Manual do usuário GCC Printers ELITE XL8

Resumo do conteúdo contido na página número 1

and Elite 12 Series printers.

.

Download and install IP/P2P on your



Open up IP/P2P from the Programs List.




















Max Hops and IP Port
filled in. These values



nters’ button.
1
Now click on the ‘Pri
during this installation.
can remain unchanged
Windows are already
You will note that the
Windows 98 or Windows Me System
Using IP/P2P with GCC Elite XL8/Elite XL16/Elite XL20

Resumo do conteúdo contido na página número 2

shown on the right. You may or be no printers listed in this window. t he y ou i : IP Address of your printer; a name for you r printer the port number ‘ 3300 ’ a ppropriate fields you will click on y our prin p rinters window with the Designators SMP which means this is Selected, Manually Entered and Permanent. click OK on the remaining IP/P2P window, to close out of if IP/P2P. 2 Click OK to close this window

Resumo do conteúdo contido na página número 3

our ‘Printers’ Folder in this window. Place your cursor over the ICON and, using a Right Click select properties from the drop down Select the ‘Details’ Tab on the Port window. 3 the down arrow in the ‘Print to the following From the Details Tab you will click on ‘Properties’ window. menu. a local printer it will be available installed your GCC Elite 12 as Assuming you have already Now open y

Resumo do conteúdo contido na página número 4

At this point you will see your Printer Listed as you entered it in the IP/P 2P Window earlier. Verify the port is displayed in the Print to the Following Port’ window and also verify that you have GCC Elite 12xxxx selected as t depend on which specific printer model you have installed. This example shows a GCC Elite 1212 Click on ‘Spool Settings’ and select - Directional Printing’ 4 ‘Disable Bi driver to use. The specific driver name will

Resumo do conteúdo contido na página número 5

On the next Window Select Pure Binary Data Click OK Now go back to the General Tab. Click on Print Test Page. Test Page should print. ose the properties window, you have successfully set up LPR Printing for your GCC Printer using IP/P2P. 5 You may now cl Your Windows 98 or Windows Me …….then click Apply Click on Advanced Now go to the Postscript Tab