Resumo do conteúdo contido na página número 1
cr cr
System 5cr cr cr
System Switcher
68-388-01
Printed in the USA
Resumo do conteúdo contido na página número 2
Precautions Safety Instructions • English Warning Power sources This equipment should be operated only from the power source indicated on the This symbol is intended to alert the user of important operating and maintenance product. This equipment is intended to be used with a main power system with a grounded (servicing) instructions in the literature provided with the equipment. (neutral) conductor. The third (grounding) pin is a safety feature, do not attempt to bypass or This symbol is inte
Resumo do conteúdo contido na página número 3
QUICK START FOR SYSTEM 5cr cr cr cr cr SWITCHER Connections S-video 1. Rear Panel Inputs PC2 and PC3 – Connect RGBS/ RGBHV sources, such as from Computer-Video Interfaces. Connect Audio if available. 2. Rear Panel Inputs S-video VID1 & VID2 – Connect S-video Composite Video or S-video sources and Audio, if available. (Use Setup and then procedure “b” below to select Composite or S-video.) 3. Outputs – Connect RGBS/RGBHV, S-video and Composite Video to the Display Device (Projector), as required
Resumo do conteúdo contido na página número 4
Contents Chapter One Introduction to System 5cr cr cr cr cr What is a System 5cr Switcher? ................................................................................................. 1-1 Controlling the System ................................................................................................... 1-1 Infrared learning for System Control .............................................................................. 1-2 Standard Features ........................................
Resumo do conteúdo contido na página número 5
System 5cr Switcher User’s Manual Chapter One cr cr Introduction to System 5cr cr cr What is the System 5cr ? Control of the Entire A/V System Infrared Learning Features & Options 1 Specifications
Resumo do conteúdo contido na página número 6
Introduction and Features Chapter 1 What is a System 5cr cr cr cr cr Switcher? Throughout this manual, the terms System 5 and System 5cr are both used to refer to the same product. The System 5 provides central control for small audio/video installations. The five inputs accept video formats from composite, S-video and computer-video sources, together with line-level audio. In addition to being a video/audio switcher, the System 5 combines the functions of several devices, including projector
Resumo do conteúdo contido na página número 7
Chapter 1 Introduction and Features Infrared Learning for System Control The IR receiver window on the front panel also serves as a learning port to add IR signals from other sources to the System 5 panel functions. Then, when a panel function is selected, the learned IR signal is transmitted into the room through the hard-wired IR emitter, or the optional IR Broadcaster, to be received by the projector. IR commands for the projector can be associated with each of the Display buttons (Power, M
Resumo do conteúdo contido na página número 8
Introduction and Features Chapter 1 Options and Accessories The System 5 is more than just a system switcher. Standard and optional features make it the control center for a small A/V system by adding control of other things in the room as part of the system design. Two of these standard features include: Room control allows for relay control of lights, window coverings, display screen, or most anything the system designer wants to use it for. An IR transmitter distributes all incoming IR
Resumo do conteúdo contido na página número 9
Chapter 1 Introduction and Features Specifications Video input Number/type _ 3 RGBHV/RGBS/RGsB computer video _ 2 S-video or composite video Connectors _ 1 15-pin HD female (RGB computer video) _ 2 x 5 BNC female (RGB computer video) _ 2 x 2 BNC female (S-video or composite video) Nominal level(s) _ Analog — 0.3 to 1.45V p-p Maximum level(s) _ Analog — 2.0V p-p Impedance _ 75 ohms Horizontal frequency _ 15 kHz to 150 kHz Vertical frequency _ 30 Hz to 150 Hz Return loss _ -45dB @ 5 MHz Maximu
Resumo do conteúdo contido na página número 10
Introduction and Features Chapter 1 Audio throughput Gain _ -78dB to +40dB Frequency response _ ±0.05dB @ 20 Hz to 20 kHz THD + Noise _ < 0.1% @ 1 kHz, at rated maximum output S/N _ >95dB, 21dBu output Adjacent input crosstalk _ >80dB @ 1 kHz Stereo channel separation _ >90dB @ 1 kHz Total harmonic distortion _ 0.03%, worse case, @ 1 kHz at rated preamp drive CMRR _ >75dB @ 20 Hz to 20 kHz Audio output — preamp Number/type _ 1 stereo, balanced/unbalanced Connectors _ 1 3.5 mm captive screw te
Resumo do conteúdo contido na página número 11
