Resumo do conteúdo contido na página número 1
AV Receiver
DTR-5.8
Instruction Manual
Resumo do conteúdo contido na página número 2
WARNING: WARNING AVIS RISK OF ELECTRIC SHOCK RISQUE DE CHOC ELECTRIQUE TO REDUCE THE RISK OF FIRE OR ELECTRIC DO NOT OPEN NE PAS OUVRIR SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within CAUTION: the product’s enclosure that may be of sufficient TO REDUCE THE RISK OF ELECTRIC SHOCK, magnitude to constitute a risk of electr
Resumo do conteúdo contido na página número 3
Precautions 1. Recording Copyright—Unless it’s for personal use For U.S. models only, recording copyrighted material is illegal with- FCC Information for User out the permission of the copyright holder. CAUTION: 2. AC Fuse—The AC fuse inside the unit is not user- The user changes or modifications not expressly serviceable. If you cannot turn on the unit, contact approved by the party responsible for compliance could the dealer from whom you purchased this unit. void the user’s authority to o
Resumo do conteúdo contido na página número 4
Thank you for purchasing an Integra AV Receiver. Supplied Accessories Please read this manual thoroughly before making con- nections and plugging in the unit. Make sure you have the following accessories: Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new AV Receiver. Please retain this manual for future reference. Remote controller & two batteries (AA/R6) Speaker setup microphone Indoor FM antenna AM loop antenna Power
Resumo do conteúdo contido na página número 5
Table of Contents Introduction Basic Operations Important Safety Instructions ....................2 Basic Operations....................................... 54 Selecting the Input Source ...........................54 Precautions ..................................................3 Using the Multichannel DVD Input................55 Supplied Accessories..................................4 Adjusting the Bass & Treble .........................55 Features ................................................
Resumo do conteúdo contido na página número 6
Features Amplification *1. • 90 watts minimum continuous power per channel, 8 Manufactured under license from Dolby Laboratories. ohm loads, 2 channels driven from 20 Hz to 20 kHz “Dolby”, “Pro Logic” and the double-D symbol are registered with a maximum total harmonic distortion of 0.08 % trademarks of Dolby Laboratories. (FTC rating) *2. • WRAT-Wide Range Amplifier Technology “DTS” is a registered trademark of DTS, Inc. and “DTS-HD • Optimum Gain Volume Circuitry Master Audio” is a trade
Resumo do conteúdo contido na página número 7
Front & Rear Panels Front Panel North American model 1 234 5 67 8 9bkblbm bnbo bp bq br bs bt ck cl cm Australian model 2 cn3 The page numbers in parentheses show where you can find the main explanation for each item. Standby/On button (40) Stereo button (59) This button is used to set the AV receiver to Standby This button is used to select the Stereo listening or On. mode. Standby indicator (40) Listening Mode [ ] [ ] buttons (59) This indicator lights up when the AV receiver is in The
Resumo do conteúdo contido na página número 8
Front & Rear Panels—Continued Tuning Mode button (57) Ready indicator (82) (Australian model) This button is used to select the Auto or Manual Enters Ready mode and lights up when the HDMI tuning mode. Power Control is set to Enable and the AV receiver is on Standby. Display button (55) This button is used to display various information about the currently selected input source. Setup button This button is used to access the onscreen setup menus that appear on the connected TV. Arrow/Tun
Resumo do conteúdo contido na página número 9
Front & Rear Panels—Continued Display 12 3 4 5 6 7 The page numbers in parentheses show where you can find the main explanation for each item. SLEEP indicator (56) Tuning indicators This indicator lights up when the Sleep function has FM STEREO (57): This indicator lights up when been set. the AV receiver is tuned to a stereo FM station. MUTING indicator (56) AUTO (57): This indicator lights up when the Auto This indicator flashes or lights up while the AV Tuning mode is selected, and dis
Resumo do conteúdo contido na página número 10
Front & Rear Panels—Continued Rear Panel North American model (North American model only) 34 1 2 8 567 9 bk blbmbn bo bp bqbrbs bt ckclcm cn co cp The page numbers in parentheses show where you can find the main explanation for each item. DIGITAL OPTICAL IN 1, 2 and OUT FM ANTENNA (22) These optical digital audio inputs are for connecting This jack is for connecting an FM antenna. components with optical digital audio outputs, such MONITOR OUT as CD players and DVD players. The S-Video or co
Resumo do conteúdo contido na página número 11
Front & Rear Panels—Continued AC INLET This connector is for connecting the supplied power cord. REMOTE CONTROL This (Remote Interactive) jack can be con- nected to an jack on another -capable Inte- gra component. The AV receiver’s remote controller can then be used to control that component. To use , you must make an analog audio connection (RCA) between the AV receiver and the other AV component, even if they are connected digitally. COMPONENT VIDEO IN 1, 2, 3 These component video in
