Manual do usuário JL Audio Slampak SLPK-POL-RZR800

Resumo do conteúdo contido na página número 1

SB-POL-RGRRZR INSTR_SKU# 94456
Installat Ion

d I F F I C u l t Y :

Slampak
If you choose to perform the installation yourself, it is absolutely vital that the
®
out
Slampak be properly mounted to the vehicle according to these instructions.
o F
Failure to mount the enclosure properly presents two problems:
I n s t a l l a t I o n G u I d e
for the 1) The sub-bass performance will suffer due to the movement of the enclosure
25
caused by the force exerted by the woofer(s).
SB-POL-RG

Resumo do conteúdo contido na página número 2

SB-POL-RGRRZR INSTR_SKU# 94456 s t e P 4 S t e P 8 once both compression clamps are in place, fold the lever Looking back from the front, run the cabling through this down and insert the locking pin. access hole near the floor and, secure it as shown in the DETAIL picture below. s t e P 5 D e t a i l This is seen from the rear wheel looking up and to the front, notice the expansion clamp inserted from below going up into the enclosure from below. This will be done on each side then the

Resumo do conteúdo contido na página número 3

SB-POL-RGRRZR INSTR_SKU# 94456 s t e P 1 1 s t e P 1 4 As you run the cable up under the hood, take precautions Hook up the power and, ground, securing the fuse block to to remain close to the OEM harness securing the two har- the cabling with the supplied zip-ties. nesses together with zip ties as shown to ensure that there is no slack and, that the cables avoid an moving parts of the vehicle such as the steering components shown. s t e P 1 2 s t e P 1 5 Looking towards the “firewall” from t