Manual do usuário Invacare 5143B

Resumo do conteúdo contido na página número 1

Service Manual
DEALER: Keep this manual. The procedures in this manual MUST
be performed by a qualified technician.
84 inch Bed Extension (5143B)
1 General
Check all parts for shipping damage. In case of damage, DO NOT use. Contact Carrier/Invacare for
further instructions.
To ensure the safe installation of the crossover cable service kit, these instructions must be followed:
1.1 Symbols
Signal words are used in this manual and apply to hazards or unsafe practices which could result in
perso

Resumo do conteúdo contido na página número 2

1.4 General Warnings Safety WARNING  DO NOT use this product or any available optional equipment without first completely reading and understanding these instructions and any additional instructional material such as owner’s manuals, service manuals or instruction sheets supplied with this product or optional equipment. If you are unable to understand the warnings, cautions or instructions, contact a healthcare professional, dealer or technical personnel before attempting to use this equip

Resumo do conteúdo contido na página número 3

3. Separate link fabric by raising the head end and disengage the open end hooks that secure the head and foot springs together. I L H I J J K K 4. From the head end (H), lift up on the bed frame (I) and disengage the rivets (J) on the corner plates out of the corner locks (K) of the head end of bed. 5. From the foot end (L), lift up on the bed frame (I) and disengage the rivets (J) on the corner plates out of the corner locks (K) of the foot end of bed. 6. Lay bed on side and rotate head and

Resumo do conteúdo contido na página número 4

D F I A H 6. Attach second helical spring (F) to the mounting hole (H) into the four inch extension (A) on other side of bed frame. 7. Using vise grips (I), secure the helical spring (F) to the link fabric extension (D). J D C 8. To connect the link fabric extension (D) to the head spring (J), manually raise the head spring and attach open-end hooks (C) to the head spring. Make sure open end of hooks (C) are positioned down towards the ground/floor.  9. Attach bed ends to head and foot spring

Resumo do conteúdo contido na página número 5

M Assembled View M O N 11. Remove existing pull tube (M) in head motor assembly or head crank assembly 12. Install pull tube furnished with this kit in the following manner: • For beds equipped with AC motors, use the first spring button (N) • For beds equipped with DC motors, use the second spring button (O). E F,G 13. Reconnect pull tube (E) to head spring drive arm using the clevis (G) and cotter (F) pins. Bed requires an 84-inch mattress.  If assistance is required or any problems are encou

Resumo do conteúdo contido na página número 6

NOTES 84 inch Bed Extension (5143B) 6 Part No 53000M701

Resumo do conteúdo contido na página número 7

NOTES Part No 53000M701 7 84 inch Bed Extension (5143B)

Resumo do conteúdo contido na página número 8

Invacare Corporation www.invacare.com USA © 2011 Invacare Corporation. All rights One Invacare Way reserved. Republication, duplication or Elyria, Ohio USA modification in whole or in part is 44036-2125 prohibited without prior written 440-329-6000 permission from Invacare. Trademarks are 800-333-6900 identified by ™ and ®. All trademarks are Technical Services owned by or licensed to Invacare 440-329-6593 Corporation or its subsidiaries unless 800-832-4707 otherwise noted. Part No 5300