Resumo do conteúdo contido na página número 1
Resumo do conteúdo contido na página número 2
4 Ventilation — The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm clearance from the rear and the top of the unit, and 5 cm from each side. - Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings. - Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded. 5 Objects and liquid entry — Take care that objects or liquid do not get inside the unit through
Resumo do conteúdo contido na página número 3
Altenna Grounding According to the National Electrical Code , ANTENNA LEAD IN WIRE h #’- PREPARATIONS — $ ANTENNA DISCHARGE 1 GROUND CLAMP c; UNIT 3 /’ CONNECTIONS ,...,.,,,,,.,.,,,,.. ..........................................,,, (NEc SECTION ai 0-20) REMOTE CONTROL ...........................................................5 BEFORE OPERATION ........................................................5 ELECTRIC GROUNDING SERVICE CONDUCTORS SOUND EC!UIPMENT (NEC SECTION 810-21) 6 AUDIO ADJUSTMENTS
Resumo do conteúdo contido na página número 4
1 Connect the right and left speakers to the main unit. Connect the right speaker cord to SPEAKERS R terminals, and the left to SPEAKERS L terminals. Check the AC voltage The rated voltage of your unit shown on the rear panel is 120 V ‘ AC. Check that the rated voltage matches your local voltage. IMPORTANT Connect the speakers, antennas, and all optional equipment first. Then connect the AC cord in the end. Speakers There are no difference between the front speakers as well as The speaker cord w
Resumo do conteúdo contido na página número 5
3 Ccmnect thesupplied antennas. Connect the FM antenna to FM 75 Q terminals and the AM antenna to AM LOOP terminals. FM antenna AM antenna & ‘———’CX-ZR554 @ Front speakers @ Surround speakers 4 Connect the AC cord to an AC outlet. Place the surround speakers directly to the side of or slightly behind the listening area. Align them horizontally, about 1 To position the antennas meter above ear height. FM feecler antenna: Extend tile antenna horizontally in a T-shape and fix its ends to To mount t
Resumo do conteúdo contido na página número 6
Inserting batteries Detach the battery cover on the rear of the remote control and insert two R6 (size AA) batteries. CD DEMO R6(’AA) b When to replace the batteries The maximum operational distance between the remote control and the sensor on the main unit should be approximately 5 meters To turn the unit on (16 feet). When this distance decreases, replace the batteries Press one of the function buttons (TAPE, TUNEFUBAND, VIDEO/ with new ones, AUX/PHONO, CD). Playback of the inserted disc begin
Resumo do conteúdo contido na página número 7
:,. —r i This unit provides the following three different equalization curves. VOLUIME CONTROL ROCK: Powerful sound emphasizing treble and bass POP: More presence in the vocals and midrange Turn VOLUME on the main unit, or press VOLUME CLASSIC: Enriched sound with heavy bass and fine treble. on the remote control. The volLlme level is displayed as a number from Oto MAX (31). Press GEQ repeatedly to select the equalization The volume level is automatically set to 16 when the power is mode. turned
Resumo do conteúdo contido na página número 8
ON To search for a station quickly (Auto Search) Press TUNER PRESET repeatedly to display “SEARCH’’(auto search mode), and turn MULTI JOG clockwise or counterclockwise Until the frequency starts to change rapidly. After tuning into a station, the search stops, ~ MONO TUNER BAND SHl~ To stop the Auto Search manually, turn MULTI JOG a little in either direction. ● The Auto Search may not stop at the stations with very weak signals. ● M DOWN and M UP are also available to search for a station. Keep
Resumo do conteúdo contido na página número 9
(Deck 1) (Deck 2) The unit can store a total of 32 preset stations. When a station is stored, a preset number is assigned to the station. Use the preset Usable tapes number to tune in to a preset station directly. Use Type I (normal) tapes only. 1 Press TUNER/BAND to select a band, and press 1 PressTAPE, then press WA to open the cassette l++ DOWN or -UP to select a station. holder. 2 Press I I SET to store the station. A preset number beginning from 1 in consecutive order for each band is assig
Resumo do conteúdo contido na página número 10
PLAYING DISCS Load discs. all discs in the disc compartment, press *. To ~lav EDITI Play begins with the disc on tray 1. CHECK RANDOM/ Number of track being played Elapsed playing time REPEAT 0-9,+10 SHIFT To dav one disc only press one of DISC DIRECT PLAY ! P 1-5. 1, DISC The selected disc is played once. DIRECT G PLAY 1-5 Selected disc tray number Elaps~d playing time Press CD, then press AOPEN/CLOSE to open the disc compartment. Load disc(s) with the label side I up. Number of track being pla
Resumo do conteúdo contido na página número 11
● wjoadina an 8-cm (3-inch) disc, make sure to riace it onto ~rer circle of the tray precisely. Otherwise, the disc may be damaged or the disc compartment will not open. If it does not open, please consult your Aiwa dealer for repair. Up to 30 tracks can be programmed from any of the inserted ● Do not place more than one compact disc on one disc tray. discs. ● Do not tilt the unit with discs loaded. Doing so may cause malfunctions. ● When transporting the unit, remove the discs from the trays. ●
