Manual do usuário JBL Studio S-CENTERII

Resumo do conteúdo contido na página número 1

SPECIFICATIONS
Description: 3-Way dual 5-1/4" center
Maximum Recommended
Amplifier Power:** 150W
Nominal Impedance: 8 Ohms
Sensitivity (2.83V/1m): 91dB
Frequency Response (–3dB): 75Hz – 20kHz
Crossover Frequencies: 800Hz, 3200Hz
High-Frequency Transducer: 1" Pure-titanium dome, with rubber surround,
shielded; Elliptical Oblate Spheroidal™ (EOS)
waveguide
Midrange Transducer: 4" PolyPlas™ (polymer-coated cellulose fiber)
cone, rubber surround, shielded; Linear Field
Proximity™ (LFP) bezel
L

Resumo do conteúdo contido na página número 2

THANK YOU FOR CHOOSING JBL For more than 50 years, JBL and that when you think our customers and build has been involved in every about purchasing additional products that meet their aspect of music and film audio equipment for your needs and expectations. recording and reproduction, home, car or office, you will JBL Consumer Products from live performances to the once again choose JBL. recordings you play in your Please take a moment to home, car or office. complete the enclosed We’re confident

Resumo do conteúdo contido na página número 3

SPEAKER PLACEMENT Proper placement of your loudspeakers. Use these The Studio Series S-CENTERII speakers is an important step placement recommendations loudspeaker is video- in obtaining the most realistic as a guide. Slight variations shielded and can safely be soundstage possible. These will not diminish your placed near a television. recommendations are for the listening pleasure. optimum placement of your The S-CENTERII is designed to complement all of the 0-2 ft. Studio Series loudspeaker

Resumo do conteúdo contido na página número 4

TROUBLESHOOTING If there is no sound from • If more than one pair of • If your receiver/processor any of the speakers: main speakers is being is set in Dolby* Pro Logic* • Check that receiver/ used, check the minimum mode, make sure the center amplifier is on and that impedance requirements of speaker is not in phantom a source is playing. your receiver/amplifier. mode. • Review proper operation • If your receiver/processor of your receiver/amplifier. If there is no sound from is set in Dolby D