Manual do usuário Infinity TSS-CENTER4000

Resumo do conteúdo contido na página número 1

INFP1594Center-4000om 10/18/04 2:34 PM Page 1
TSS-4000
TOTAL SPEAKER SOLUTIONS
TSS-CENTER4000
Owner’s Guide

Resumo do conteúdo contido na página número 2

INFP1594Center-4000om 10/18/04 2:34 PM Page 2 INTRODUCTION PLANNING YOUR SYSTEM ™ Before deciding where to best place your speakers, survey your Infinity Total Solutions room and study Figures 1 and 2. Infinity Total Solutions TSS-CENTER4000 center channel loudspeaker is designed to perfectly complement the TSS-SAT4000 speakers. It uses identical drivers to provide exceptional Center Left Right dialogue reproduction and a seamless transition between the Channel Front Front Subwoofer (above or

Resumo do conteúdo contido na página número 3

INFP1594Center-4000om 10/18/04 2:34 PM Page 3 Tilting the Speaker Wall-Mounting the TSS-CENTER4000 Using the If needed, the enclosed stand allows you to tilt the speaker Included Wall Bracket across a wide range (i.e., up a maximum of 18˚ or down a The customer is responsible for proper selection and use of maximum of 7˚), as shown in Figure 3. mounting hardware, and for correctly and safely wall-mounting Important! the speakers. Do not exceed the tilt range. Doing so may cause the speaker to

Resumo do conteúdo contido na página número 4

INFP1594Center-4000om 10/18/04 2:34 PM Page 4 Step Six Step Four Using the included Allen wrench, remove the top and bottom The wall-bracket design allows for rotation of the speakers at angles up to 30 degrees of center. Position the speakers end caps of the speaker by unscrewing the single center screw on bottom. so they face toward the primary listening position, before fully tightening. End Cap End Cap 1/4-20 x 3/4" Screw Step Five Connect the wires (page 5). Replace the end caps whil

Resumo do conteúdo contido na página número 5

INFP1594Center-4000om 10/18/04 2:34 PM Page 5 WIRING THE SPEAKER CARE OF YOUR SPEAKER SYSTEM After placing the speaker, you are ready to connect it to your When needed, use a soft cloth to remove any fingerprints or system. First, turn off all audio system power. Use high-quality to wipe off dust. Do not use any cleaning products or polish. speaker wire to make the connections. Consult the owner’s Clean the grille by gentle vacuuming. manuals included with your amplifier or receiver for conn

Resumo do conteúdo contido na página número 6

INFP1594Center-4000om 10/18/04 2:34 PM Page 6 SPECIFICATIONS TSS-CENTER4000 Frequency Response 120 – 20kHz (±3dB) Nominal Impedance 8 ohms Sensitivity 89dB (2.83V @ 1m) Recommended Amplifier 10 – 150 watts Power Range Crossover Frequencies 1,000Hz, 3,800Hz; 24dB/octave ® Low Frequency Drivers (4) 3-1/2" (89mm) MMD, magnetically shielded Mid Frequency Drivers (2) 3-1/2" (89mm) MMD, magnetically shielded High Frequency Driver 3/4" (19mm) MMD, elliptical waveguide, magnetically shielded Dimensio

Resumo do conteúdo contido na página número 7

INFP1594Center-4000om 10/18/04 2:34 PM Page 7 NOTES

Resumo do conteúdo contido na página número 8

INFP1594Center-4000om 10/18/04 2:34 PM Page 8 © 2004 Harman International Industries, Incorporated Infinity Systems, 250 Crossways Park Drive,Woodbury, NY 11797 USA 516.674.4INF (USA only) www.infinitysystems.com *Trademarks of Dolby Laboratories. DTS is a registered trademark of Digital Theater Systems, Inc. Infinity and MMD are registered trademarks, and Total Solutions is a trademark, of Harman International Industries, Incorporated. Part No. 400-OMCNTR 10/04