Manual do usuário Kidco G10

Resumo do conteúdo contido na página número 1

Gateway Model G1 0 for openings 28” to 34”
Optional 6” Extension (Model G6) available for openings 34” to 40”
Optional 12” Extension (Model G 1 2) available for openings 40” to 46”
Only one extension recommended per gate
User Guide

Resumo do conteúdo contido na página número 2

Ensure mounting surface (wall, doorframe, FOLLOW THESE stair post etc.) is strong, rigid and is smooth, clean and grease free. If mounting to brick, INSTRUCTIONS dry wall or other surfaces, an optional gate installation kit, wooden board mounted to the CAREFULLY AND surface or additional hardware may be necessary to provide a solid, smooth surface. KEEP THEM FOR When mounting gate to a stair post, handle FUTURE must always be on opposite side of stair post, next to wall. REFERENCE Generally, pre

Resumo do conteúdo contido na página número 3

Button Spindle housing Hinge / Handle Spindle D Spindle C n (already fittec 0 7~~ Walk through section Spindle A 1 1L -=- \ \ Safety foot , Wrench / Bi T 1 Pressure indicator/Wrench Note: To prevent over extension of spindles, notches have intentionally been cut into the threads approximately 3 1/4" from the pad ends. 3

Resumo do conteúdo contido na página número 4

Optional 6” or 12” extensions are available for larger openings. Only one extension recommended per gate. If using gate on a stairway, it must be placed either on top stair or on lowest stair at bottom. Push spindles A, B, C into three corners of gate. Note these spindles are pulled not screwed, into and out of their housings and occasionally may be tight. Center gate in opening, with bottom rail resting on floor. Gaps on each side should be equal. Insert step plate under bottom rail on desired

Resumo do conteúdo contido na página número 5

Close walk-through so safety foot is above bottom rail but do not lower handle. Pull out spindle C until it touches mounting surface. Tighten nut towards the gate frame until safety foot rests on bottom rail. If hinge starts to lift, nut is too tight and should be loosened until hinge is back in position. With handle in raised position, un-screw handle spindle D until it is 1/8" from mount- ing surface. Close handle and check all hard- ware. If correctly installed gate should be firmly in place

Resumo do conteúdo contido na página número 6

To Open Gate. Release locking mechanism by pressing locking button in while lifting handle. BUTTON MUST ALWAYS BE PRESSED IN WHEN LIFTING HANDLE. Lift walk-through section so hinge is raised and walk-through will swing open in either direction. Gate should always be in locked position. To Close Gate. Lift walk-through section and position safety foot onto bottom rail, making sure hinge has dropped down. Push handle down to lock. l No part of gate requires lubrication. l Do not use abrasive clean