Manual do usuário American Power Conversion HS 500

Resumo do conteúdo contido na página número 1

INSTALLATION
®
1 2
3
Placement Remove Connector Cover Remove Battery (if wall-mounting - if not proceed at Step 5)
w w w.apc.com
Back-UPS HS 500
User’s Manual
o o
0 - 40 C (32 - 104 F)
Remove battery.
Press cover release
NOTE: APC recommends your network equipment
tab (one each side)
(computer, modem, router, hub, or other networked
and remove cover.
devices) be completely installed, configured, and
Press the outlet cover release
Disconnect battery
tested prior to adding this UPS to the net

Resumo do conteúdo contido na página número 2

STATUS INDICATORS AND ALARMS TRANSFER VOLTAGE/SENSITIVITY ADJUSTMENT (Optional) There are six status indicators (lights) on the front panel of the Back-UPS (On Line, On Battery, In situations where the Back-UPS or connected equipment appears too sensitive to input voltage, it may be Replace Battery (red) - is lit whenever the battery is On Line (green) - is lit whenever AC utility power is Overload, Replace Battery, TX/RX, and ACT/LNK). necessary to adjust the transfer voltage. This is a simple

Resumo do conteúdo contido na página número 3

8. Following installation, the Back-UPS HS software is available in the Start menu. Upon launching the program, it searches for all Back-UPS HS devices on the network, and will identify them as shown in Figure 8 by IP Address and MAC Address. The IP Address is automatically assigned to the Back-UPS by the DHCP services from your hub or router. IP Addresses assigned by the DHCP service may automatically change over time. Thus, APC recommends you do not bookmark the IP Address, as you may not be a

Resumo do conteúdo contido na página número 4

Troubleshooting Order Replacement Battery Possible Cause Procedure Replace with an APC qualified battery. Replacement batteries can be ordered from APC Global Services. Have your Use the tables below to solve minor Back-UPS installation and operation problems. Consult APC On-line Back-UPS HS model number available when ordering. Your model number can be found on the bottom of the unit. Technical Support or call APC Technical Support for assistance with problems that cannot be resolved using A re