Resumo do conteúdo contido na página número 1
User Manual
Manuel de l'utilisateur
Benutzerhandbuch
D3 Series
Resumo do conteúdo contido na página número 2
Copyright This publication, including all photographs, illustrations and software, is protected under international copy- right laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without written consent of the author. © Copyright January, 2010 Disclaimer The information in this document is subject to change without notice. The manufacturer makes no repre- sentations or warranties with respect to the contents hereof and specifica
Resumo do conteúdo contido na página número 3
DLP Projector—User’s Manual Important Safety Information Important: It is strongly recommended that you read this section carefully before using the projector. These safety and usage instructions will ensure that you enjoy many years of safe use of the projector. Keep this manual for future reference. Symbols Used Warning symbols are used on the unit and in this manual to alert you of hazardous situations. The following styles are used in this manual to alert you to important informatio
Resumo do conteúdo contido na página número 4
Preface Projector Installation Notice Place the projector in a horizontal position The tilt angle of the projector should not exceed 15 degrees, nor should the projector be installed in any way other than the desktop and ceiling mount, otherwise lamp life could decrease dramatically. Allow at least 50 cm clearance around the exhaust vent. Ensure that the intake vents do not recycle hot air from the exhaust vent. When operating the projector in an enclosed space,
Resumo do conteúdo contido na página número 5
DLP Projector—User’s Manual Power Safety Only use the supplied power cord. Do not place anything on the power cord. Place the power cord where it will not be in the way of foot traffic. Remove the batteries from the remote control when storing or not in use for a prolonged period. Replacing the Lamp Replacing the lamp can be hazardous if done incorrectly. See Replacing the Projection Lamp on page 36 for clear and safe instructions for this procedure. Before replacing the lamp: Unplu
Resumo do conteúdo contido na página número 6
Preface Main Features • Lightweight unit, easy to pack away and transport. • Compatible with all major video standards including NTSC, PAL, and SECAM. • A high brightness rating allows for presentations in daylight or in lit rooms. • Supports resolutions up to UXGA at 16.7 million colors to deliver crisp, clear images. • Flexible setup allows for front, rear projections. • Line-of-vision projections remain square, with advanced keystone correction for angled projections. • Input so
Resumo do conteúdo contido na página número 7
DLP Projector—User’s Manual Table of Contents GETTING STARTED.......................................................................................................................................................... 1 PACKING CHECKLIST........................................................................................................................................................... 1 VIEWS OF PROJECTOR PARTS...............................................................................
Resumo do conteúdo contido na página número 8
Preface SPECIFICATIONS............................................................................................................................................................. 46 SPECIFICATIONS................................................................................................................................................................. 46 PROJECTION DISTANCE V.S. PROJECTION SIZE..........................................................................................
Resumo do conteúdo contido na página número 9
DLP Projector – User’s Manual GETTING STARTED Packing Checklist Carefully unpack the projector and check that the following items are included: DLP PROJECTOR WITH LENS CAP REMOTE CONTROL (WITH ONE 3V CR2025 BATTERY) RGB CABLE POWER CORD CARRYING CASE QUICK START GUIDE WARRANTY CARD CD-ROM (THIS USER’S MANUAL) Contact your dealer immediately if any items are missing, appear damaged, or if the unit does not work. It is recommend that you keep the original packin
Resumo do conteúdo contido na página número 10
DLP Projector—User’s Manual Views of Projector Parts Front-right View ITEM LABEL DESCRIPTION SEE PAGE: Ventilation opening Do not block in order to keep the projector lamp cool 1. Height-adjuster button Push to release height adjuster 2. 15 3. Height adjuster Adjusts level of projector Lens cap Covers lens to protect when not in use 4. IR receiver Receiver for IR signal from remote control 5. 6 Lens Remove lens cap before use 6. Focus ring Focuses the projected image 7.
