Resumo do conteúdo contido na página número 1
Installation Instructions
Bosch Dual Fuel Range
Slide-In Model
Resumo do conteúdo contido na página número 2
Table of Contents Safety ...................................................... 1 Installation ................................................. 3 Before You Begin ............................................................. 3 Installation Procedure .......................................................... 8 Service ................................................... 18 Before Calling Service ......................................................... 18 Questions? 1-800-944-2904 www.boschapplia
Resumo do conteúdo contido na página número 3
Safety IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Important Safety WARNING: Do not repair or replace any part of the appliance unless specifi- cally recommended in the manuals. Improper installation, service or mainte- Instructions nance can cause injury or property damage. Refer to this manual for guidance. All other servicing should be done by a qualified technician. Appliance Handling Safety • Do not lift appliance by door handle. Remove the door for easier handling and in
Resumo do conteúdo contido na página número 4
,_Safety • Be sure your appliance is properly installed and grounded by a qualified tech- nician. Installation, electrical connections and grounding must comply with all applicable codes. Gas Safety • Install a gas shutoff valve near the appliance. It must be easily accessible in an emergency. • Leak testing must be conducted by the installer according to the instructions in this manual. • The appliance and its individual shutoff valve must be disconnected from the gas supply piping system durin
Resumo do conteúdo contido na página número 5
,_ Safety Related Equipment Safety • Warning: All ranges can tip. Injury to persons could result. Install anti-tip device packaged with range. Verify that the anti-tip devices are engaged. See installation instructions. Figure 2: Tipping Precautions • Remove all tape and packaging before using the appliance. Destroy the pack- aging after unpacking the appliance. Never allow children to play with packag- ing material. • Never modify or alter the construction of the appliance. For example, do not
Resumo do conteúdo contido na página número 6
Installation Tools and Parts Needed Range Power Supply Cord Kit (240V -30 Amp) Note: Not necessary for Canadian installations; Canadian units are shipped with the power cord already installed. Measuring Tape Phillips Head Screwdriver 1-1/4" (31.8 mm) Wrench Pencil T-20 Torx Screwdriver Screws (2) and Anchors (2) for Anti-Tip Bracket (Style will vary depending on mounting surface) Level Drill and Drill Bit Soapy Water Pipe Wrench Teflon Tape Channel Lock Pliers Gas Leak Test Solution Gas Supply L
Resumo do conteúdo contido na página número 7
Installation Preparation Prepare Unit Remove all packaging material and discard. Tip: Place the range on a piece of the cardboard to protect floors. Remove drawer and set aside. 1. Pull drawer all the way out. 2. Locate locking clips on the rails, one on each side. 3. Push up on the clip on the left rail. Pull the drawer out until clip locks into place. 4. Push down on the clip on the right rail. Pull the drawer out until clip locks into place. 5. Pull the drawer straight out and set aside. 6. P
Resumo do conteúdo contido na página número 8
Installation 4. Close the door until it stops. It will be about half- way open. 5. Holding the door firmly on both sides and using both hands, pull the door straight out of the hinge slots. Hold firmly, the door is heavy. 6. Place the door in a stable location. Electrical Requirements Refer to data plate for more information. See "Product Data Plate" on page 23 for data plate location. We recommend that the range be installed with a power cord set (not supplied). The electrical rating of the pow
Resumo do conteúdo contido na página número 9
Installation Gas Requirements Make certain that gas shutoff valve and all burner controls are in the _k_ cauti°n: OFF position before beginning. Shut off main gas supply valve before disconnecting the old range and leave it off until the new hook-up has been completed. Don't forget to relight the pilot on other gas appliances when you turn the gas back on. The gas supply line and electrical outlet must be located in the shaded space as shown in See Figure 4: Gas Supply Line and Electrical Outlet
Resumo do conteúdo contido na página número 10
Installation Allowaminimum of30inchesbetween cabinets whererangeisto beinstalled 1.. _. ..... F _ . 30" _£16_ ........... Figure 5: Cutout Requirements - Typical Installation Note: The slide-in range can also replace a freestanding range. In this case, verify that the opening is at least 30 inches. Figure 6: Cutout Requirements - Replacing a Free-Standing Model 1 .In Canada, a clearance of 12 mm from range sidewall to cabinet is required. English 8
Resumo do conteúdo contido na página número 11
