Resumo do conteúdo contido na página número 1
WS-7032U
Wireless 433 MHz
Miniature Weather Station
Instruction Manual
Resumo do conteúdo contido na página número 2
TABLE OF CONTENTS Topic Page Inventory of Contents/Additional 3 Equipment Quick set-up guide 4-5 Battery installation 6-7 Features: Indoor temperature 8 Weather Forecast icons & tendency 8-10 arrows Outdoor temperature 10 Mounting 11-13 Troubleshooting 14 Maintenance and Care instructions 15 Specifications 16 Warranty 17-18 2
Resumo do conteúdo contido na página número 3
INVENTORY OF CONTENTS 1. WS-7032U—Weather Station. 2. TX6U—Remote Temperature Sensor. 3. Three each, ½” Philips screws. 4. One strip double-sided adhesive tape. 5. Instruction manual & Warranty card. ADDITIONAL EQUIPMENT 1. Two fresh AAA 1.5V batteries (for weather station). 2. Two fresh AA 1.5V batteries (for remote sensor) 3. One Philips screwdriver. 3
Resumo do conteúdo contido na página número 4
QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor station and outdoor remote 3 to 5 apart. 2. Batteries should be out of both units for 10 minutes. 3. Place the batteries into the outdoor remote first then into the indoor station. (All outdoor remotes must be started before the indoor station) 4. DO NOT PRESS ANY BUTTONS FOR 10 MINUTES. In this time the display and sensor will start to talk to each other and the
Resumo do conteúdo contido na página número 5
The remote sensor should be placed in a dry, shaded area. The remote sensor has a range of 80 feet. Any walls that the signal will have to pass through will reduce distance. An outdoor wall or window will have 20 to 30 feet of resistance and an interior wall will have 10 to 20 feet of resistance. Your distance plus resistance should not exceed 80 ft. in a straight line. NOTE: Fog and mist will not harm your remote sensor but direct rain must be avoided. 5
Resumo do conteúdo contido na página número 6
DETAILED SET-UP GUIDE I. BATTERY INSTALLATION A. REMOTE TEMPERATURE SENSOR 1. Remove the battery cover. Place your thumb over the two air-vent Battery slots on the face of the Cover Remote Temperature Sensor, push down gently and slide the battery cover down and off. 2. Observing the correct polarity, install 2 AA batteries. The batteries will fit tightly (to avoid start-up problems make sure that they do not spring free during installation). 3. Replace the battery c
Resumo do conteúdo contido na página número 7
batteries. The batteries will fit tightly (to avoid start-up problems make sure that they do not spring free during installation). 3. Replace the battery cover. 4. To switch between °F and °C, press the °F/ °C button on the back of the unit. Note: After the batteries have been installed into the Weather Temperature Station the LCD segments should light up. Also within 3 minutes, the Outdoor Temperature should be displayed in the OUTDOOR LCD. If any of this does not occur, remove
Resumo do conteúdo contido na página número 8
FEATURES INDOOR LCD FORECAST LCD OUTDOOR LCD I. INDOOR TEMPERATURE The Weather Temperature Station monitors the temperature within its immediate proximity, and displays this temperature ( °F or °C) in the INDOOR LCD. The temperature is monitored as soon as the batteries are installed. II. WEATHER FORECAST The weather forecasting feature is estimated to be 75% accurate. The weather forecast is based solely upon the change of air pressure over time
Resumo do conteúdo contido na página número 9
an accurate forecast—causing a necessity to disregard all weather forecasting for 12-24 hours after the unit has been set-up, reset, or moved from one altitude to another (i.e. from one floor of a building to another). In areas where the weather is not affected by the change of air pressure, this feature will be less accurate. A. WEATHER ICONS There are 3 possible weather icons that will be displayed in the FORECAST LCD: Sunny—indicates that the weather is expected to improve (
Resumo do conteúdo contido na página número 10
with rain,” or the reverse. It will not change from “sunny” directly to “rainy,” although it is possible for the change to occur quickly. If the symbols do not change then the weather has not changed, or the change has been too slow and gradual to register. B. WEATHER TENDENCY ARROWS Other possible displays in the FORECAST LCD are 2 weather tendency arrows, one that points up (under the forecast icons) and one that points down (above the forecast icons). These arrows reflect c
Resumo do conteúdo contido na página número 11
Note: Extreme and sudden changes in temperature will decrease the accuracy of the Weather Temperature Station, and changes in elevation will result with inaccurate weather forecasting for the next 12 to 24 hours. These changes will require a 12 to 24 hour wait before obtaining reliable data. To achieve a true temperature reading, avoid mounting where direct sunlight can reach the Remote Temperature Sensor. We recommend that you mount the Remote Temperature Sensor on a North-facing
Resumo do conteúdo contido na página número 12
location. Through the three screw holes of the bracket, mark the mounting surface with a pencil. 3. Where marked, start the screw holes into the mounting surface. 4. Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket. 5. Snap the Remote Temperature Sensor onto the mounted bracket. B. MOUNTING WITH ADHESIVE TAPE 1. With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a sec
Resumo do conteúdo contido na página número 13
with the use of a wall hanging screw (not included). A. WALL MOUNTING 1. Place a screw (not included) into an appropriate wall, leaving approximately 3/16 of an inch (5mm) extended from the wall. 2. Place the Weather Station onto the screw using the hanging hole on the backside. Gently pull the Station down to lock the screw into place. TROUBLESHOOTING Problem: No outdoor temperature is displayed. 13
Resumo do conteúdo contido na página número 14
Solution: 1) Remove all batteries—wait 30 seconds— then reinsert into sensor first, then into the station. 2) Place sensor closer to station. 3) Be sure there are no obstructing objects. 4) Be sure all batteries are fresh. Problem: The LCD screens are faint/dim. Solution: Replace batteries. Problem: °C is displayed instead of °F (or reverse) Solution: Press the °F/ °C button on back of station. Note: For problems not solved, please contact La Crosse Technology.
Resumo do conteúdo contido na página número 15
temperature changes, vibration, and shock should be avoided to prevent damage to the units. • Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings. • Do not submerge in water. • Immediately remove all low powered batteries to avoid leakage and damage. • Opening the casings invalidates the warranty. Do not try to repair the unit. Contact La Crosse Technology for repairs.
Resumo do conteúdo contido na página número 16
SPECIFICATIONS Temperature measuring range Indoor: 32 °F to 104 °F with 0.2 °F resolution: (0 °C to 40 °C with 0.1 °C resolution). “OFL” displayed if outside this range. Outdoor: -21.9 °F to 157.9 °F with 0.2 °F resolution: (-29.9 °C to 69.9 °C with 0.1 °C resolution). “OFL” displayed if outside this range. Temperature checking intervals Indoor: Every 10 seconds. Outdoor: 3 times every 10 minutes. Transmitting 433.92 MHz frequency: Temperature Maximum 80ft (25m): in open space
Resumo do conteúdo contido na página número 17
WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can
Resumo do conteúdo contido na página número 18
The owner must pay any shipping charges incurred in getting your La Crosse Technology, Ltd product to a La Crosse Technology, Ltd authorized service center. La Crosse Technology, Ltd will pay ground return shipping charges to the owner of the product to a USA address only. Your La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of reaso
Resumo do conteúdo contido na página número 19
PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF CHILDREN’S REACH. This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: La Crosse Technology 2809
Resumo do conteúdo contido na página número 20
www.lacrossetechnology.com FCC ID: OMO-01RX (WEATHER STATION) OMO-01TX (SENSOR) THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 2. THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. 20
