Resumo do conteúdo contido na página número 1
1260 E. Van Deinse St. Greenville , MI 48838
Toll Free Phone 1-800-223-3900 Fax (616) 754-9690
www.heartlandapp.com
MODEL 9200/7200 GAS RANGE
Installation and Operating Instructions
WARNING: Improper installa-
tion, adjustment, alteration,
service or maintenance can
cause injury or property
damage. Refer to this manual.
For assistance or additional
information, consult a
agency, manufacturer
(dealer). Please read these
instructions thoroughly
before attempting to install
this unit.
Resumo do conteúdo contido na página número 2
WARNING If the information in this manual is not followed exactly, a or explosion may result causing property damage, personal injury or death. For Your Safety DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPOURS OR LIQUIDS IN THE VICINITY OF THIS APPLIANCE • Do not use the range as a heater. • Do not heat unopened glass or metal containers in the oven. • . • • Avoid the use of aerosol containers near the range. • Never place pans, cookie sheets or roasters directly on the oven bottom -us
Resumo do conteúdo contido na página número 3
WARNING WHAT TO DO IF YOU SMELL GAS!! • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbour ’ s phone. Follow the gas supplier ’ s instructions. • If you cannot reach your gas supplier , call the fire department. Installation and service must be performed by a qualified installer , service agency or the gas supplier. WARNING Never use the appliance as a space heater to heat or warm
Resumo do conteúdo contido na página número 4
Gas Models 9200/7200 CONSUMER WARRANTY ENTIRE PRODUCT – LIMITED ONE YEAR WARRANTY AGA MARVELwarrants the replacement or repair of all Parts, including gas components of this stove which prove to for one year from the date of original purchase. Such parts will be repaired or replaced at the option of Aga-Heartland without charge, subject to the terms and conditions set out below. TERMS AND CONDITIONS 1. This warranty applies only for single family domestic use when the stove has been properl
Resumo do conteúdo contido na página número 5
TABLE OF CONTENTS Page Page Cooking Guide 25 Warning 1 Care and Cleaning 26 Positioning the Range 8 Electrical Installation 9 Porcelain 26 Exhaust Hood 9 Oven Cleanin
Resumo do conteúdo contido na página número 6
Assembly and Installation To fully enjoy your new range, it is important that you read this booklet thoroughly. shipping damage, inform your dealer immediately! Caution when unpacking: Lift the range by the bottom skirt, do not lift by nickel trim. Unpacking: Note: to avoid injury, please wear safety equipment, glasses and gloves, while you are unpacking your new range. 1) Unscrew the 20 screws that hold the crate onto the skid. There are 12 along the bottom and 8 along the top. 2) Next with a p
Resumo do conteúdo contido na página número 7
BLANK
Resumo do conteúdo contido na página número 8
Sheet metal screw Steel washer Machine screw Bracket Gasket - Peel off backing and stick on. Sheet metal Machine screw Steel Washer Nut screw (black) (Nickel Plated) Gasket -Remember when working with the closet, the closet is top heavy . Use your hand to support it during installation. -With a helper,lift closet assembly from box by area that is circled. (See Fig.1 Page 2). -Rest the closet assembly on the carton,while your helper steadies the closet,peel the closet backing off the gas
Resumo do conteúdo contido na página número 9
Back of closet Sheet metal 3 1/2" x 10" Exhaust adaptor screw you are venting outside, attach the 3 1/2" x 10" exhaust adaptor with 4 sheet metal screws. Fasten your exhaust ducting to the adaptor. Small box contains: - 3 1/2"x10 exhaust adapter ( not included with woodstove closets.) Note: maximum run of ducting is 25 linear feet (subtract 5' per 90 deg elbow added to the exhaust line and 2.5' per 45 deg elbow.) 7
Resumo do conteúdo contido na página número 10
Back of stove Back of stove Exhaust Hood In Power In (female receptacle, (male receptacle) from closet) Power In Exhaust Hood In (male receptacle) (female receptacle, from closet ) Model 9200 Model 7200 Positioning the Range 1. When the range is fully assembled, recheck all electrical connections especially between the exhaust hood and the back of the range. As well, check that all nuts and bolts have been tightened. 2. Ensure teflon gliders and flooring are clean. 3. Caution: On flooring wit
Resumo do conteúdo contido na página número 11
Electrical Installation THE MODEL 7200/9200 GAS RANGE MUST BE ELECTRICALLY GROUNDED IN COMPLIANCE WITH LOCAL CODES AND IN THE ABSENCE OF LOCAL CODES, WITH THE NATIONAL ELECTRICAL CODE ANSI/NFPA 70 “LATEST EDITION” IN THE U.S. OR THE CANADIAN ELECTRICAL CODE, PART I, CSA STANDARD C22.1 IN CANADA or YOUR NATIONAL ELECTRICAL CODE. Connect the female end of the power cord to the main power (male) receptacle at the rear of the stove. See Page 8 for receptacle locations and Figure 2 for receptacle
