
with installation questions and missing or damaged parts.
Repla

Resumo do conteúdo contido na página número 2

Step 1: Foot Assembly Diagram 1 A Thread a Foot (K) into each 3” Pillar (E). Thread a Shelf Connector (A) into the other end of the 3” Pillar (E) until tight. E Repeat this process for each remaining 3” Pillar. K Step 2: Add Bottom Shelf Insert each Foot Assembly from Step 1 through the Bottom Shelf (I) as shown in Diagram 2. Diagram 2 I Foot Assembly Step 3: Add 9” Pillars Thread a 9” Pillar (G) onto each exposed Shelf Connector (A) until tight. Thread a Shelf Connector (A) into the top of t

Resumo do conteúdo contido na página número 3

Step 4: Add Middle Shelf Place the Middle Shelf (I) on the 9” Pillars (G). A Shelf Connector (A) should be protruding above the Middle Shelf at each corner. Place two Top Bolts (B) through the Middle Shelf (I) and thread them into both middle 9” Pillars (G) as shown in Diagram 4. Using the Allen Key (L), tighten both Top Bolts (B). Diagram 4 B I A G Step 5: Add 7” Pillars Thread and hand tighten a 7” Pillar (F) onto each exposed Shelf connector (A). Press a Grommet (D) into each wire management

Resumo do conteúdo contido na página número 4

Step 6: Add Top Shelf Place the Front Brace (J) on the two front 7” Pillars (F) as shown in Diagram 6 and Detail A. Place the Top Shelf (H) (with its curved edge towards the front) on the Front Brace (J), and 7” Pillars (F) as shown in Diagram 6. Insert two Top Bolts (B) through the holes in the Top Shelf (H), Front Brace (J) and two front 7” Pillars (F) as shown in Diagram 6 and Detail A. Place a Spacer (C) on both rear 7” Pillars (F) as shown in Diagram 6 and Detail B. Insert two Top Bolts (