Resumo do conteúdo contido na página número 12
To record part of the CD When ● is pressed, recording always starts from the first track. To start in the middle of a track, play th~ CD first and press I I SET for CD at the point you wish to start recording from. Then, press ● . The pause mode for CD button is released automatically and recording Stark. $ ‘*———— -—-————$’ ‘ Sound adjustment during recording The output volume and tone of the speakers or headphones may be freely varied without affecting the recording. ● Do not press the buttons
Resumo do conteúdo contido na página número 13
6 Press O on Deck 1 to start recording on the first side. ~ flashes for 10 seconds, and then CD play and recording of edited tracks for the first side start simultaneously. When the end of the tape is reached, Deck 1 enters the recording stop mode. After entering the recording stop mode go to step 7, 4 7 Press EDIT/CHECK while pressing SHIFT on the ‘5 remote control to display the program for the second recording. “B” is displayed. 3,7 Turn over the tape in Deck 1 and press ● to start 8 recordin
Resumo do conteúdo contido na página número 14
Selected disc Program number Remaining time on side A number I 5 Programmed track number Selected’track number 4,5 6 Repeat step 5 for the rest of the tracks for side 3,7,8,9 A. A track whose playing time is longer than the remaining time cannot be programmed. 7 Press EDIT/CHECK while pressing SHIFT on the remote control to select side B and program the tracks for side B. In the Programmed edit recording function the tracks can be Tape side B (reverse side) programmed while checking the remainin
Resumo do conteúdo contido na página número 15
,— ----,, 1 1 2- 2 Pre:w CLOCIVDIMMER once, then press ENTER The unit can be turned off automatically at a specified time. W!in 4 seconds. Use the remote control. 1 Press SLEEP while pressing SHIFT. When using the remote control Press CLOCK while pressing SHIFT, then press llSETu!il.hh 4 seconds. 2 Within 4 seconds, turn MULTI JOG or press U Turn MULTI JOG to designate the hour, then press or ~ to specify the time until the power is turned ENTER. off. The hour stops flashing and the minute stark
Resumo do conteúdo contido na página número 16
5 Prepare the source. To listen to a CD, load the disc to be played first on tray 1. To listen to a ta~e, insert the tape into Deck 1 or 2. To listen to the radio, tune in to a station. Press POWER to turn the unit off after adjusting 6 the volume and tone. @ remains on the display after the power is turned off (timer standby mode). m )’ Get ready for the TAPE function or the timer 7 recording. To listen to the tape, press F. The unit can be turned on at a specified time every day with the To re
Resumo do conteúdo contido na página número 17
— CD DIGITAL OUT (OPTICAL) POWER- q — ;~lD~~A~W ,= I U ! m d’ To play equipment connected to VIDEO/AUX/PHONO IN jacks proceed as follows. F{efer to the operating instructions of the connected equipment for deta,lls, 1 Press VIDEO/AUX/PHONO. * The c:mnecting cords are not supplied. Obtain the necessary “VIDEO” appears on the display. 0 connecting cords. @ Consult your local Aiwa dealer for optional equipment. 2 Play the connected equipment. To change a source name on the display When VIDEO/AUX/PH
Resumo do conteúdo contido na página número 18
If the unit fails to perform as described in these Operating Occasional care and maintenance of the unit and the software Instructions, check the following guide. are needed to optimize the performance of your unit. To clean the cabinet GENERAL Use a soft and dry cloth. There is no sound. ● Is’the AC cord connected properly? If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution. Do not use strong ● Is there a bad connection? (+ page 3) ● There may b
Resumo do conteúdo contido na página número 19
-. ~, Speaker svstem SX-ZR55 — .,,, ., Cabinet type 3 way, bass reflex Woofer: Speakers 170 mm (63/4 in.) cone type Tweeter: 60 mm (23/t3in.) cone type Main unit CX-ZR554 Super tweeter: FM tunw’ section 20 mm (13/16 in.) Ceramk typf? Tuning range 87.5 MHz to 108 MHz impedance 6 ohms Usable :sensitivity(IHF) 13.2 dBf Output sound pressurs level 87 dB/Wlm 75 ohms (unbalanced) Antenna terminals Dimensions (W x H x D) 280 x 444x 272 mm (11’/8 X Ii”/z X lr)3/4 ill.) AM tuner section Weight 4.5 kg (9
Resumo do conteúdo contido na página número 20
4 Ventilation — La unidad debera situarse donde tenga suficienteespacio Iibrea su alrededor, para que la ventilation apropiada quede asegurada. Deje un espacio Iibre de 10 cmpor la parte posterior y superior de la unidad, y 5 cm por cada Iado. - No ponga la unidad sobre una cama, una alfombra o superficies similares que podrian tapar Ias aberturas de ventilation, - No instale la unidad en una Iibreria, mueble o estanter[a cerrada hermeticamente donde la ventilation no sea a adecuada. RISK OF ELE