Manual do usuário Azden IRR-15

Resumo do conteúdo contido na página número 1

User’s Guide
INFRARED WIRELESS SYSTEM
IRR-15 RECEIVER - IRB-10 BODY-PACK - IRH-10 HANDHELD
IRD-30 SENSOR
Azden Corporation, 147 New Hyde Park Road, P.O. Box 10, Franklin Square, NY 11010
voice - 516.328.7500 • fax - 516.328.7506 • email - azdenus@azdencorp.com
© 2007 Azden Corporation
Printed in USA P1020-01

Resumo do conteúdo contido na página número 2

G D H F E A C B M N O P 3 1 3 IRB-10 (Top View) 5 2 6 4 R Q U W T S V X Y i 7

Resumo do conteúdo contido na página número 3

INTRODUCTION SPECIFICATIONS System overall 2 Working range.............................................IRB-10 – 1600 ft w/built-in sensor 2 IRH-10 – 2500 ft w/built-in sensor Frequency response...................................50Hz – 9kHz (±3dB) body pack (mic dependent) Thank you for selecting the Azden “RED” infrared system as your wireless solution. We are 50Hz – 5kHz (±3dB) auxiliary emitter mic confident that it will perform beyond your expectations. For over 40 years Azden Corpora-

Resumo do conteúdo contido na página número 4

TABLE OF CONTENTS TROUBLESHOOTING The single most important thing to ALWAYS check when trouble arises are the batteries. EXPLODED VIEWS ..................................................................................................................i Make sure they are fresh and the POWER LED is glowing brightly. INTRODUCTION ...................................................................................................................... ii RECEIVER SETUP ..................................

Resumo do conteúdo contido na página número 5

RECEIVER SETUP (see illustration on page i) THE IRH-10 HANDHELD MIC (continued ) I. Receiver Front Panel I. Using the IRH-10: A. Power-Volume Knob - turn the knob clockwise to turn the receiver ON After installing fresh batteries and choosing a frequency, simply turn the mic/transmit- and to increase the output volume level. Turn the knob counter-clockwise until it ter on by sliding the ON/OFF switch up. The Power LED above the switch will glow as clicks to turn the receiver OFF. will the red LE

Resumo do conteúdo contido na página número 6

II. Frequency Selection: IV. Using the IRB-10 (continued): The IRB-10 can be set to transmit on either one of two preset frequencies. This is so While there is a built-in microphone in the emitter, for best results an external micro- that two different speakers can talk at the same time in the same room. While it does phone should be used. This microphone can be attached to the IRB-10 through the not matter which frequency is chosen for the body-pack, two transmitters cannot share 3.5mm EXT. MIC