Manual do usuário JL Audio Stealthbox SB-F-RTRKCTR/12W3v2-D2

Resumo do conteúdo contido na página número 1

®
Stealthbox
INSTALLATION GUIDE
START
for the HERE
SB-F-RTRKCTR/12W3v2
➔ ➔
➔
Rear Console Only
(Fits 2002-Up Ford SuperCrew
Harley Davidson, King Ranch;
2001-2002 Lincoln Navigator and
2002 Blackwood )
STEP 1: Remove front exposed pocket, STEP 2: With an 8mm socket and long STEP 3: Remove the pair of bolts from side
internal instert and rubber flooring. extenstion, remove the four bolts. Located rear of the OEM console.
where the front pocket was removed from in
You will have to lower the two

Resumo do conteúdo contido na página número 2

➔ ➔ Cont. From Page 1 ➔ ➔ ➔ ➔➔ ➔ ➔ ➔ STEP 7: Position the Stealthbox into location. STEP 9: With factory console outside truck, STEP 11: With lid removed, this will allow STEP 12: Remove the four screws from Hand tighten front of Stealthbo;, using the remove the four 8mm bolts from bottom of access to a pair of T-15 Torx bolts. Remove sides of the structure support. Remove the supplied pair of1” sapcers, pair of lock washers, console. these T -15 T orx head bolts. structure support from outside

Resumo do conteúdo contido na página número 3

Cont. From Page 2 ➔ ➔ ➔➔ STEP 16: Use masking tape to mark cutting IMPORTANT!!!! IMPORTANT!!!! STEP 17: A) Line up small angle bracket to front template. middle of OEM inner(cut) console and mark hole. A) Cut 1 1/2” under lip.Where there is no B) Where there is a ledge/reinforcement cut IMPORTANT!!!! Please read STEP 16 A and ledge/reinforcement 1 5/16” under the ledge/reinforcement. B before cutting. Using a suitable saw to cut OEM inner console. ➔ ➔➔ ➔ STEP 17: B) Using an 1/8” drill bit, dri

Resumo do conteúdo contido na página número 4

Cont. From Page 3 CONGRATULATIONS! INSTALL COMPLETE. ➔ ➔➔➔ Included Hardware: 1) Black Pop Rivet 1) #4 Steel Flat Washer STEP 21: Mount lid strap using the STEP 22: With OEM outer console, OEM STEP 23: Repalce front pocket that was removed 1) Small Angle Bracket “7th” T -15 T orx bolt. inner cut console and hinged lid mounted. in STEP 1 and close the lid. 1) #8x1/2” Pan Head Screw Look in the lid latch catch, located on the 2) 1/4” Flat Washers front of OEM inner console.You will see the 2) 1/4