Resumo do conteúdo contido na página número 1
Dell™ PowerEdge™
R510 Systems
Getting Started
With Your System
Guide de mise en route
Primeiros passos com o sistema
Procedimientos iniciales con el sistema
Resumo do conteúdo contido na página número 2
Resumo do conteúdo contido na página número 3
Dell™ PowerEdge™ R510 Systems Getting Started With Your System Regulatory Model E12S Series and E13S Series
Resumo do conteúdo contido na página número 4
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. ____________________ Information in this document is subject to change without notice. © 2009 Dell Inc. All rights reserved. Reproduction of these materials in any manner w
Resumo do conteúdo contido na página número 5
Installation and Configuration WARNING: Before performing the following procedure, review the safety instructions that came with the system. Unpacking the System Unpack your system and identify each item. Assemble the rails and install the system in the rack following the safety instructions and the rack installation instructions provided with your system. Getting Started With Your System 3
Resumo do conteúdo contido na página número 6
Optional – Connecting the Keyboard, Mouse, and Monitor Connect the keyboard, mouse, and monitor (optional). The connectors on the back of your system have icons indicating which cable to plug into each connector. Be sure to tighten the screws (if any) on the monitor's cable connector. Connecting the Power Cable(s) Connect the system’s power cable(s) to the system and, if a monitor is used, connect the monitor’s power cable to the monitor. 4 Getting Started With Your System
Resumo do conteúdo contido na página número 7
Securing the Power Cable(s) Bend the system power cable into a loop as shown in the illustration and secure the cable to the bracket using the provided strap. Plug the other end of the power cable into a grounded electrical outlet or a separate power source such as an uninterrupted power supply (UPS) or a power distribution unit (PDU). Turning On the System Press the power button on the system and the monitor. The power indicators should light. Getting Started With Your System 5
Resumo do conteúdo contido na página número 8
body.fm Page 6 Tuesday, October 20, 2009 10:43 AM Installing the Optional Bezel Install the bezel (optional). Complete the Operating System Setup If you purchased a preinstalled operating system, see the operating system documentation that ships with your system. To install an operating system for the first time, see the installation and configuration documentation for your operating system. Be sure the operating system is installed before installing hardware or software not purchased wit
Resumo do conteúdo contido na página número 9
body.fm Page 7 Tuesday, October 20, 2009 10:44 AM � Microsoft Windows Server 2008 Standard, Enterprise, and Datacenter (x64) Editions with SP2 with Hyper-V role enabled � Microsoft Windows Web Server 2008 with SP2 with Hyper-V role enabled � Microsoft Windows Server 2008 Standa rd and Enterprise (x86) Editions with SP2 � Microsoft Windows Web Server 2008 with SP2 � Microsoft Windows Server 2008 R2 Standard, Enterprise, and Datacenter (x64) Editions with Hyper-V role enabled � Microsoft Win
Resumo do conteúdo contido na página número 10
� VMware Virtual Infrastructure 3 ESXi Version 3.5 Update 4 NOTE: VMware Virtual Infrastructure 3 ESXi Version 3.5 Update 4 is not supported on twelve–hard-drive systems. ® � Citrix XenServer™ Enterprise (Version 5.5) NOTE: Twelve–hard-drive systems support Citrix XenServer Enterprise (Version 6.0). � Citrix Essentials for XenServer Enterprise (Version 5.5) NOTE: For the latest information on supported operating systems, seesupport.dell.com. Other Information You May Need WARNING: See the
Resumo do conteúdo contido na página número 11
Technical Specifications Processor ® ® Processor type Two Intel Xeon processors 5500 series Expansion Bus Bus type PCI Express Generation 2 Expansion slots using riser cards NOTE: Depending on the configuration, your system may have either riser 1 or riser 2. Riser 1 Slot 1: PCIe x4, half-length, full-height Slot 2: PCIe x4, full-length, full-height Slot 3: PCIe x8, half-length, full-height OR Slot 4: PCIe x4, internal slot for integrated card NOTE: All four slots are x8 connectors. Riser 2 Sl
