Resumo do conteúdo contido na página número 1
Resumo do conteúdo contido na página número 2
Introduction Adjustable Phase The output phase of each channel can Features SX .2 Series be set at 0 Degrees or 180 Degrees. Left and Right channels Amplifier can be linked or independently adjusted. Low Impedance Operation Stable into 2 ohm stereo Owners Manual or 4 ohm mono loads. UltraMatch Gain Structure Digital input gain control with five selectable gain ranges (1 volt, 2 volt, 4 volt, 8 volt, 16 SORT Protection Circuitry (Short circuit, Over-voltage, Two Channel Models: volt) with 12 dB
Resumo do conteúdo contido na página número 3
Features VFD DISPLAY - cont KEYPAD ISIS VFD Display GAIN - Indicates you are in the gain menu. The keypad consists of nine buttons that allow you to adjust Meet the ISIS interface (Indicate Status & Input Settings). AMP1 AMP2 your amplifier. LOCK LEFT SYS RIGHT MUTE TheISIS (pronounced eye-sis) allows you to view the cur- EQ - Indicates you are in the equalizer menu. GAIN EQ LPF HPF PHASE KOMP rent conditions and settings of your amplifier as well as M1 - Used to select memory preset 1 or to st
Resumo do conteúdo contido na página número 4
Features Remove Remove Custom-machined power block accepts up to a 2 Ga wire End Panel Views Mounting for both power and ground connections and up to an 8 Ga for remote turn-on assures maximum power transfer with The BLAST Port is used to connect the Remote Bass Level When selecting a location to mount your Kicker amplifier be minimal loss. Controller and for transferring control signals from one SX sure it is structurally sound and that there are no items R amplifier to another SX amplifier. A
Resumo do conteúdo contido na página número 5
Installation The ground should be connected to the amplifier first Wiring System Diagrams before making any of the other connections. This wire should TWO CHANNEL OPERATION (STEREO) be as short as possible (24 inches or less) and connected to a Signal is input into the amplifier using the low level RCA paint/corrosion free solid metal area of the car’s chassis. Use input connections. If your source unit does not have RCA the same gauge wire as recommended for the amplifier’s SX.2 series amplifi
Resumo do conteúdo contido na página número 6
Installation STEREO AND MONO SIMULTANEOUSLY (SAMS) USING THE SIGNAL OUTPUT JACKS (PAST) SX.2 series amplifiers are capable of operating into a minimum impedance of 4 ohms P A S T The Output ( re mp ignal ransfer) RCA jacks allow you to SOURCE UNIT mono and 2 ohms stereo simultaneously with the use of passive crossovers. send the incoming signal from one Kicker SX series amplifier to another amplifier or processor without the need for Y PAST cables. The signal from the jacks is identical to t
Resumo do conteúdo contido na página número 7
INSTALLATION ... ... ... USING THE REMOTE BASS LEVEL CONTROL & BLAST As you can see there can be an infinite number of menu BACK VIEW Mounting Surface Navigation levels and each one of these menu levels can have an infinite You can use the Remote Bass Level Control to control the number of its own items. Your KICKER SX series amplifier uses the latest in Digital DSP output of your amplifier from the front of the car. SIDE VIEW control and provides you with valuable operational informa- Navigat
Resumo do conteúdo contido na página número 8
Operation Continuing our example, we are now in the HISTORY item in Pressing the key and holding it in for If you want the display to continue scrolling simply press PRESS & Menu System the SICK BAY MENU. If we press the ESC key we would go longer than 1.5 seconds will activate the the HOME key again. HOLD The menu system layout is as follows: back up to the SICK BAY MENU. If we accelerated scrolling mode and scroll press the ESC key again we would go through the menu items at a much MAIN - Thi
Resumo do conteúdo contido na página número 9
Operation SICK BAY - cont SYSTEM MENU -This menu item contains many diagnostic 7a.) CURRENT shows amplifiers current status or fault 8.) Amp Name - Here you can assign a unique name to tools and first time setup options. Use the UP and DOWN code. The 6 possible codes are: your KICKER SX amplifier. This name will replace the model 7c.) PINK NOISE is a built in pink noise generator arrow keys to scroll through the options and press ENT to name in the DEFAULT screen. If you change your mind and
Resumo do conteúdo contido na página número 10
Operation 9.) Mem Name - Here you can change the names of the 10.) Remote Adr - This feature is currently not used but is 14.) Display - Several options to allow customizing 15.) Lock Code - Set your own lock code! The factory memory locations. The factory defaults are reserved for future expansion. the amplifier’s VFD display. default is 123 but you can change it and create your own code with up to 10 characters. Memory-1 11.) Gain Range - Sets the input voltage window of the 14a.) BRIGHTNES
Resumo do conteúdo contido na página número 11
Operation 16.) Reset Amp - This option resets all adjustable BOOST/CUT is how much you want to boost or cut the Now use the UP and DOWN keys EQ MENU - Here you can adjust the single band parametric settings back to their original factory defaults. equalizer and has a range of -18 dB to + 18 dB in .5 dB to increase or decrease the gain of equalizer. Your options are frequency, bandwidth and steps. the selected channel(s) in .5 dB boost/cut. Use the UP and DOWN keys to increments from 0 d
Resumo do conteúdo contido na página número 12
Operation When you are done adjusting the hi-pass MENU - Here is where you adjust the high pass Lo-Pass MENU - Here is where you adjust the low pass EQ press the ESC key while in the When you are done adjusting the crossover. crossover. EQ menu to return to the MAIN EQ press the ESC key while in the ESC HOME ENT ESC HOME ENT menu. EQ menu to return to the MAIN Press the ENT key to enter the Press the ENT key to enter the ESC HOME ENT ESC HOME ENT menu. HI-PASS menu. LO-PASS menu. NOTE..