Installation 1 30" (76.2 cm) '_ min. centered ® ® 4" (10.2 cm) 4" (10.2cm) 30" (76.2 cm) min. rain. min. no clearance required (12 mm clearance required in Canada) Figure 7: Cabinet Preparation Required Clearance I From cooktop to materials above: There must be a minimum clearance of 30 inches between the top of the cooking surface and the bottom of an unprotected wood or metal cabinet. See Figure 7: Cabinet Preparation. 24 inches is acceptable when the bottom of the wood or metal cabinet is pro
Resumo do conteúdo contido na página número 12
Installation 2. Secure bracket with2 screwsadequate formounting surface (i.e.,forwood floorusewoodscrews, forconcrete flooruseconcrete anchors andscrews). rearwait cabinet walt device flush against cabinet walt Figure 8: Anti-Tip Bracket Ventilation Recommendations We strongly recommend the installation of a ventilation hood above this appli- ance. For most kitchens a certified hood rating of not less than 300 CFM is recom- mended. The range hood must be installed according to instructions furni
Resumo do conteúdo contido na página número 13
Installation Install2screwsthrough holesintrimandinrangebackwall. SeeFigure9: Back- wallTrimStripandFigure10:Install Backwall Trim_rip Backwall Trim Strip Figure 9: Backwall Trim Strip j. . Back of Range \ Figure 10: Install Backwall Trim Strip Connect Electric There are two possible electrical connections: 1. Four wire range cord 2. Three wire range cord The four wire range cord connection is the recommended method, but where local codes permit, three wire connections are also acceptable. Note:
Resumo do conteúdo contido na página número 14
Installation Install Strain Relief Place strain relief in knockout below terminal block. See Figure 11: Strain Relief Knockout. The strain relief provided with your range cord must be properly ,_ Warning: installed. Strain reliefs vary. Carefully read and follow the instructions included with your strain relief. 1. In the knockout panel below the terminal block, remove the knockout that fits your strain relief. 2. Feed range cord through hole and strain relief up to terminal block. Allow for sla
Resumo do conteúdo contido na página número 15
Installation Warning: RiskofElectricShock orFire.Frame grounded toneutral through a ground strap.Grounding through theneutralconductor isprohibited fornewbranch-circuit installations (1996NEC),mobile homes, and recreational vehicles, orinanareawherelocalcodesprohibit grounding through theneutralconductor. Forinstallations wheregrounding through theneutral conductor is prohibited, (a)disconnect thelinkfromtheneutral, (b)usegrounding terminal orleadtoground unit,(c)connect neutral terminal tolead
Resumo do conteúdo contido na página número 16
Installation . Remove top nut, star washer, and round washer from each post. Note: DO NOT remove last round washer, last nut or internal wiring leads. . Remove screw from bottom end of ground strap. 5. Remove ground strap from center post, rotate so that wide end is at top and attach wide end to range through hole below junction box. Attach green wire on top of ground strap. Tighten Screw. green ground screw ground wire ground strap Figure 14: Four Wire Range cord Connection - Ground Strap and W
Resumo do conteúdo contido na página número 17
Installation 10.Properly secure strainrelief(seeprevious section). Note: DONOTpluginrangeatthistime. ThreeWire Range Cord Connection The Four Wire Connection (above) is preferred, but where local codes and ordi- nances permit grounding through neutral and where conversion to four wire is impractical, the unit may be connected to the power supply via a three wire con- nection. 1. Disconnect electrical power at breaker box. 2. Remove the terminal block cover to expose the terminal block. Figure 16
Resumo do conteúdo contido na página número 18
Installation 7. Tighten allconnections securely andreplace terminal blockcover. / green ground screw Figure 18: Completed Three Wire Range Cord Connection 8. Properly secure strain relief. See "Install _rain Relief' on page 12 for detailed instructions. Note: DO NOT plug in range at this time. Connect Gas Supply Shut off main gas supply valve before disconnecting the old range and leave it off until the new hook-up has been completed. Don't forget to relight the pilot on other gas appliances whe
Resumo do conteúdo contido na página número 19
Installation Important note for LP users The range is shipped from the factory for use with natural gas. For use with pro- pane (LP) gas, your range must first be converted using the LP conversion kit. Flexible Connector Method If using rigid pipe, skip to "Rigid Pipe Method" on page 19. Attach Connector B A/ Figure 20: Flexible Connector Method Table 4: Flexible Connector Method Letter Item A Gas Shut Off Valve B Regulator C Flexible Connector 1. Install male 1/2" flare adaptor at the 1/2" NPT
Resumo do conteúdo contido na página número 20
Installation drawer adjustable leg Figure21: Adjust the Front Leveling Leg Slide Range into Opening . Plug in power cord. 2. Slide range into opening, being careful not to damage countertops, floors, or the range drawer front. Do not apply pressure to cooktop when sliding into position. Be careful not to crimp flexible connector. Tip: 1. If the range does not slide easily: Use soapy water to dampen the following pressure points: • countertop • foam tape • floor under range legs . Remove drawer a
