Resumo do conteúdo contido na página número 1
Multimedia Rear-Projection Display
PLC-XR70N
MODEL
Owner's Manual
Resumo do conteúdo contido na página número 2
INFORMATION TO THE USER NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio comm
Resumo do conteúdo contido na página número 3
Resumo do conteúdo contido na página número 4
TABLE OF CONTENTS FEATURES AND DESIGN 5 COMPUTER MODE 26 SELECTING COMPUTER MODE 26 SELECTING COMPUTER SYSTEM 27 PC ADJUSTMENT 28 INSTALLATION 6 COMPATIBLE COMPUTER SPECIFICATIONS 29 PICTURE IMAGE ADJUSTMENT 30 INSTALLING THE PROJECTOR 6 PICTURE POSITION ADJUSTMENT 32 PREPARING THE REMOTE CONTROLS 8 PICTURE SCREEN ADJUSTMENT 32 NAME OF EACH PART OF THE PROJECTOR 10 CONNECTING TO THE AC POWER CORD 11 VIDEO MODE 34 CONNECTING THE PROJECTOR 12 SELECTING VIDEO MODE 34 SELECTING COLOR SYSTEM 35 TERMI
Resumo do conteúdo contido na página número 5
Resumo do conteúdo contido na página número 6
INSTALLATION INSTALLING THE PROJECTOR Caution to the Installation Contact the sales dealer and request to install this projector. For installing this appliance properly, technical services are required. Any person who is not familiar with technical terms and skills, should not attempt to install. This projector should be installed referring to the Installation Manual separately attached. Caution for Installation When installing and placing this projector, please observe the following precautio
Resumo do conteúdo contido na página número 7
INSTALLATION CAUTION FOR INSTALLATION OF THE PROJECTOR When using or installing the projector, following attention should be taken: l We recommend to avoid dusty / smoky place for operating the projector. . When using under the dusty or smoky conditions, dust may accumulate on the LCD panel and Lens inside it, and may be projected on the screen together with the picture. When the symptoms above are noticed, contact your authorized dealer or service station for the cleaning. l Air blown from
Resumo do conteúdo contido na página número 8
Resumo do conteúdo contido na página número 9
INSTALLATION Caution for handling Remote Control Units When operating the Remote Control Units, please observe the following precautions: l Avoid contact with water. l Do not expose the Remote Control Units to moisture, or heat. l Do not drop the Remote Control Units. Caution for handling batteries Install batteries properly to match the "+" and "–" marks inside the case. If batteries are installed or used incorrectly, it may cause liquid leak, explosion, injury, fire hazard, or pollution. To
Resumo do conteúdo contido na página número 10
INSTALLATION NAME OF EACH PART OF THE PROJECTOR Front of the Projector PROJECTION SCREEN INDICATORS AND INFRARED REMOTE RECEIVER Do not touch the surface of the screen directly . Refer to page 19 for details. SPEAKERS FRONT PANEL Press the Door and open it. Refer to page 18 for details. FRONT TERMINAL Refer to page 12 for details. CASTER STORAGE SPACES LOCK BOLT Settle the projector by Press the Door and pull rotating 4 Lock Bolts. the handle. Rear of the
Resumo do conteúdo contido na página número 11
INSTALLATION CONNECTING THE AC POWER CORD This projector uses nominal input voltages of 100 ~ 120 V AC. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of power system. Consult a sales dealer or service station if you are not sure of the type of power supply being in use. Connect the projector with the peripheral equipment before turning the projector on. (Refer to page 14 ~
Resumo do conteúdo contido na página número 12
