Manual do usuário American Power Conversion NS 600

Resumo do conteúdo contido na página número 1

®
®
Back-UPS NS 600
User’s Guide
w w w.apc.com
Connect Battery
For safety, the Back-UPS NS is shipped with one battery wire disconnected. The UPS will not operate until the wire is connected to the touch-safe
battery terminal. NOTE: Small sparks may occur during battery connection. This is normal.
1
Turn the Back-UPS NS over and press in the Connect the battery wire firmly to Insert the battery back into the compartment.
1 2 3
two release tabs. Slide the plastic battery the battery terminal.

Resumo do conteúdo contido na página número 2

Use the table below to solve minor Back-UPS NS installation or operation problems. Consult APC Online Technical Support or call APC Troubleshooting Technical Support for assistance with problems that cannot be resolved using the table below: Problem Probable Cause Solution Back-UPS NS will not turn on. Battery is disconnected or utility power is not available at Connect the battery (see Connect Battery) and ensure power is available at the wall the wall outlet. outlet. No power available at the