Resumo do conteúdo contido na página número 13
Operation Phase MENU - Here you can switch the polarity of each Mute MENU - Here you can mute each channel(s) output for MUTE MENU - cont. Kompressor MENU - Here you can select which Kompressor channel(s) output between 0 or 180 setup or testing purposes. setting you wish to use. The SX amplifier utilizes a full digital degrees. NOTE... compressor circuit to tweak the amplifier and the sound to Press the ENT key to enter the While adjusting the MUTE you will notice the mute indica- your unique
Resumo do conteúdo contido na página número 14
Operation UNLOCK AMPLIFIER UNLOCK AMPLIFIER - cont. You will need to call KICKER directly at (405) 624-8583 to Security MENU - Here you can lock down your amplifier to handle this situation. You will need your amplifier’s serial prevent any access to the settings. The DEFAULT screen is still You do remember your lock code right? You better because If you enter the wrong code the display will flash the mes- number AND your receipt as the guys and gals answering the active and you can select any
Resumo do conteúdo contido na página número 15
Operation STORING A PRESET PRESET PRESETS In more general terms, each preset offers you these Memory Presets options. There are four memory preset keys each with an Make all the adjustments you want to have stored in the Ok, we know that sounds like a certain pizza commercial, indicator above it in the ISIS VFD display. The indicator will preset and return to the DEFAULT screen. but seriously the four memory presets come with settings Memory-1 sets the amplifier into full-range mode with a illu
Resumo do conteúdo contido na página número 16
Help Alternator n noise (whining sound that varies with engine RPM): Substitute known good source unit. Troubleshooting Check for damaged RCA cables. If amp does not make noise using PINK NOISE then: If your amplifier does not appear to be working, check obvi- Check routing of RCA cable. Check speaker connections. ous things first such as blown fuses, poor or incorrect wiring Check source unit for good ground. Test speaker outputs with known good speaker. connections, crossovers set impr
Resumo do conteúdo contido na página número 17
Specifications A few words on the Kompressor. The effect is most Kompressor Performance noticeable in the bass area of your music and the descriptions above apply to that area of your music Model SX400.2 SX500.2 SX600.2 SX900.2 Here is a brief explanation of each KOMPRESSOR setting. (Bass/Midbass). You can use the Kompressor in any amplifier configuration (Low Pass, High Pass, Band Pass or Full Range) Contour - This preset applies expansion below the threshold RMS Power but we feel the best re
Resumo do conteúdo contido na página número 18
Specifications Specifications common to all models. Height: 2.5 inches / 6.35 centimeters WHAT IS NOT COVERED? ELECTRONICS LIMITED WARRANTY Width: 10 inches / 25.4 centimeters This warranty is valid only if the product is used for the purpose for which it Kicker warrants this product to be free from defects in material and workman- was designed. Length Without EndKaps: Subtract 5 inches (12.7 cm) from chart above ship under normal use for a period of 90 DAYS from date of original purchase It
Resumo do conteúdo contido na página número 19
Notes Notes Pizza Delivery 36 37 SX .2 Series Amplifiers SX .2 Series Amplifiers Notes
Resumo do conteúdo contido na página número 20
Notes Chic’s Numbers Hook Ups 38 39 SX .2 Series Amplifiers SX .2 Series Amplifiers Notes
