Resumo do conteúdo contido na página número 1
SyncMaster P50HP, P50HP-2, P63FP, P63FP-2
PDP Display
User Manual
The color and the appearance may differ depending on the
product, and the specifications are subject to change
without prior notice to improve the performance.
Resumo do conteúdo contido na página número 2
Safety Instructions Notational Note These safety instructions must be followed to ensure your safety and prevent property dam- age. Make sure to read the instructions carefully and use the product in the correct manner. Warning / Caution Failure to follow directions noted by this symbol could result in bodily harm or damage to the equipment. Note Important to read and under- Prohibited stand at all times Disconnect the plug from the Do not disassemble outlet Ground to prevent an electric Do n
Resumo do conteúdo contido na página número 3
Safety Instructions Ensure that the power plug is plugged into the power outlet firmly and correctly. • Otherwise, this may result in fire. Do not forcefully bend or pull the power plug and do not place any heavy material on it. • Otherwise, this may result in fire. Do not connect multiple appliances to the same power outlet. • Otherwise, this may cause fire due to overheating. Do not disconnect the power cord while using the product. • Otherwise, this may result in damage to the product due
Resumo do conteúdo contido na página número 4
Safety Instructions Keep heating appliances as far away from the power cord or the product as possible. • Otherwise, this may result in electric shock or fire. Do not install it in a badly ventilated location such as a bookcase or closet. • Otherwise, this may result in fire due to an increase in the in- ternal temperature. When putting the product down, make sure to put it down softly. • Otherwise, this may result in damage to the screen display. Do not place the front of the product on the
Resumo do conteúdo contido na página número 5
Safety Instructions When cleaning the power plug pins or dusting the power outlet, clean it with a dry cloth. • Otherwise, it may result in fire. When cleaning the product, make sure to disconnect the power cord. • Otherwise, it may result in electric shock or fire. When cleaning the product, disconnect the power cord and clean it with a soft, dry cloth. • Do not use chemicals such as wax, benzene, alcohol, thinner, mosquito repellant, lubricant, or cleaner. • These may change the appearance o
Resumo do conteúdo contido na página número 6
Safety Instructions If thunder or lightning is occurring, do not touch the power cord or antenna cable. • Otherwise, this may result in electric shock or fire. Do not try to move the monitor by pulling only the wire or the signal cable. • Otherwise, it may fall and result in electric shock, damage to the product or fire due to damage to the cable. Do not lift or move the product back and forwards or right and left while only holding the power cord or signal cables. • Otherwise, it may fall an
Resumo do conteúdo contido na página número 7
Safety Instructions To avoid eyestrain, do not sit too close to the product. Take a rest for at least five (5) minutes after using the monitor for one (1) hour. • This reduces eye fatigue. Do not install it in an unstable location such as an unstable rack or uneven surface or a location exposed to vibrations. • Otherwise, it may fall and cause personal injury and/or damage the product. • If you use the product in a location exposed to vibrations, it may damage the product and result in fire.
Resumo do conteúdo contido na página número 8
Safety Instructions The batteries (and rechargeable batteries) are not ordinary re- fuse and must be returned for recycling purposes. The customer is responsible for returning the used or rechargeable batteries for recycling. • The customer can return used or rechargeable batteries to a nearby public recycling center or to a store selling the same type of the battery or rechargeable battery. Do not place the product in a location exposed to direct sunlight or near any heat such as a fire or hea
Resumo do conteúdo contido na página número 9
Safety Instructions Do not put any heavy objects on the product. • This may result in personal injury and/or damage to the prod- uct. 8
Resumo do conteúdo contido na página número 10
Introduction Package Contents Note Please make sure the following items are included with your PDP Display. If any items are missing, contact your dealer. Contact a local dealer to buy optional items. Checking the Contents of the Package Remove the lock from the package box, as shown in the figure above. Lift up the package box by Check the contents of the Remove the Styrofoam holding the grooves on package. and vinyl cover. both sides of the package box. Note • After unpacking the package, ma
Resumo do conteúdo contido na página número 11
Introduction PDP Display Manuals Quick Setup Guide Warranty Card User's Guide (Not available in all loca- tions) Cables Power Cord D-Sub Cable Others Remote Control Batteries (AAA X 2) Ferrite Core for Power Cord (Not available in all loca- tions) Sold separately DVI Cable Wall Mount KIT BNC to BNC Cable Network Box RGB to BNC Cable Ferrite Core • The ferrite cores are used to shield the cables from interfer- ence. • When connecting a cable, open the ferrite core and clip it around the cable
