Resumo do conteúdo contido na página número 1
LB510A-R2
10BASE-T/100BASE-TX G.SHDSL Two-Wire Extender/NTU
Extend corporate LAN-to-WAN communications at higher speeds
or at a longer distance.
Resumo do conteúdo contido na página número 2
Black Box G.SHDSL.bis EFM CPE TABLE OF CONTENTS 1. GENERAL INFORMATION .........................................................................9 1.1 Features ..............................................................................................9 1.2 Description.......................................................................................... 9 1.3 Power Input Connector ..................................................................... 10 1.3.1 External AC universal power s
Resumo do conteúdo contido na página número 3
Table of Contents 5.1 Establishing a Remote Console Session .......................................... 29 5.1.1 How to Connect .....................................................................29 5.1.2 How to Disconnect................................................................. 31 5.1.3 Differences in local and remote control session behavior ...... 31 6. SOFTWARE UPGRADE ........................................................................... 32 7. RESET CONFIGURATION TO FACTORY DE
Resumo do conteúdo contido na página número 4
Black Box G.SHDSL.bis EFM CPE C.1 Line Port ...........................................................................................39 C.1.1 RJ-45........................................................................................39 C.2 ETHERNET PORT............................................................................39 C.2.1 RJ-45 socket 10/100Base-T.....................................................39 Page 4 724-746-5500 | blackbox.com
Resumo do conteúdo contido na página número 5
RADIO FREQUENCY INTERFERENCE STATEMENTS RADIO FREQUENCY INTERFERENCE STATEMENTS FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication. It has been tested and found to comply with the limits for a Class A computing device in accord
Resumo do conteúdo contido na página número 6
Black Box G.SHDSL.bis EFM CPE INSTRUCCIONES DE SEGURIDAD (Normas Oficiales Mexicanas Electrical Safety Statement) 4. Todas las instrucciones de seguridad y operación deberán ser leídas antes de que el aparato eléctrico sea operado. 5. Las instrucciones de seguridad y operación deberán ser guardadas para referen- cia futura. 6. Todas las advertencias en el aparato eléctrico y en sus instrucciones de oper- ación deben ser respetadas. 7. Todas las instrucciones de operación y uso debe
Resumo do conteúdo contido na página número 7
INSTRUCCIONES DE SEGURIDAD 17.El equipo eléctrico debe ser limpiado únicamente de acuerdo a las recomenda- ciones del fabricante. 18.En caso de existir, una antena externa deberá ser localizada lejos de las lineas de energia. 19.El cable de corriente deberá ser desconectado del cuando el equipo no sea usado por un largo periodo de tiempo. 20.Cuidado debe ser tomado de tal manera que objectos liquidos no sean derrama- dos sobre la cubierta u orificios de ventilación. 21.Servicio
Resumo do conteúdo contido na página número 8
Black Box G.SHDSL.bis EFM CPE SAFETY WHEN WORKING WITH ELECTRICITY • This device contains no user serviceable parts. This device can only be repaired by qualified service personnel. Do not open the device when the power cord is connected. WARNING For systems without a power switch and without an external power adapter, line voltages are present within the device when the power cord is connected. For devices with an external power adapter, the power adapter shall be a listed Limited Po
Resumo do conteúdo contido na página número 9
In accordance with the requirements of council directive 2002/96/EC on Waste of Electrical and Electronic Equipment (WEEE), ensure that at end-of-life you separate this product from other waste and scrap and deliver to the WEEE col- lection system in your country for recycling. This device contains no user serviceable parts. This device can only be repaired by qualified service personnel. WARNING This device is NOT intended nor approved for connection to the PSTN. It is intended only for
Resumo do conteúdo contido na página número 10
Black Box G.SHDSL.bis EFM CPE 1. GENERAL INFORMATION Thank you for your purchase of this Black Box product. This product has been thor- oughly inspected and tested and is warranted for one year for parts and labor. If any questions or problems arise during installation or use of this product, contact Black Box Technical Support at 724-746-5500 or info@blackbox.com. 1.1 FEATURES Symmetrical high data-rate DSL (G.SHDSL) Data rates up to 5.69 Mbps 10/100 Ethernet port for management a
Resumo do conteúdo contido na página número 11
Figure 1. LB510A-R2 1.3 POWER INPUT CONNECTOR The LB510A-R2 comes with an AC or DC power supply. (See Appendix A.7 on page 36.) The power connection to the CPE is a 2.5 mm barrel receptacle with the center con- ductor positive (see figure 2). Rated voltage: 5 VDC Rated current: 1 A 5 VDC Figure 2. Power connection barrel receptacle 5 VDC diagram 1.3.1 External AC universal power supply Output from power supply: 5 VDC, 2 A Input to power supply: universal input 100-240 VAC 50/60 Hz
Resumo do conteúdo contido na página número 12
Black Box G.SHDSL.bis EFM CPE 1.3.2 External 48 VDC power supply The external DC adaptor shall be a listed limited power source that incorporates a disconnect device and shall be positioned within easy reach of the operator. The interconnecting cables shall be rated for the proper voltage, current, anticipated temperature, CAUTION flammability, and mechanical serviceability. Input: Rated voltage: 36–60 VDC Rated current: 0.25 A DC 3-pin locking connector, 3.5 mm pitch Transient
Resumo do conteúdo contido na página número 13
Configuration hardware (DIP-switch)-configuration mode. In DIP-switch-configuration mode the device will read the DIP-switch settings during system startup and configure itself according to the switch settings. Once you power-up the LB510A-R2 in DIP-switch mode, it will operate in DIP-switch mode until powered down. When operating in DIP- switch mode you cannot change any configuration settings: Changing the DIP switch settings while the device is running requires the dsl start command.
