Manual do usuário UNICOM Electric MICROGST-8

Resumo do conteúdo contido na página número 1

MicroGST-5
MicroGST-8
5 or 8 Port 10/100/1000Base-T
Desktop Switch
MicroGST-5 GEP-32005T-1
MicroGST-8 GEP-32008T-1
908 Canada Court
City of Industry, CA 91748 U.S.A.
Phone: 626.964.7873 or 800.346.6668 Fax: 626.964.7880
www.unicomlink.com e-mail: info@unicomlink.com
USER’S MANUAL
©UNICOM 2009. UNICOM and “A Network Systems Solution” are trademarks of UNICOM Electric, Inc.
All rights reserved. Specifications subject to change without notice.
Rev: 10.09

Resumo do conteúdo contido na página número 2

Resumo do conteúdo contido na página número 3

The information in this guide may be changed without notice. The manufacturer assumes no 1. Introduction responsibility for any errors which may appear in this guide. Ethernet is a trademark of XEROX Corporation. Microsoft, Windows and Windows logo are trademarks of Microsoft Corporation. Thank you for purchasing Unicom’s MicroGST-5 or MicroGST-8 Desktop Copyright 2009. All right are reserved. No Part of the contents of this guide maybe transmitted or Gigabit Switch. Before you start installing

Resumo do conteúdo contido na página número 4

2. Installation 4 Technical Specifications This chapter describes the function of the switch components and
MicroGST-5 (5-Port 10/100/1000T switch) shows how to install it on your network. Basic knowledge of networking Ports 5-Port 1000Base-T Buffer Memory 104 KB is assumed. Read this chapter completely before installation. MAC Address 1000 Jumbo Frame 9 KB Size (W x D x H) Metal case: 109 x 84 x 27 (mm) Plastic case: 120 x 84 x 32 (mm) 2.1 Front View and LEDs Weight Metal case: 0.48 kg Figure

Resumo do conteúdo contido na página número 5

wires of 1,2,3,6 are reversed so that wire 1 become 3 at the other end 2.2 Rear View of the cable, 2 becomes 6, and so forth. Figure 2.1-1 illustrates the rear panel of the MicroGST-5 Switch; To determine which wire is wire 1, hold the RJ-45 plug with the spring Figure 2.1-2 illustrates the rear panel of the MicroGST-8 Switch. clip facing towards the ground and the end pointing away from you. The Table 2.2-1 shows the port function of both switches. copper wires exposed upwards to your view. The

Resumo do conteúdo contido na página número 6

2.3 Installing the switch 3. Specifications The MicroGST-5 and 8 Switches do not need software configuration. To install the switches, simply complete the following steps: 3.1 Cable Specifications
Table 3-1 lists the cables you can use and their specifications. Step 1 Select a location for your switch.
Put the switch on a sturdy surface. Caution:
Please do not use telephone cables. Telephone cables do not support Keep enough ventilation space between the switch and the Ethernet or Fast Eth