Resumo do conteúdo contido na página número 1
NETWORK CAMERA
Model:
IK-WR14A
User's Manual
For information on our latest products and peripheral devices, refer to the
following Website:
http://www.toshibasecurity.com
If the URL changes, refer to the Toshiba website (http://www.toshiba.com/).
Resumo do conteúdo contido na página número 2
Table of Contents Introduction ������������������������������������������������������������������������������������������������������������������������������������������������������������������ 4 ImportantSafeguards �������������������������������������������������������������������������������������������������������������������������������������������������� 6 ImportantSafeguards(Cont�
Resumo do conteúdo contido na página número 3
Specifications ���������������������������������������������������������������������������������������������������������������������������������������������������������� 1 14 AppearanceDiagram ����������������������������������������������������������������������������������������������������������������������������������������������� 1 16 T echnologyLicenseNotice ������������������������������������������������������������������������������������������������������������������������������
Resumo do conteúdo contido na página número 4
Introduction FCC (USA)-INFORMATION NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interfere
Resumo do conteúdo contido na página número 5
Thank you for purchasing the IK-WR14A Network Camera. Before using the camera, read this User's Manual carefully to ensure correct usage. After reading this User's Manual, save it for future reference. The design, specifications, software, and User's Manual contents are subject to change without prior notice. Terms and Trademarks l The term "OS" is used in this manual to indicate operating systems compatible with this product. -- Windows XP: Microsoft Windows XP operating system -- Window
Resumo do conteúdo contido na página número 6
Important Safeguards 1. Read Instructions Read all the safety and operating instructions before operating the product. 2. Retain Instructions Retain the safety instructions and user's manual for future reference. 3. Warnings Comply with all warnings on the product and in the user's manual. 4. Follow Instructions Follow all operating and use instructions. 5. Cleaning . Disconnect this camera from the power supply before cleaning 6. Attachments Do not use attachments not recommended by the camera
Resumo do conteúdo contido na página número 7
12. Lightning For additional protection on this camera during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the power supply and cable system. This will prevent damage to the camera due to lightning and power- line surges. If lightning occurs, do not touch the unit or any connected cables in order to avoid electric shock. 13. Overloading Do not overload the power supply or extension cords as this can result
Resumo do conteúdo contido na página número 8
Important Safeguards (Cont.) CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral
Resumo do conteúdo contido na página número 9
Notes on Use and Installation l Do not aim the camera at the sun Never aim the camera at the sun even with the camera power off. l Do not shoot intense light Intense light such as a spotlight may cause a bloom or smear. A vertical stripe may appear on the screen. However, this is not a malfunction. l Treat the camera with care Dropping or subjecting the camera to intense vibration may cause it to malfunction. l Avoid Volatile Liquid Do not use volatile liquids, such as an insect spray, near
Resumo do conteúdo contido na página número 10
Precautions for Use Disclaimer We disclaim any responsibility and shall be held harmless for any damages or losses incurred by the user in any of the following cases: 1. Fire, earthquake or any other act of God; acts by third parties; misuse by the user, whether intentional or accidental; use under extreme operating conditions. 2. Malfunction or non-function resulting in indirect, additional or consequential damages, including but not limited to loss of expected income and suspension of busine
Resumo do conteúdo contido na página número 11
Package Contents IK-WR14A AV Out Cable l l l CD-ROM l Alignment Sticker/Mounting Plate l Warranty Card l Quick Start Guide and Important Safeguards l Waterproof Connector & Bushing l Gasket, Torx Wrench, Silica Gel and tape, Hex Nut , Screws and Anchors 11
Resumo do conteúdo contido na página número 12
Physical Description Camera Base Dome Cover Cover screws Side Opening Cover NO TE Replace the side opening cover with the supplied bushing if you want to route cables from the side of camera. The 1/2" (12.7mm) protection conduits and tubing are not supplied. 12
Resumo do conteúdo contido na página número 13
CAMERA BASE l Front View IR LEDs (SR-LED) Lens Light Sensor Focus Button Lens cover Tilt adjustment Mounting screws screws Status LED Rear View l General I/O Terminal Block Micro SD/ 1. GND SDHC Card 2. Power input (DC 12V) Slot 3. Power input (AC 24V) 4. Power input (AC 24V) 5. Signal GND Recessed 6. Digital Input Reset Button 7. Digital output 8. 12V DC Output DIP switch 10/100BaseT Microphone Video Output Ethernet Socket NTSC internal 60Hz MIC In (Printed "Audio In") Audio/Video Ou
Resumo do conteúdo contido na página número 14
Physical Description (Cont.) General I/O Terminal Block This Network Camera provides a general I/O terminal block which is used to connect external input / output devices. NO TE ● 12V DC is outputted from 8-pin only when connected to a power supply. The diagrams below apply when "Digital Input" is used for an alarm input. 14
Resumo do conteúdo contido na página número 15
Status LED The LED indicates the status of the Network Camera. Item LED status Description Red LED steady ON Power on and system booting 1 Red LED OFF Power off Steady Red + Blink Green every 1 sec. Network works (heartbeat) 2 Red LED Steady ON + Green LED OFF Network fail 3 Red LED steady ON + Blink Green every 2 sec. Audio mute (heartbeat) 4 Blink Red every 0.15 sec. + Blink Green every 1 sec. Upgrading F/W 5 Blink Red every 0.15 sec. + Blink Green every 0.15 sec. Restoring default Hardware
Resumo do conteúdo contido na página número 16
SD/SDHC Card and Capacity This network camera is compliant with Micro SD/SDHC 32GB and other preceding standard Micro SD cards for local storage. NO TE ● There is a limit to the number of rewrites that is possible with the SD memory card. Replacing the SD memory card when performing periodic maintenance of the camera is recommended. ● Do not use 512MB and below SD memory cards. ● The Camera system reserves approximately 60MB in SD memory cards. Any images are not recordable on this space. ● C
Resumo do conteúdo contido na página número 17
P A R T I T I O N L I N K R E C E I V E P O W E R C O L L I S I O N 1 2 3 4 5 Installation Hardware Installation Please verify that your product package contains all the accessories listed in the Package Contents listed on page 11. Depending on the user’s application, an Ethernet cable may be needed. The Ethernet cable should meet the specs of UTP Category 5 or higher. Hardware Installation is shown in the Quick Start Guide(QSG). Please refer to page 13 of the QSG.
Resumo do conteúdo contido na página número 18
2. In this case, if the Local Area Network (LAN) IP address of your Network Camera is 192.168.0.3, please forward the following ports for the Network Camera on the router. ■ HTTP port ■ RTSP port ■ RTP port for audio ■ RTCP port for audio ■ RTP port for video ■ RTCP port for video If you have changed the port numbers on the Network page, please open the ports accordingly on your router. For information on how to forward ports on the router, please refer to your router’s user’s manual. 3.
Resumo do conteúdo contido na página número 19
Software Installation Installation Wizard (IW), a free-bundled software packaged in the product CD, helps to set up your Network Camera in a LAN. 1. Install the IW under the Software Utility directory from the software CD. Installation Wizard Double click the IW shortcut on your desktop to launch the program. 2. The program will analyze your network environment. After your network environment is analyzed, please click [Next] to continue the program. 3. The program will search for Network
Resumo do conteúdo contido na página número 20
Ready to Use 1. Access the Network Camera on the LAN. 2. Retrieve live video through a web browser. 2010/09/01 13:49:39 Adjusting the Lens Adjusting the Lens is shown in the Quick Start Guide (QSG). Please refer to 21 pages of QSG. 20