Resumo do conteúdo contido na página número 12
Remote Controller Installing the Batteries Aiming the Remote Controller To use the remote controller, point it at the AV receiver’s To open the battery compartment, press remote control sensor, as shown below. 1 the small hollow and slide off the cover. Remote control sensor AV receiver Standby indicator Approx. 16 ft. Insert the two supplied batteries (AA/R6) 2 (5 m) in accordance with the polarity diagram inside the battery compartment. Notes: • The remote controller may not work reliably
Resumo do conteúdo contido na página número 13
Remote Controller—Continued Using the Remote Controller Receiver/Tape Mode The remote controller can be used to control different Receiver/Tape mode is used to control the AV receiver. components including the AV receiver. The remote con- It can also be used to control an Integra cassette recorder troller has a specific operating mode for use with each connected via . type of component. Modes are selected by using the six Remote Mode buttons. 1 ■ Receiver/Tape Mode In Receiver/Tape mode, you
Resumo do conteúdo contido na página número 14
Remote Controller—Continued For detailed information, see the pages in parentheses. L Night button (67) Used with the Late Night function. Zone 2 button (86) ■ Buttons used when the Tuner input is Used to select the input source for Zone 2. selected Standby/On button (40) To select the Tuner (AM/FM) as the input Sets the AV receiver to Standby or On. source, press: Input Selector buttons (54) Used to select the input sources. Multi CH button (55) Selects the multichannel DVD input. Dimmer
Resumo do conteúdo contido na página número 15
Remote Controller—Continued Standby/On button DVD Mode Sets the DVD player to Standby or On. By default, the remote controller is set to control an Inte- Number buttons gra DVD player. Used to enter title, chapter, and track numbers and times for locating specific points. To select your DVD player as the input source, press: Disc +/– button or Selects discs on a DVD changer. Top Menu button Selects a DVD’s top menu. Arrow [ ]/[ ]/[ ]/[ ] and Enter buttons Used to navigate DVD menus and the
Resumo do conteúdo contido na página número 16
Remote Controller—Continued Standby/On button CD/MD/CDR/Dock Mode Sets the component to Standby or On. By default, the remote controller is set to control an Inte- Number buttons gra CD player. Used to enter track numbers and times for locating specific points on CD/MD players. To select the input source, press: Disc/Album +/– button CD player Selects discs on a CD changer, or the next or previ- ous album on an HDD-compatible component con- nected to an RI Dock. MD or CD recorder Top Menu b
Resumo do conteúdo contido na página número 17
About Home Theater Enjoying Home Theater Thanks to the AV receiver’s superb capabilities, you can enjoy surround sound with a real sense of movement in your own home—just like being in a movie theater or concert hall. With DVDs you can enjoy DTS and Dolby Digital. With analog and digital TV you can enjoy Dolby Pro Logic IIx or Onkyo’s own DSP surround listening modes. Front left and right speakers These output the overall sound. Their role in a home theater is to provide a solid anchor for th
Resumo do conteúdo contido na página número 18
Connecting the AV receiver AV Connection Color Coding About AV Connections RCA-type AV connections are usually color-coded: red, • Before making any AV connections, read the manuals white, and yellow. Use red plugs to connect right- supplied with your other AV components. channel audio inputs and outputs (typically labeled “R”). • Don’t connect the power cord until you’ve completed Use white plugs to connect left-channel audio inputs and and double-checked all AV connections. outputs (typic
Resumo do conteúdo contido na página número 19
Connecting the AV receiver—Continued Connecting a Powered Subwoofer Connecting Your Speakers Using a suitable cable, connect the AV receiver’s PRE Speaker Configuration OUT SUBWOOFER to an input on your powered sub- woofer, as shown. If your subwoofer is unpowered and For the best surround sound experience, you should con- nect seven speakers and a powered subwoofer. you’re using an external amplifier, connect the PRE OUT SUBWOOFER to an input on the amp. The following table indicates the cha
Resumo do conteúdo contido na página número 20
Connecting the AV receiver—Continued Speaker Connection Precautions Connecting the Speaker Cables Read the following before connecting your speakers: • North American models: Only connect speakers Strip about 5/8" (15 mm) 15 mm 1 with an impedance of 6 ohms or higher. If you use of insulation from the speakers with a lower impedance, and use the ampli- ends of the speaker fier at high volume levels for a long period of time, the cables, and twist the bare built-in protection circuit may
