Resumo do conteúdo contido na página número 1
UX-B70 MICRO COMPONENT SYSTEM
5-CD
MICRO COMPONENT SYSTEM
UX-B70—Consists of CA-UXB70 and SP-UXB70
STANDBY/ON
13 2
VOLUME
46 5
DISPLAY
DISC
CLOCK/
SELECT AUX/DVD TREBLE 79 8
TIMER
FM/AM BASS
CD TAPE 10 +10 SLEEP
BASS DISC UP TREBLE
CD1 CD2 CD3 CD4 CD5
SET DISC DOWN CANCEL
3/8 23
CD TAPE FM/AM AUX
REV. CD REC
MODE REC MODE
PLAY FM
MODE REPEAT MODE
PTY
SEARCH A.STANDBY DIMMER AHB PRO
RDS
DISPLAY
PTY TA/News
SELECT /Info
5-CD CHANGER, PLAY&EXCHANGE
VOLUME
RM-SUXB70R REMOTE CONTROL
PHONES
INSTRUCTIO
Resumo do conteúdo contido na página número 2
Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug REPRODUCTION OF LABELS fitted is not suitable for the power points in your home or the cable 1 CLASSIFICATION LABEL ON EXTERIOR SURFACE is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonethele
Resumo do conteúdo contido na página número 3
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards, but like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
Resumo do conteúdo contido na página número 4
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging the unit from the wall outlet, always pull This manual is organized as follows: on the plug, not the AC power cord. • This manual mainly explains operations using the DO NOT handle the AC power cord
Resumo do conteúdo contido na página número 5
Contents Location of the Buttons and Controls ............................. 3 Front Panel ................................................................................ 3 Remote Control ......................................................................... 5 Getting Started .................................................................. 6 Unpacking ................................................................................. 6 Connecting Antennas .....................................
Resumo do conteúdo contido na página número 6
5-CD Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel r 1 t 2 3 4 y u 5 i 6 VOLUME o 7 DISC SELECT AUX/DVD TREBLE 8 ; FM/AM BASS CD TAPE 9 CD1 CD2 CD3 CD4 CD5 p q w 5-CD CHANGER, PLAY&EXCHANGE PHONES e Front panel See pages in parentheses for details. q Disc eject buttons (10, 17, 18) 1 (standby/on) button and STANDBY/ON lamp CD10, CD20, CD30, CD40, and CD50 (10, 21, 22, 28) • Pressing one of these buttons also turns on the unit and 2 R
Resumo do conteúdo contido na página número 7
Continued Display window on the front panel 1 2 345 679 8 0 - AHB PRO DAILY 1 2 3 4 5 AUTO STEREO SLEEP REC STANDBY MONO REC CD PRGM RANDOM CD ALL A - B TAPE Display window See pages in parentheses for details. 1 CD indicator (17) 2 Disc indicators (17) 3 Disc play mode indicators (19 – 21) • PRGM (program), RANDOM, and Repeat mode ( , CD, ALL, A-B) 4 TAPE indicator (22) indicator (22) 5 Tape operation indicators (22, 23) •2 3 (tape direction) and (reverse mode) 6 REC (recording) indicator
Resumo do conteúdo contido na página número 8
Remote Control See pages in parentheses for details. 1 Number buttons 2 BASS button (12) 3 Multi operation buttons • DISC UP and DISC DOWN •4, 7, and ¢ 4 SET button (13, 14, 21) 5 Source buttons STANDBY/ON •3¥8 CD, 2 3 TAPE, FM/AM, and AUX 13 2 Pressing one of these buttons also turns on the unit. p 6 REV.MODE button (22, 23) 46 5 DISPLAY 1 7 PLAY MODE button (19, 20) q CLOCK/ 79 8 8 RDS operation buttons (15, 16) TIMER w • PTY SEARCH, PTY SELECT 9 / (, RDS DISPLAY, 10 +10 SLEEP and TA/News/I
Resumo do conteúdo contido na página número 9
Getting Started Continued To connect an outdoor FM antenna Unpacking Before connecting it, disconnect the supplied FM antenna. After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each Outdoor FM antenna piece supplied. (not supplied) • FM antenna (1) • AM (MW) loop antenna (1) • Remote control (1) Coaxial cable (not supplied) • Batteries (2) If any item is missing, consult your dealer immediately. Connecting Antennas FM an
Resumo do conteúdo contido na página número 10
AM (MW) antenna Connecting Speakers To connect speakers You can connect the speakers using the speaker cords. 1 1 ANTENNA 2 3,4 Vinyl-covered wire (not supplied) SPEAKERS RIGHT LEFT 2 Speaker Speaker SPEAKER IMPEDANCE cord cord 6~16Ω AM (MW) loop antenna (supplied) 1 Connect the AM (MW) loop antenna to the AM LOOP terminals as illustrated. 2 Turn the AM (MW) loop antenna until you have the best reception. Right speaker Left speaker To connect an outdoor AM (MW) antenna 1 If the cords are cover
Resumo do conteúdo contido na página número 11
NOW you are ready to plug in the unit and any To remove the speaker grilles The speaker grilles are removable as illustrated below: other connected equipment. IMPORTANT: Holes Projections Be sure to check that all connections have been made before plugging in the power cord. Putting the Batteries into the Remote Control Insert the batteries—R6(SUM-3)/AA(15F)—into the remote control by matching the polarity (+ and –) on the batteries with the + and – marking on the battery compartment. When the r