Resumo do conteúdo contido na página número 11
DLP Projector – User’s Manual Top view—On-screen Display (OSD) buttons and LEDs SEE ITEM LABEL DESCRIPTION PAGE: 1. Turns the projector On or Off (Power) ▲ (Up cursor) Navigates and changes settings in the OSD 2. 18 Green Power On Power LED 3. Off Power Off (AC Off) Flashing Error code On System over temperature 4. Over Temp LED Off Normal State Orange Lamp is ready to be powered-on. Ready LED 5. Lamp not ready (Warm-up/shutting down/cooling) Flashing (see LED E
Resumo do conteúdo contido na página número 12
DLP Projector—User’s Manual Rear view ITEM LABEL DESCRIPTION SEE PAGE: AC IN Connect the POWER CABLE 1. 11 Connect the USB CABLE from a computer (Service USB (Service Only) 2. Only) AUDIO Connect the AUDIO CABLE from the input device 3. S-VIDEO Connect the S-VIDEO CABLE from a video device 4. 10 VIDEO Connect the VIDEO CABLE from a video device 5. 6. VGA Connect the RGB cable (supplied) from a computer TM Connect the HDMI digital video CABLE from a video TM HDMI 7.
Resumo do conteúdo contido na página número 13
DLP Projector – User’s Manual Bottom view ITEM LABEL DESCRIPTION SEE PAGE: Lamp cover Remove when changing the lamp. 1. 36 X X Height adjustor button Push to release adjustor. 2. 15 X Height adjustor Adjuster drops down when adjuster button is pushed. 3. Lens cap hook To fasten the lens cap cover. 4. 5. Tilt adjustor Rotate adjuster lever to adjust angle position. 15 X Ceiling support holes Contact your dealer for information on mounting the projector on a ceiling. 6.
Resumo do conteúdo contido na página número 14
DLP Projector—User’s Manual Remote Control Parts Important: 1. Avoid using the projector with bright fluorescent lighting turned on. Certain high-frequency fluo- rescent lights can disrupt remote control operation. 2. Be sure nothing obstructs the path between the remote control and the projector. If the path be- tween the remote control and the projector is obstructed, you can bounce the signal off certain reflective surfaces such as projector screens. 3. The buttons and keys on the
Resumo do conteúdo contido na página número 15
DLP Projector – User’s Manual ITEM LABEL DESCRIPTION SEE PAGE: Up cursor Navigates and changes settings in the OSD 1. 18 2. Enter Changes settings in the OSD Power Turns the projector On or Off 3. 11 Right cursor Navigates and changes settings in the OSD 4. 18 Volume + Increase volume 5. 17 Volume - Decrease volume 6. Mute Mutes the built-in speaker 7. Freeze Freeze/unfreezes the on-screen picture 8. Source Detects the input device 9. Auto Auto adjustment for frequen
Resumo do conteúdo contido na página número 16
DLP Projector—User’s Manual Remote Control Operating Range The remote control uses infrared transmission to control the projector. It is not necessary to point the remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or the rear of the projector, the remote will function well within a radius of about 7 meters (23 feet) and 15 degrees above or below the projector level. If the projector does not respond to the remote control, move a little clo
Resumo do conteúdo contido na página número 17
DLP Projector – User’s Manual SETUP AND OPERATION Inserting the Remote Control Batteries Remove the battery compartment cover 1. by sliding the cover in the direction of the arrow. (A) Pull out the cover. (B) Insert the battery with the positive side 2. facing up. Replace the cover. 3. Caution: 1. Only use a 3V lithium battery (CR2025). 2. Dispose of used batteries according to local ordinance regulations. 3. Remove the battery when not using the projector for pro
Resumo do conteúdo contido na página número 18
DLP Projector—User’s Manual Connecting Input Devices A PC or notebook computer and video devices can be connected to the projector at the same time. Video devices include DVD, VCD, and VHS players, as well as movie camcorders and digital still cameras. Check the user manual of the connecting device to confirm it has the appropriate output connector. ITEM LABEL DESCRIPTION USB (Service Only) Connect the USB CABLE from a computer. (Service Only) A Connect the AUDIO CABLE from the comp
Resumo do conteúdo contido na página número 19
DLP Projector – User’s Manual Starting and Shutting down the Projector Connect the power cord to the projector. 1. Connect the other end to a wall outlet. The Power and Ready LEDs on the projector light. Turn on the connected devices. 2. Ensure the Ready LED displays a solid 3. orange and not a flashing orange. Then press the Power button to turn on the projector. The projector splash screen displays and connected devices are detected. See Setting an Access Password
Resumo do conteúdo contido na página número 20
DLP Projector—User’s Manual When the “Power Off? /Press Power 5. again” message appears, press the Power button. The projector turns off. Caution: 1. Be sure to remove the lens cap before starting projector. 2. Do not unplug the power cord until the POWER LED stops flashing–indicating the projector has cooled down. – 12 –
