Manual do usuário GE IMRSEN-W12

Resumo do conteúdo contido na página número 1

Catalog Number: RSEN-W12
Total Lighting Control
Line-voltage Wall Switch Occupancy Sensor
DESCRIPTION AND OPERATION
The RSEN-W12 is a self-contained motion-sensing
lighting control which replaces a conventional wall
switch for energy savings and convenience. Lights turn
off automatically after a room is vacated.
Built-in sensors produce low intensity, inaudible sound and
detect changes in sound waves caused by motion, such as
walking into the room, reaching for a telephone, turning in a
chair. T

Resumo do conteúdo contido na página número 2

Catalog Number: RSEN-W12 INSTALLATION Coverage Sensor Coverage The RSEN-W12 is designed for offices or small rooms up to 1 300 square feet. Although total coverage of minor motion is ⁄2 STEP WALK COVERAGE 450 square feet, wall switches are normally mounted off-center MOTION-AT-DESK COVERAGE in a room which reduces the coverage attainable. SENSOR Basic Installation Steps 20 24 1. Turn off power at the circuit breaker. (6.1) (7.3) 2. Wire and mount the switch in standard junction box. 3. Restore p

Resumo do conteúdo contido na página número 3

Catalog Number: RSEN-W12 INSTALLATION (CONTINUED) Checkout and Adjustment Sensor Wiring Once installation is complete, restore power to the lighting 120 VAC OR 277 VAC circuit. Proper operation of the RSEN-W12 must be verified. Adjustments should be made with the HVAC system on. NEUTRAL Use only insulated tools to make adjustments. LOAD 1 LOAD 2 1. Adjustment controls are under the touchplate. “Time LOAD 1 LOAD 2 SWITCH LEG SWITCH LEG Delay” ranges from 15 seconds (for testing) to 30 minutes. Us

Resumo do conteúdo contido na página número 4

Catalog Number: RSEN-W12 Emergency Service or Support (888) 852-2778 TROUBLESHOOTING Emergency Manual ON An override jumper is located underneath the touchplate. This jumper should remain in place at all times, except in the event of unit malfunction. Remove the jumper to bypass the sensor and turn the lights on. LED Will Not Go On Verify that the lighting circuit has power. Verify that the sensor is properly adjusted. Press the touchplate to turn on the lights manually. If the LED does not ligh