Resumo do conteúdo contido na página número 12
body.fm Page 10 Tuesday, October 20, 2009 10:46 AM Drives Hard drives Four–hard-drive systems Up to four 3.5-inch, cabled SAS, SATA, or SSD drives Eight–hard-drive systems Up to eight 3.5-inch or 2.5-inch, hot-swappable SAS, SATA, or SSD drives Twelve–hard-drive systems Up to twelve 3.5-inch or 2.5-inch, hot-swappable SAS, SATA, or SSD drives and up to two cabled 2.5-inch SAS or SSD drives NOTE: For twelve–hard-drive systems with additional internal hard drives, it is recommended that y
Resumo do conteúdo contido na página número 13
Video Video type Matrox G200, integrated in the BMC Video memory 8 MB Power AC power supply (per power supply) Wattage Four–hard-drive systems 480 W (non-redundant power supply) Eight–hard-drive systems 750 W/1100 W (optional redundant power supply) Twelve–hard-drive systems 750 W (optional redundant power supply) Voltage 100–240 VAC, autoranging, 50–60 Hz Heat dissipation Four–hard-drive systems 1840 BTU/hr maximum Eight–hard-drive systems 2200 BTU/hr maximum Twelve–hard-drive systems 2450
Resumo do conteúdo contido na página número 14
Physical (continued) Depth Four– and eight–hard-drive 61.02 cm (24.09 in) systems Twelve–hard-drive systems 66.46 cm (26.17 in) Weight (maximum configuration) Four–hard-drive systems 16 kg (35.2 lbs) Eight–hard-drive systems 22.5 kg (49.5 lbs) Twelve–hard-drive systems 29.0 kg (63.8 lbs) Weight (empty) Four–hard-drive systems 13.6 kg (29.92 lbs) Eight–hard-drive systems 13.5 kg (29.7 lbs) Twelve–hard-drive systems 15.85 kg (34.87 lbs) Environmental NOTE: For additional information about environ
Resumo do conteúdo contido na página número 15
Environmental (continued) Maximum vibration Operating 0.26 G at 5–350 Hz for 15 min Storage 1.54 G at 10–250 Hz for 15 min Maximum shock Operating One shock pulse in the positive z axis (one pulse on each side of the system) of 31 G for 2.6 ms in the operational orientation Storage Six consecutively executed shock pulses in the positive and negative x, y, and z axes (one pulse on each side of the system) of 71 G for up to 2 ms Altitude Operating –16 to 3.048 m (–50 to 10,000 ft) NOTE: For a
Resumo do conteúdo contido na página número 16
14 Getting Started With Your System
Resumo do conteúdo contido na página número 17
Systèmes Dell™ PowerEdge™ R510 Guide de mise en route Modèle réglementaire séries E12S et E13S
Resumo do conteúdo contido na página número 18
Remarques, précautions et avertissements REMARQUE : Une REMARQUE indique des informations importantes qui peuvent vous aider à mieux utiliser votre ordinateur. PRÉCAUTION : Une PRÉCAUTION vous avertit d'un risque de dommage matériel ou de perte de données en cas de non-respect des instructions données. AVERTISSEMENT : Un AVERTISSEMENT vous avertit d'un risque d'endom- magement du matériel, de blessure corporelle ou de mort. ____________________ Les informations contenues dans ce document so
Resumo do conteúdo contido na página número 19
Installation et configuration AVERTISSEMENT : Avant de commencer cette procédure, lisez les consignes de sécurité fournies avec le système. Déballage du système Sortez le système de son emballage et identifiez chaque élément. Assemblez les rails et installez le système dans le rack en suivant les consignes de sécurité et les instructions d'installation du rack fournies avec votre système. Guide de mise en route 17
Resumo do conteúdo contido na página número 20
Facultatif – Connexion du clavier, de la souris et du moniteur Connectez le clavier, la souris et le moniteur (en option). Les icônes des connecteurs situées à l'arrière du système indiquent où insérer chaque câble. N'oubliez pas de serrer les vis situées sur le connecteur du câble du moniteur, s'il en est équipé. Branchement du ou des câbles d'alimentation Branchez le ou les câbles d'alimentation au système et, si vous utilisez un moniteur, connectez son câble d'alimentation à celui-ci. 18 G