Resumo do conteúdo contido na página número 14
ETH 0 ETH 1 ETH 2 ETH 3 Power DSL Black Box G.SHDSL.bis EFM CPE 2.3 CONFIGURING THE DIP SWITCHES The LB510A-R2 is equipped with three sets of DIP switches, which you can use to configure the modem for a broad range of applications. This section describes switch locations and discusses the configuration options available. NOTE: By default, the LB510A-R2’s DIP switches are all set to “OFF” so the CPE can be configured via G.SHDSL.bis EFM DSLAM. If that is how you will be configuring the CPE,
Resumo do conteúdo contido na página número 15
ON ON OFF 1 2 3 4 5 6 7 8 Configuration The three sets of DIP switches on the underside of the LB510A-R2 are referred to as S1, S3 and S4. For basic configuration, use DIP switch S1. For testing the LB510A-R2, use DIP switch S3. To con- figure the rate, use DIP switch S4. This figure shows the DIP switch orientation, with respect to ON and OFF positions, is consis- tent for all switches. 2.4 SYSTEM RESET MODE To enter system reset mode, turn the S1-1 DIP switch to the ON position and power c
Resumo do conteúdo contido na página número 16
Black Box G.SHDSL.bis EFM CPE Position Function Settings ON - Ethernet Port 0 is used for Ethernet Port 0 Management management S1-5 (Eth 0 is used for management OFF - Any port can be used for only) management (if S1-4 is also OFF) ON - Annex B S1-6 Annex OFF - Annex A S1-7 Reserved Reserved ON - CO S1-8 DSL Mode OFF - CPE Table 3: LB510A-R2 S3 DIP-Switch functions (test modes and patterns) Position Function S3-1 S3-2 Reserved S3-3 S3-4 S3-5 511e Pattern S3-6 511 Pattern S3-7 Test Mode Remot
Resumo do conteúdo contido na página número 17
S4-2 S4-3 S4-4 S4-5 S4-6 S4-7 S4-8 Data Rate (kbps) OFF OFF OFF ON OFF OFF ON 704 OFF OFF OFF ON OFF ON OFF 768 OFF OFF OFF ON OFF ON ON 832 OFF OFF OFF ON ON OFF OFF 896 OFF OFF OFF ON ON OFF ON 960 OFF OFF OFF ON ON ON OFF 1024 OFF OFF OFF ON ON ON ON 1088 OFF OFF ON OFF OFF OFF OFF 1152 OFF OFF ON OFF OFF OFF ON 1216 OFF OFF ON OFF OFF ON OFF 1280 OFF OFF ON OFF OFF ON ON 1344 OFF OFF ON OFF ON OFF OFF 1408 OFF OFF ON OFF ON OFF ON 1472 OFF OFF ON OFF ON ON OFF 1536 OFF OFF ON OFF ON ON ON 16
Resumo do conteúdo contido na página número 18
Black Box G.SHDSL.bis EFM CPE S4-2 S4-3 S4-4 S4-5 S4-6 S4-7 S4-8 Data Rate (kbps) OFF ON OFF ON OFF ON OFF 2816 OFF ON OFF ON OFF ON ON 2880 OFF ON OFF ON ON OFF OFF 2944 OFF ON OFF ON ON OFF ON 3008 OFF ON OFF ON ON ON OFF 3072 OFF ON OFF ON ON ON ON 3136 OFF ON ON OFF OFF OFF OFF 3200 OFF ON ON OFF OFF OFF ON 3264 OFF ON ON OFF OFF ON OFF 3328 OFF ON ON OFF OFF ON ON 3392 OFF ON ON OFF ON OFF OFF 3456 OFF ON ON OFF ON OFF ON 3520 OFF ON ON OFF ON ON OFF 3584 OFF ON ON OFF ON ON ON 3648 OFF ON
Resumo do conteúdo contido na página número 19
S4-2 S4-3 S4-4 S4-5 S4-6 S4-7 S4-8 Data Rate (kbps) ON OFF OFF ON ON OFF OFF 4992 ON OFF OFF ON ON OFF ON 5056 ON OFF OFF ON ON ON OFF 5120 ON OFF OFF ON ON ON ON 5184 ON OFF ON OFF OFF OFF OFF 5248 ON OFF ON OFF OFF OFF ON 5312 ON OFF ON OFF OFF ON OFF 5376 ON OFF ON OFF OFF ON ON 5440 ON OFF ON OFF ON OFF OFF 5504 ON OFF ON OFF ON OFF ON 5568 ON OFF ON OFF ON ON OFF 5632 ON OFF ON OFF ON ON ON 5696 2.6 ETHERNET MANAGEMENT PORT The LB510A-R2 offers a 10/100 Ethernet port for configuration and
Resumo do conteúdo contido na página número 20
Black Box G.SHDSL.bis EFM CPE DSL Sync State: Out of Sync, Acquiring Sync, In Sync, or Losing Sync. NOTE: DSL Link State vs. DSL Sync State—The DSL link state describes whether the DSL is training (in progress), linked (success), deactivated (we don’t have an option to deactivate the modem, so the user should not see this), or idle. The DSL sync state describes whether no sync words have been found (out of sync), there are no sync word errors (in sync), or whether we are transitioning from
