Manual do usuário Channel Plus 5115BID

Resumo do conteúdo contido na página número 1

PERFORMANCE MULTI-ROOM VIDEO
WARRANTY
5115 Modulator Series
Multiplex Technology, Inc. warrants this product to be
free from defects in materials and workmanship for a
period of one year from the date of purchase or MTI will Model 5115HHR
repair, or at its option, replace the defective product. To
obtain warranty service, call MTI for a return material
Model 5115BID
authorization (RMA) number and return the product pre-
paid to Multiplex Technology, Inc., 3001 Enterprise
Model 5115PAL
Street, B

Resumo do conteúdo contido na página número 2

The 5115 series is a audio/video distribution system that creates a Installation new channel to add to existing television channels. The new channel Step One carries audio/video from any video source to all the TVs in the home Locate the incoming CATV or antenna feed and existing splitter. The 5115 was designed to install effortlessly into existing coax home (Usually found on the side of the house, in the attic or near the electrical and phone service box) wiring or into new construction. Remov

Resumo do conteúdo contido na página número 3

Installation of the wall plate Connecting A Video Source Using any video source, DVD,Satellite or VCR connect it to the wall Step Two plate as shown. This video source will be transmitted over the Cat 5 The wall plate mounts using a low voltage ring into a wall cut out. wire to the channel injector. Run a line of Cat 5 wire from the wall plate to the channel injector and connect wires as shown. Optional loop * Side view out television of wall plate Audio/video or a/v receiver connections note:

Resumo do conteúdo contido na página número 4

Method Two: Use the power injector to apply power along the Cat Applying Power and Programming 5 or quad wire run. Cut the connecting wire along the run and insert Step Three the power injector. Connect the wires using the color coding. Then The 5115 series has three different methods for applying power plug the power supply into the power injector. to the system. Use only one method for applying power. power injector Method One: Apply power directly to the channel injector with the power supp

Resumo do conteúdo contido na página número 5

Power Length Requirements How to Program Method One Determine which unused channel you want to view your video source on and program the injector for that channel. There must be one unused channel both before and after the selected channel to avoid interference. The new channel will be combined with the exist- ing channels and appear on all televisions. Up to 300’ of Upper right corner on Cat 5 or quad channel injector wire maximum power plug green LED programming button Power Length Requireme

Resumo do conteúdo contido na página número 6

Programming a New Channel Valid channels are 14 thru 64 for UHF and 65 thru 125 for CATV Specifications: typical @ 25°C ± 5° C Channels 95-99 are not available. Channels 21 thru 62 are for Pal. 5115HHR / 5115BID 5115PAL(AUS) Channel Spacing: video input format NTSC CCIR Skip at least one number between the new channel and the closest existing UHF/CATV channel. input signal 1.0 V peak-to-peak @ 75 (example 14 and 16: OK 14