CONNECTING THE PROJECTOR TERMINALS OF THE PROJECTOR This projector has various kind of terminals to connect with peripheral equipment. Connect the projector with these equipment before turning them on. (Refer to page 14 ~ 17 for connection.) Rear Terminal COMPUTER IN 1 AUDIO IN 1 Connect the Computer output Connect the Audio output from to this terminal. the computer to this terminal. CONTROL PORT 1 (Refer to page 14 and 15.) AUDIO 1 (Refer to page 14 and 15.) (STEREO) COMPUTER IN 1 CONTROL P
Resumo do conteúdo contido na página número 13
CONNECTING THE PROJECTOR COMPUTER IN 1 Red Input 9 Non Connect Pin Configuration Terminal : HDB15-PIN 2 Green Input 10 Ground (Vert.sync.) Connect the display output 3 Blue Input 11 Sense 0 5 4 3 2 1 terminal of the computer to the 4 Sense 2 12 Sense 1 10 9 8 7 6 5 Ground (Horiz.sync.) 13 Horiz. sync. projector with the VGA Cable 15 14 13 12 11 (supplied). When connecting the 6 Ground (Red) 14 Vert. sync. 7 Ground (Green) 15 Reserved Macintosh computer the 8 Ground (Blue) MAC/VGA Adapter is req
Resumo do conteúdo contido na página número 14
CONNECTING THE PROJECTOR CONNECTING TO THE COMPUTER CONNECTING THE IBM-COMPATIBLE COMPUTER To connect with the IBM-compatible computer, refer to the figure below. Use Cables and Adapter indicated below. · VGA CABLE (supplied) · MOUSE CABLE FOR PS/2 PORT or SERIAL PORT (supplied) · AUDIO CABLE (not supplied) u Be sure to connect the MOUSE CABLE to match the terminal. TERMINAL TERMINAL VGA CABLE AUDIO CABLE (Supplied) (Not Supplied) MOUSE MOUSE CABLE FOR CABLE FOR PS/2 PORT SERIAL PORT (Supplied)
Resumo do conteúdo contido na página número 15
Resumo do conteúdo contido na página número 16
CONNECTING THE PROJECTOR CONNECTING TO THE VIDEO EQUIPMENT CONNECTING THE VIDEO EQUIPMENT Refer to the figure below for connecting the video equipment like VCR, video disc player, video camera, satellite TV tuner or other video equipment. u The Video input includes S-VIDEO Jacks to allow connection to an S-VHS format VCR. The S-VIDEO jack has priority over the VIDEO jack. u When connecting the video source to the VIDEO IN 2, connect either the Video cable or the BNC cable to the AUDIO projecto
Resumo do conteúdo contido na página número 17
CONNECTING THE PROJECTOR CONNECTING THE COMPONENT VIDEO EQUIPMENT Refer to the figure below to connect the component video output equipment like DVD player. VIDEO AUDIO Y C/Cb Cr R L Video/Audio cable (not supplied) REAR TERMINAL To VIDEO IN 1 terminal AUDIO 1 CONTROL PORT 1 (STEREO) COMPUTER IN 1 Y C/Cb VIDEO IN 1 S-VIDEO Connect to FRONT VIDEO/Y C/Cb(B-Y) Cr(R-Y) TERMINAL or Cr REAR TERMINAL R-AUDIO-L (MONO) VIDEO IN 2 S-VIDEO R VIDEO(BNC) VIDEO L R/C JACK R-AUDIO-L (MONO) FRONT TERMINAL To VI
Resumo do conteúdo contido na página número 18
BEFORE OPERATION CONTROLS AND INDICATORS CONTROLS OF FRONT PANEL (Within Right Door) FINE SYNC BUTTON MODE BUTTON MENU BUTTON ON-OFF BUTTON Used to adjust Used to select input Used to activate or Used to turn the Fine Sync. source. (Computer terminate the projection lamp on (Refer to page 30.) 1~3, Video 1~3) MENU operation. or off. (Refer to page 26 (Refer to page 22 and 34.) and 23.) FINE SYNC VOLUME MODE MENU ON-OFF SELECT + + NORMAL SYSTEM - - MAIN SWITCH VOLUME BUTTON NORMAL BUTTON SYSTEM
Resumo do conteúdo contido na página número 19
Resumo do conteúdo contido na página número 20
ON-OFF VOLUME FREEZE MUTE . BEFORE OPERATION OPERATION OF THE REMOTE CONTROLS Wireless Remote Control Unit This remote control unit is not only able to operate the projector but also usable as a wireless mouse for a PC. One pointing pad and two click buttons are used for wireless mouse operation. Wireless mouse is usable when PC mouse pointer is displayed on the screen, the wireless mouse cannot be used when the On-Screen Menu is displayed. PC BUTTON FINE SYNC BUTTON Used to select source Use to
