Manual do usuário Fisher LNS-T01Z

Resumo do conteúdo contido na página número 1

1AA6P1P2629-- (ICPWZ)

Resumo do conteúdo contido na página número 2

Resumo do conteúdo contido na página número 3

✽

Resumo do conteúdo contido na página número 4

Resumo do conteúdo contido na página número 5

LCD PROJECTOR LENS MODEL NO. LNS-W01Z / LNS-T01Z LENS REPLACEMENT AND INSTALLATION PROCEDURES NOTES ON REPLACEMENT AND INSTALLATION The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet and be sure to refer to the Installation Manual corresponding with your projector. When installing or replacing the lens, make sure the Lens Model No. matches with your projector. Refer to the catalog, or c

Resumo do conteúdo contido na página número 6

NOTES ON LENS INSTALLATION The ZOOM and FOCUS adjustment on the Top Control or the Remote Control can- not be operated with this Lens. • Lens installation and replacement should be made by the qualified service per- sonnel. • Be sure to install the lens following this procedure precisely. • The lens cover is on the lens for protection. Be sure to replace the lens cover before installation. • When installing or replacing the lens, be careful not to stain, scratch or damage the lens. LIST OF CONT

Resumo do conteúdo contido na página número 7

LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps 1 to 5 for lens replacement and installation. UPPER LENS COVER C REMOVE THE LENS COVER. (See figure-1) 1 1. Remove screws A (2 screws). 2. Pull down the lower lens cover while pushing the part D, then remove it. 3. Remove screws B (2 screws). B 4. Remove screws C (2 screws) and remove upper lens cover. D 2 Fig-1 D  IN CASE OF MODEL WITHOUT LENS A LOWER LENS COVER REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2) Remove 2 screw

Resumo do conteúdo contido na página número 8

INSTALL THE LENS. (See figure-4) 3 LENS MOUNTING BRACKET 1. Remove protective caps(front and back) on the lens. 2. Mount the lens on mounting bracket of the main cabinet with 4 screws. Use the screws included with the lens. Use the driver included with the lens to fasten the screws. (After using, save it for latter use.) ATTACHED DRIVER Fig-4 INSTALL THE LIGHT-BLOCK SHEET. (See figure-5) 4 FOCUS LENS LOCK SCREW Install the light-block sheet around the lens as shown in the illustration. Use the