Resumo do conteúdo contido na página número 1
Basic Useful
Introduction Easy Start Setup Connections Appendix
Operation Features
DATA PROJECTOR
MODEL
PG-LW2000
OPERATION MANUAL
Resumo do conteúdo contido na página número 2
IMPORTANT • For your assistance in reporting the loss or theft of your Projector, please record Model No.: the Model and Serial Number located on the bottom of the projector and retain this Serial No.: information. • Before recycling the packag ing, please ensure that you have checked the con- tents of the carton thoroughly against the list of “Supplied accessories” on page 3. SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fi tted with a non-rewireable (moulded) plug in
Resumo do conteúdo contido na página número 3
Introduction Before using the projector, please read this operation manual carefully. Introduction ENGLISH There are two important reasons for prompt warranty registration of your new SHARP Projec tor, using the REGISTRATION CARD packed with the projector. 1. WARRANTY This is to assure that you immediately receive the full benefi t of the parts, service and labor warranty applicable to your purchase. 2. CONSUMER PRODUCT SAFETY ACT To ensure that you will promptl
Resumo do conteúdo contido na página número 4
INFORMATION This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the operation manual, may cause harmful interference to radio communications.
Resumo do conteúdo contido na página número 5
Introduction Accessories Supplied accessories Two LR03 batteries RGB cable (“AAA” size, UM/SUM-4, (6' (1.8 m)) HP-16 or similar) Remote control Power cord* (1) (2) (3) (4) For U.S. and For Europe, For U.K. and For Australia, New Canada, etc. except U.K. Singapore Zealand and Oceania (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) * Which power cords are supplied along with your projector de
Resumo do conteúdo contido na página número 6
Contents Preparing Introduction Useful Features Accessories ............................................3 Operating with the Remote Control......30 Contents .................................................4 Displaying and Setting the Break Timer ......................................... 30 IMPORTANT SAFEGUARDS ..................6 Displaying the Pointer ............................. 30 Part Names and Functions ...................10 Using the Spot Function ......................... 30 Top View .
Resumo do conteúdo contido na página número 7
Introduction Keylock Function .................................... 48 Selecting the Quick Start Menu .............. 49 Setting the FUNCTION Button Operation.. 49 STANDBY Mode ..................................... 49 ® TM DLP Link ............................................ 49 ® TM DLP Link Invert .................................. 49 Returning to the Default Settings ............ 49 Checking the Lamp Life Status ............... 49 Viewing Stereoscopic 3D Images .........50 Precautions on Viewi
Resumo do conteúdo contido na página número 8
IMPORTANT SAFEGUARDS CAUTION: Please read all of these instructions before you operate this product and save these instructions for later use. Electrical energy can perform many useful functions. This product has been engineered and manufactured to assure your personal safety. BUT IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. In order not to defeat the safeguards incorporated in this product, observe the following basic rules for its installation, use and servicing.
Resumo do conteúdo contido na página número 9
Introduction 15. Overloading 19. Replacement Parts Do not overload wall outlets, extension cords, When replacement parts are required, be or integral convenience receptacles as this sure the service technician has used can result in a risk of fi re or electric shock. replace ment parts specifi ed by the manufacturer or have the same 16. Object and Liquid Entry characteristics as the original part. Never push objects of any kind into this Unauthorized substitutions may result in product thro
Resumo do conteúdo contido na página número 10
Observe the following safeguards when setting up your projector. Caution concerning the lamp unit When using the projector in high- ■ Potential hazard of glass particles if lamp altitude areas such as mountains (at ruptures. In case of lamp rupture, contact altitudes of approximately 1,500 your nearest Sharp Authorized Projector meters (4,900 feet) or more) Dealer or Service Center ■ When you use the projector in high-altitude for replacement. areas with thin air, set “Fan Mode” to See
Resumo do conteúdo contido na página número 11
Introduction Caution regarding usage of the projector Temperature monitor function ■ If you are not to use the projector for a long time or before moving the projector, make certain you unplug the power cord from the wall outlet, and disconnect any other cables connected to it. ■ If the temperature inside the projector ■ Do not carry the projector by holding the increases, due to blockage of the air vents, lens. or the setting location, the temperature ■ Do not expose the projector to di