Resumo do conteúdo contido na página número 12
Ventless Installation Figure 4 Exhaust venting options Vented Installation, Tools, Material, and Dimensions Tools required to install vented hood: Hammer Slot screwdriver Pliers Electric drill Measuring tape Drill bits Sabre saw OR Keyhole saw Materials Required: Duct—enough to go through wall or attic to outside. Elbows as required. Roof cap or wall venthood Caulking to seal around duct Sheet metal screws The above are standard parts and are available at any hardware store or heating contractor
Resumo do conteúdo contido na página número 13
Installation of Ducting Installation through an outside wall range hood outlet (see Figure 4, Page 10), making sure no wall studs are cut. Push range into position. From outside of the house, measure distance from the siding to the range outlet. Cut duct pipe that length, plus 1” (25mm) for overlap into outlet. Mechanically attach vent hood to pipe. Caulk the back of vent hood and around pipe where it goes through wall and into range hood outlet so caulking seals against outside siding. Compl
Resumo do conteúdo contido na página número 14
Venting Safety Guidelines Installation must be done in accordance with all local and national codes. Use only materials which conform to local codes in effect. Be sure power is disconnected before doing any electrical work. All duct work must be metal and mechanically fastened. Do not use plastic duct. The range hood should never be exhausted into a wall cavity or an attic where an accumulation of grease could become a fire hazard. Please ensure closet installation above the appliance conform
Resumo do conteúdo contido na página número 15
in the US or in Canada with the Canadian Electrical Model 9200 Code, Part I, CSA Standard C22, or the Local National Appliances Electrical Code. Venting How to Steps Appliance Clearances (see Page 15 for additional details): How to Steps • Sides of stove to adjacent surfaces: 1/2” (1.5 cm) min • Nickel trim to adjacent surfaces: 0” right and left • Rear clearance: 0” • Closet right side to cabinet: 0” Option 1 - Ventless installation: • Top of counter to underside adjacent cabinet: 18” (46
Resumo do conteúdo contido na página número 16
Model 9200 Dimensions 3-7/8” Range HoodOutlet (10 cm) 13-3/4” 3 1/4” x 10” 27-1/2” 11-3/8” cresting (35 cm) 8 cm x 25 cm (70 cm) (29 cm) panel 13” 33cm. 56” (142 cm) Gas Inlet-1/2” NPT 66-1/4” 62-3/8” (168 cm) (159 cm) Exhaust 36-1/8” 62-3/8” 36-1/8” Power Hood Cord (female) (159 cm) (92 cm) (92 cm) Receptacle 34” (86 cm) 29-3/4” 28” (76 cm) (72 cm) 3-3/4” 29-3/4” (10 cm) (76 cm) Figure 9 Range Hood Outlet 3-1/2” x 10-1/2” 30” (8.9 cm x 26.7 cm) (76 cm) Rough in Measurements (6” clearance to any
Resumo do conteúdo contido na página número 17
in the US or in Canada with the Canadian Electrical Model 7200 Code, Part I, CSA Standard C22, or the Local National Appliances Electrical Code. How to Steps Venting Appliance Clearances (see Page 17 for additional details): • Sides of stove to adjacent surfaces: 1/2” (1.5 cm) min How to Steps • Nickel trim to adjacent surfaces: 0” right and left • Rear clearance: 0” • Closet right side to cabinets: 0” • Top of counter to underside adjacent cabinets: 18” (46 Option 1 - Ventless installatio
Resumo do conteúdo contido na página número 18
Model 7200 Dimensions 3-7/8” Range Hood (10 cm) 11-3/8” 37-3/4” Outlet Cresting (29 cm) (96 cm) 3-1/4” x 10” 20” Panel 13” (8cm x 25cm) (51 cm) 33cm. 4-3/4” (12 cm) 56” Gas Inlet 1/2” NPT (142 cm) 66-1/4” Power 62-3/8” 36-1/8” (169 cm) Cord (159 cm) (92 cm) 36-1/8” (92 cm) Exhaust Hood 30” (female) (76 cm) Receptacle 39-3/4” 28” 39-3/4” (101 cm) 47-1/2” (72 cm) (101 cm) (121 cm) Figure 11 481/2” (123 cm) 1” stove clearance must be measured from the left side Rough in Range Hood Outlet (6” cleara
Resumo do conteúdo contido na página número 19
Important Safety Instructions 1. PROPER INSTALLATION—BE SURE YOUR APPLIANCE IS PROPERLY INSTALLED AND GROUNDED BY A QUALIFIED TECHNICIAN. 2. NEVER use this appliance as a space heater to heat or warm the room. Doing so may result in Carbon Monoxide poisoning and in overheating of the oven. 3. Do not leave children alone. Children should not be left alone or unattended in area where appliance is in use. They should never be allowed to sit or stand on any part of the appliance. 4. 5.
Resumo do conteúdo contido na página número 20
Features I A D B C L E F H Figure 13 G Cooking Controls The cooking controls are located on the right hand side of the cooktop; these controls of settings for ease and accuracy in cooking and baking. Sealed Burner Features (See Figure 13) A) Centre Burners - are two maximum 8,000 BTU (2.34 kW)(L/P 7,000 BTU) with simmer of 600 BTU (.2 kW) sealed gas burners, easy clean, for medium duty cooking tasks. B) Right Burners (48” models only) - front sealed burner is maximum 10,000 BTU (2.93 kW)(L/P