System 5cr Switcher User’s Manual Chapter Two Rear Panel Connections Mounting – Table or Rack Input Connections Output Connections Connecting Accessories 2
Resumo do conteúdo contido na página número 12
Making Connections Chapter 2 Installation in a Rack, on a Wall or Under a Table The System 5cr comes with two sets of mounting brackets. One set is for mounting under a table or on a wall and the second set is for rack mounting. Either set is attached to the System 5 by four #8 screws. When mounted under a table on a wall, the bracket will extend approximately 1/4 inch above the top surface of the System 5 enclosure, as shown in Figure 2-1. This is designed to have an air space between the Sy
Resumo do conteúdo contido na página número 13
Chapter 2 • Making Connections Figure 2-2a. The left side of the rear panel has four of the five inputs. 6 PC1 input is on the Front Panel and accepts laptop video through a VGA connector as well as 2-channel audio through a 3.5 mm jack, as shown in Figure 2-2. With a buffered output, VGA signals can be driven up to 50 feet without additional amplification. Figure 2-3. PC1 Input is on the Front Panel. Audio Input Connections Connect balanced or unbalanced, 2-channel audio to the input connectors
Resumo do conteúdo contido na página número 14
Making Connections Chapter 2 _______ Although all three outputs may be connected at the same time, only one can be active at one time, as determined by the input format. In a typical installation, an LCD projector may have inputs for all three formats. In such cases, each of the three System 5 outputs would be connected to the same projector. 11 R, G, B, H/HV, V BNC connectors, for RGBS or RGBHV output. The green LED indicates when the selected input is RGB format (PC1, PC2 or PC3) and this o
Resumo do conteúdo contido na página número 15
Chapter 2 Making Connections Audio Preamp Out Connection Connect balanced or unbalanced, 2-channel audio to the Preamp Out connector marked L (Left) and R (Right), using a captive screw connector. Possible connections are shown in Figure 2-6. Connectors are included with each System 5, however, cables are the responsibility of the installer. Use the same procedure as for the audio input captive screw connectors. Figure 2-6. Audio Preamp Output can be connected three different ways. Connecting
Resumo do conteúdo contido na página número 16
Making Connections Chapter 2 3.5 mm, 5-pole captive screw connectors are used for the audio inputs and one output, as well as for accessories. These include: Aux1 & Aux2 – SCP 100 remote panels (2 optional) Relay – Room/relay custom control (standard feature) Comm – projector control through the standard IR Emitter or the optional IR Broadcaster. One three-contact stereo phono-type of connector is provided for the optional Display Power Sensor. This device detects when the projector pow
Resumo do conteúdo contido na página número 17
System 5cr Switcher User’s Manual Chapter Three cr cr Using the System 5cr cr cr Front Panel Controls & Indicators Configuration: Audio Preset, VID Formats & IR Learning 3
Resumo do conteúdo contido na página número 18
Operating the System 5cr Chapter 3 Using the System 5cr cr cr cr cr ________ In addition to the basic function of each of the panel buttons described here, there are also setup procedures that use many of the same buttons and controls. Each of the Input and Display buttons is capable of “learning” an IR command. The Display Power button must learn both power on and power off for the projector. The setup procedures are described later in this section. Front Panel Controls and Indicators On po
Resumo do conteúdo contido na página número 19
Chapter 3 Operating the System 5cr ________ As stated earlier, each input button can be programmed to “learn” an associated IR command. For example, selecting the PC1 input could also send a signal to the projector to switch to its computer input mode, and selecting VID1 could cause the projector to switch to S-video mode, etc. 3 PC Input Selection Buttons and Indicators: PC1 – Input select button for computer video and audio. This selects the input from the VGA and Audio connectors on the S
Resumo do conteúdo contido na página número 20
Operating the System 5cr Chapter 3 Configuration Setup from the Front Panel For the System 5 switcher to control other equipment in the A/V system, it must be configured from the front panel, or through an RS-232 device. This cannot be done from an IR 40 or SCP 100. See Chapter 4 for Windows® Control program and Appendix A for RS-232 instructions. Infrared Programs and Libraries Extron provides a library of drivers for most projectors. To download a driver from the library, see the procedure