Resumo do conteúdo contido na página número 12
Basic and Common Operations To change the clock Setting the Clock 1 Make sure the (timer) indicator and the timer mode Before operating the unit any further, first set the unit’s clock. indicator (DAILY or REC) are not lit on the display. When you plug in the power cord, “0:00” starts flashing on • If they are lit, press and hold CLOCK/TIMER until they the display. go off. You can set the clock when the unit is either turned on or in standby mode. 2 Press CLOCK/TIMER repeatedly until the unit e
Resumo do conteúdo contido na página número 13
Continued To turn off the unit automatically (Auto Standby) Turning On the Power Using the Auto Standby function, the unit automatically turns STANDBY/ON To turn on the unit, press STANDBY/ON itself off if no sound comes in for more than 3 minutes when (or on the unit). “CD” or “TAPE” is selected as the source. The STANDBY/ON lamp on the unit lights If an operation is done within this 3-minute period, the Auto green. Standby function is canceled temporarily even though no • When you press the
Resumo do conteúdo contido na página número 14
Adjusting the Volume Reinforcing the Bass Sound You can adjust the volume level only while the unit is turned The richness and fullness of the bass sound is clearly on. The volume level can be adjusted between maintained regardless of how low you set the volume “VOLUME MIN” and “VOLUME 1” – “VOLUME 40 —Active Hyper Bass Pro. (VOLUME MAX).” • This function also affects the sound from headphones. • The volume level has no effect on recording. • This function only affects the playback sound, and do
Resumo do conteúdo contido na página número 15
Adjusting the Tone Changing the Display Brightness You can adjust the bass level (low frequency range) and the You can change the display brightness only while the unit is treble level (high frequency range) within a range of “–5” to turned on. “+5.” When shipped, each level is set to “+2.” On the remote control ONLY: • This function also affects the sound from headphones. DIMMER Press DIMMER while the unit is turned on. • This function only affects the playback sound, and does not • Each time y
Resumo do conteúdo contido na página número 16
Listening to FM and AM (MW) Broadcasts Tuning in to a Station Presetting Stations You can preset 30 FM and 15 AM (MW) stations manually. FM/AM 1 Press FM/AM to select either “FM” In some cases, test frequencies have been already stored or “AM.” for the tuner since the factory examined the tuner preset The unit automatically turns on and tunes in to function before shipment. This is not a malfunction. You the previously received station—either FM or can preset the stations you want into memory by
Resumo do conteúdo contido na página número 17
SET 4 Press SET again. To tune in to a preset station directly using the number “STORED” appears on the display for a buttons while. On the remote control ONLY: 13 2 Pressing the number button(s) allows you to select the preset number you want. 46 5 The tuned station in step 1 is stored in the preset number Ex.: For preset number 5, press 5. 79 8 selected in step 3. For preset number 15, press +10, • Storing a new station on an already assigned number then 5. 10 +10 erases the previously stored
Resumo do conteúdo contido na página número 18
Receiving FM Stations with RDS RDS (Radio Data System) allows FM stations to send an Searching for Programs by PTY Codes additional signal along with their regular program signals. (PTY Search) For example, the stations send their station names, as well as information about what type of program they broadcast, such One of the advantages of RDS is that you can locate a as sports or music, etc. particular kind of program by specifying the PTY codes. When tuned in to an FM station which provides th
Resumo do conteúdo contido na página número 19
Switching Temporarily to a Program Type of How the Enhanced Other Networks function actually Your Choice works: The Enhanced Other Networks function allows the unit to switch temporarily to a broadcast program of your choice CASE 1 (TA, News, and Info) from a different station. If there is no station broadcasting the program you • The function only works when you are listening to a preset have selected FM RDS stations providing the data. The unit continues tuning in to the current station. « To
Resumo do conteúdo contido na página número 20
Playing Back Discs on the 5-CD Changer This unit has been designed to play back the following Loading Discs discs—CD, CD-R, and CD-RW. When playing a CD-R or CD-RW On the unit ONLY: User-edited CD-Rs (CD-Recordable) and CD-RWs (CD- ReWritable) can be played only if they are already 1 Press one of the disc eject buttons (CD10 – “finalized.” CD50) for the disc tray you want to load a • Usually you can play back your original CD-Rs or CD- disc onto. RWs recorded in music CD format. However, sometim