Resumo do conteúdo contido na página número 12
Introduction Your PDP Display Note The PDP device may interfere with an amateur radio or AM radio. Front SOURCE button [SOURCE] Switches from PC mode to Video mode. Changing the source is only al- lowed for external devices that are connected to the PDP Display at the time. [PC] → [DVI] → [AV] → [HDMI] → [MagicInfo] → [BNC] → [Component] Note • MagicInfo can only be enabled when a network box is connected. • The HDMI port and network box cannot be connected at the same time. Enter button [ ]
Resumo do conteúdo contido na página número 13
Introduction Note See PowerSaver described in the manual for further information regarding power saving functions. For energy conservation, turn your PDP Display OFF when it is not needed or when leaving it unattended for long periods. Remote Control Sensor Aim the remote control towards this spot on the PDP Display. Rear Note For detailed information concerning cable connections, refer to Connecting Cables under Setup. The PDP Display's configuration at the back may vary slightly depending on
Resumo do conteúdo contido na página número 14
Introduction RS232C OUT/IN (RS232C Serial PORT) MDC(Multiple Display Control) Program Port RGB IN (PC Connection Terminal (In- put)) • Use a D-Sub Cable (15 pin D-Sub) - PC mode (Analog PC) • Connect the RGB IN port on the monitor to the BNC port on the PC using the RGB to BNC cable. DVI IN (PC Video Connection Terminal) Connect the [DVI IN] port on the monitor to the DVI port on the PC using the DVI cable. DVI/RGB AUDIO IN (PC/DVI Audio Con- nection Terminal (Input)) AV/COMPONENT AUDIO IN
Resumo do conteúdo contido na página número 15
Introduction AV IN [VIDEO] Connect the AV IN [VIDEO] terminal of your monitor to the video output terminal of the external device using a VIDEO cable. AUDIO OUT Headphone/External speaker output termi- nal. HDMI IN Connect the HDMI terminal at the back of your PDP Display to the HDMI terminal of your digital output device using a HDMI ca- ble. Up to HDMI cable 1.2 can be supported. BNC OUT [R, G, B, H, V] (BNC Terminal (Output)) BNC (Analog PC) Connection: connecting the R, G, B, H, V ports
Resumo do conteúdo contido na página número 16
Introduction Kensington Lock The Kensington Lock is a device used to physically fix the system when using it in a public place. The locking device has to be purchased separately. The appearance and locking method may differ from the illustra- tion depending on the manufacturer. Refer to the manual provided with the Kensington Lock for proper use. Note The location of the Kensington Lock may be different depending on its model. Using the Anti-Theft Kensington Lock 1. Insert the locking device
Resumo do conteúdo contido na página número 17
Introduction POWER OFF Number Buttons DEL / GUIDE button - VOL + SOURCE D.MENU TOOLS Up-Down Left-Right buttons INFO COLOR BUTTONS TTX/MIX MTS/DUAL ENTER/PRE-CH MUTE CH/P TV MENU RETURN EXIT MagicInfo Turns the product On. 1. POWER Turns the product Off. 2. OFF 3. Number Buttons Used to enter the password during the OSD adjustment or to use MagicInfo. The "-" button is used to select Digital channels. 4. DEL / GUIDE but- Electronic Program Guide (EPG) display. ton - This button is
Resumo do conteúdo contido na página número 18
Introduction 9. Up-Down Left-Right but- Moves from one menu item to another horizontally, vertically tons or adjusts selected menu values. Current picture information is displayed on the upper left 10. INFO corner of the screen. 11. COLOR BUTTONS Press to add or delete channels and to store channels to the favorite channel list in the “Channel List” menu. - This button is disabled for this PDP display. TV channels provide written information services via tele- 12. TTX/MIX text. - Teletext Butt
Resumo do conteúdo contido na página número 19
Introduction Exits from the menu screen. 20. EXIT 21. MagicInfo MagicInfo Quick Launch Button. Note This button is disabled for products that do not support MagicInfo. Mechanical Layout(P50HP, P50HP-2) Mechanical Layout PDP Display Head Installation VESA Bracket • When installing VESA, make sure to comply with the international VESA standards. • Purchasing VESA Bracket and Installation Information : Please contact your nearest SAMSUNG Distributor to place an order. After your order is placed, i
Resumo do conteúdo contido na página número 20
Introduction • At least 2 persons are needed in order to move the PDP Display. • SAMSUNG is not responsible for any product damage or any injury caused by installation at customer's discretion. Dimensions Notice For securing the bracket on a wall, use only machine screws of 6 mm diameter and 8 to 12 mm length. Wall Bracket Installation • Contact a technician for installing the wall bracket. • SAMSUNG Electronics is not responsible for any damages to the product or harm to customers when the inst