Resumo do conteúdo contido na página número 12
Part Names and Functions Numbers in Z refer to the main pages in this operation manual where the topic is explained. 1 11 2 12 3 8 4 13 9 5 6 7 10 14 15 16 17 Top View Front View 1 Temperature warning indicator 54 11 Zoom ring 25 For enlarging/reducing the picture. 2 Lamp indicator 54 12 Focus ring 24 3 Power indicator 54 For adjusting the focus. 4 STANDBY/ON button 23 13 Intake vent 53 For turning the power on and putting the projector into Standby mode. 14 Security
Resumo do conteúdo contido na página número 13
Introduction 12 3 4 5 6 7 8 9 10 Rear View (Terminals) 1 HDMI terminal 19, 20, 21 Terminal for HDMI input. 2 AUDIO input terminal 21 3 VIDEO input terminal 20 Terminal for connecting video equipment. 4 COMPUTER/COMPONENT input terminal 19, 20 Terminal for computer RGB and component signals. 5 RS-232C terminal 22 Terminal for controlling the projector using a computer. 6 Exhaust vent 53 7 Speaker 46 Using the Kensington Lock • This projector has a Kensington Security
Resumo do conteúdo contido na página número 14
Part Names and Functions (Continued) Numbers in Z refer to the main pages in this operation manual where the topic is explained. 1 8 POINTER button 30 For displaying the pointer. 2 9 Adjustment buttons (P/R/O/Q) 35 13 For selecting and adjusting menu items. 3 14 10 EFFECT button 30 4 15 For changing the pointer or spot area. 5 16 11 KEYSTONE button 26 6 17 For entering the Keystone Correction 7 mode. 18 8 12 FUNCTION button 49 9 For operating and executing a function 19 assigned to “FUNCTION
Resumo do conteúdo contido na página número 15
Introduction Inserting the Batteries Pull down the tab on the cover and remove the 1 1 cover towards the direction of the arrow. Insert the batteries. 2 2 • Insert the batteries making sure the polarities correctly match the m and n marks inside the battery compartment. Insert the lower tab of the cover into the opening, 3 3 and lower the cover until it clicks in place. Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below Caution • Dange
Resumo do conteúdo contido na página número 16
Easy Start This section shows the basic operation (projector connecting with the computer). For details, see the page described below for each step. Setup and Projection In this section, connection of the projector and the computer is explained using one example. 3 STANDBY button 8 STANDBY/ON 8 button ON button 3 O/Q buttons 6 INPUT buttons 6 6 INPUT buttons Zoom ring 5 4 Adjustment 6 buttons Focus ring 4 (P/R/O/Q) KEYSTONE button 5 HEIGHT 4 ADJUST lever P. 16 1. Place the projector facing
Resumo do conteúdo contido na página número 17
Easy Start 4. Adjust the projected image with the Setup Guide 1 After the projector turns on, the Setup Guide appears. (When “Setup Guide” is set to “On”. See page 45.) 2 Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size. 3 After adjusting the focus, height (angle) and picture size, press ENTER to fi nish the Setup Guide. _P. 24 5. Correct trapezoidal distortion Correcting trapezoidal distortion using Keystone Correction. Shrinks Shrinks On the remote
Resumo do conteúdo contido na página número 18
254"×159" (646 cm × 404 cm) 85"×53" (215 cm × 135 cm) 34"×21" (86 cm × 54 cm) 170"×106" (431 cm × 269 cm) Setting Up the Projector Video Setup If using this projector outside the U.S.A., please change setting to “0 IRE” in Video Setup. (See page 42.) Setting Up the Projector For optimal image quality, position the projector perpendicular to the screen with the projector's feet fl at and level. Doing so will eliminate the need for Keystone correction and provide the best image quality. (See pag
Resumo do conteúdo contido na página número 19
Setup Screen Size and Projection Distance Screen Note Note H • • A Allllo ow a m w a ma ar rg giin n of e of er rro ror i r in n t th he v e va allu ue es s i in n t th he e Lens center diagrams diagrams be belo low w. . L 16:10 Signal Input (Normal Mode) Picture (Screen) size Projection distance [L] Distance from the lens center χ to the bottom of the image [H] Diag. [ ] Width Height Minimum [L1] Maximum [L2] 37 300" (762 cm) 646 cm (254") 404 cm (159") 10.0 m (32' 9") 12.0 m (39' 6") 7 cm (2
Resumo do conteúdo contido na página número 20
Setting Up the Projector (Continued) Projection (PRJ) Mode The projector can use any of the 4 projection modes shown in the diagram below. Select the mode most appropriate for the projection setting in use. (You can set the PRJ mode in “SCR- ADJ” menu. See page 45.) ■ Table mounted, front projection ■ Ceiling mounted, front projection [Menu item ➞ “Front”] [Menu item ➞ “Ceiling + Front”] ■ Table mounted, rear projection ■ Ceiling mounted, rear projection (with a translucent screen) (with a tra
